StarTech.com 10/100 PoE Power over Ethernet Injector 48V/30W Instruction manual
Add to My manualsStarTech.com POEINJ100 is a Power over Ethernet (PoE) injector that converts standard AC power into low-voltage DC power, enabling you to power IEEE 802.3af/at compliant network devices or the POESPLT100 PoE Splitter over existing Cat5 or higher network cables. With its ability to transmit both power and data over a single Ethernet cable, the POEINJ100 eliminates the need for separate power outlets for your PoE devices, making it an ideal solution for expanding your network infrastructure without additional wiring.
advertisement
![StarTech.com 10/100 PoE Power over Ethernet Injector 48V/30W Instruction manual | Manualzz StarTech.com 10/100 PoE Power over Ethernet Injector 48V/30W Instruction manual | Manualzz](http://s1.manualzz.com/store/data/002401636_1-4b7a9dfb281bf667133f9042da638f0f-360x466.png)
POEINJ100
POESPLT100
Instruction Manual
Power over Ethernet
10/100 POE Power over Ethernet
Injector - 48V
10/100 POE Power over Ethernet
Splitter - 5V/12V
Manual Revision:05/06/2011
For the most up-to-date information, please visit www.startech.com
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by
StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks, registered trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the property of their respective holders.
Table of Contents
Introduction .............................................................. 1
Packaging Contents............................................................. 1
System Requirements ......................................................... 1
Side View - POEINJ100 ....................................................... 2
Side View - POESPLT100 ................................................... 2
Installation ................................................................ 3
POEINJ100.......................................................................... 3
POESPLT100 ...................................................................... 3
Specifications ........................................................... 4
Technical Support .................................................... 6
Warranty Information ............................................... 6 i
Introduction
The POEINJ100 10/100 Mbps device converts standard 90-260V AC power into low-voltage DC power that can run over existing Cat5 or higher network cable to power IEEE 802.3af/at compliant network devices, or the
POESPLT100 PoE Splitter.
The POESPLT100 splitter device separates the data and power connections received from the Injector device and offers a selectable 5,
7.5, 9 or 12V output switch allowing you to customize the power output to suit your requirements. Taking advantage of PoE technology lets you expand your technology infrastructure without the hassle or expense of running new electrical wiring.
Packaging Contents
POEINJ100
1 x PoE injector
1 x Power Adapter
1 x Instruction Manual
POESPLT100
1 x PoE splitter
1 x Power Output cable
1 x Instruction Manual
System Requirements
• RJ45 terminated Cat5 or higher Ethernet cabling
• 10/100 Mbps compatible Ethernet network
• Available AC power outlet for the POEINJ100 unit
1
Side View - POEINJ100
Side View - POESPLT100
2
Installation
POEINJ100
This should be the side that does not require Power over Ethernet.
1. Connect the Ethernet cable from the source network device (i.e. computer, router, switch, etc) to the “Data (In)” RJ45 connector on the input side of the POEINJ100 unit.
2. Connect the included power adapter to the POEINJ100 unit.
3. Connect an RJ45 terminated Ethernet cable to the “Power + Data (Out)” connector on the output side of the POEINJ100 unit. The other end of the cable will either connect directly to a PoE compliant device, or to the
POESPLT100 in order to separate data and power again.
POESPLT100
1. Connect the Ethernet cable from the POEINJ100 unit to the “Data +
Power (In)” RJ45 connector on the input side of the POESPLT100 unit.
2. Set the slide switch on the side of the unit to the desired voltage output
(5V, 7.5V, 9V, 12V).
3. Connect an RJ45 terminated Ethernet cable from the “Data (Out)” connector on the output side of the POESPLT100 to the network device
(i.e. computer, router, switch, etc).
4. Connect the included Power Output Cable from the “Output Power” connector on the output side of the POESPLT100 unit to the DC power connector on the network device.
3
Specifications
Compliant Standards
Connectors
LEDs
PoE Output
Link Speeds
Maximum Cable Length
Power Adapter
Operating Temperature
Storage Temperature
Humidity
Dimension (LxWxH)
Weight
POEINJ100
IEEE 802.3af
IEEE 802.3at
IEEE 802.3
IEEE 802.3u
2 x RJ45 Ethernet female
1 x DC Power type N
2 x RJ45 Link
48VDC, 30W
10/100 Mbps
100 m / 330 ft
48VDC, 880mA, type N plug
0°C ~ 40°C (32°F ~ 104°F)
-20°C ~ 85°C (-4°F ~ 185°F)
10% ~ 90% RH
102.0mm x 75.0mm x 23.0mm
490 g
4
Compliant Standards
Connectors
LEDs
PoE Input
Power Output
Link Speeds
Operating Temperature
Storage Temperature
Humidity
Dimension (LxWxH)
Weight
POESPLT100
IEEE 802.3af
IEEE 802.3at
IEEE 802.3
IEEE 802.3u
2 x RJ45 Ethernet female
1 x DC Power type N
1 x RJ45 Link
48VDC, 30W
5 / 7.5 / 9 / 12V DC, up to 19.2W peak
10/100 Mbps
0°C ~ 45°C (32°F ~ 113°F)
-20°C ~ 90°C (-4°F ~ 194°F)
10% ~ 90% RH
102.0mm x 75.0mm x 23.0mm
240 g
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in materials and workmanship for the periods noted, following the initial date of purchase. During this period, the products may be returned for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does not warrant its products from defects or damages arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.
com USA LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product. Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.
6
StarTech.com has been making “hard-to-find easy” since 1985, providing high quality solutions to a diverse IT and A/V customer base that spans many channels, including government, education and industrial facilities to name just a few. We offer an unmatched selection of computer parts, cables, A/V products,
KVM and Server Management solutions, serving a worldwide market through our locations in the United States, Canada, the
United Kingdom and Taiwan.
Visit www.startech.com today for complete information about all our products and to access exclusive interactive tools such as the Cable Finder, Parts Finder and the KVM Reference Guide.
advertisement
Related manuals
advertisement