CAROUSEL SLIDE PROJECTORS
While once frequently used in the classroom, carousel slide projectors have
become used less and less in recent years
in favor of digital equipment such as the
data projector. However, there are still a
handful of classes that rely on these pieces
of equipment, particularly art-related
classes where much of the material can be
found on slides.
While the specific configuration of each model differs (power switch, focus dial,
etc.), the basic operation of each unit is fairly simple.
• Position the projector approximately six to eight feet back from the
projection screen and place your carousel tray of slides onto the projector,
making sure to line up the notch on the carousel tray with the notch in
the center of the slide projector; this will ensure that the carousel tray
begins at the „0‰ position, locking it into place.
• Turn on the projector using the power switch,
located either on the back or side of the unit;
make sure the switch is flipped all the way to
power up the both the lamp and fan.
• Some projectors project the light from the lamp
onto the screen as soon as it is turned on;
others will not illuminate until slides are
inserted.
There are two ways to advance through the slides. The
first way is by means of a corded remote (Fig. 11) plugged
into the rear of the projector. There are two buttons on
Fig. 11
Carousel
Slide Projector
Corded Remote
this remote – one to advance the slides and one to reverse the slides. Be sure not to
click the advancing button too quickly in succession, as this can send the slides in
reverse as opposed to advancing them. The second way of advancing the slides is by
way of buttons on the side of the projector itself. These buttons work exactly the
same way as the remote, advancing and reversing the slides.
When you have completed your slideshow, advance or reverse the slides back to
the „0‰ position, turn off the projector and remove the carousel tray.
In the event that a slide becomes stuck inside the projector, there is a release lever
on the side of the projector that will raise the slide up and out of the projectorÊs
slot. Hold the release lever and grab the offending slide, removing it from the tray.
Once you advance past that slideÊs slot in the tray, you may then replace the slide.
Stuck slides can occur due to normal wear and tear that occurs with slides and does
not indicate any problem with the projector itself.
">