iconBIT FTB2600LED Manual

Keep your power bank operating to the fullest potential, by following the below steps:

1. Re-charge your power bank once every three months

when it is not in use.

2. Keep the power bank away from any moist environment

and corrosive material.

3. Never wash the power bank with any chemicals, soaps

or detergents.

1. Simply using the attached USB cable to charge the digital

product, One end of the USB cable connect with the "OUT"

port of the power bank, another end connect with the

digital product with converted tip. Press " " button once,

it will start to charge and the green LED will indicate the

charging process.

2. Finishing charging or fail to connect the digital product,

the green LED will stop flashing. And the power bank

will turn off automatically after 30 seconds.

3. 30%, 70%, 100% is the three capacity indicator, when the

30% indicator light on means low power, please charge

the power bank in time.

4. Press the " " button twice within one second to turn

ON/OFF the LED light.

Note: If the instantaneous current is oversize when charging the digital product,the power bank will turn to protected mode automatically. To relieve the protected mode just charge the power bank.

The "IN" port is the charging port of the power bank. The three blue capacity indicators will light on when charge the power bank, after full charging, the 100% capacity indicator will light on.

1. Power indicator

2. Turn ON button

3. USB output port

4. DC5V input port