Graco 308414A Pressure Pot and Paint Container Gun Washer Kit Owner's Manual

INSTRUCTIONS–PARTS LIST
308–414
Rev. A
This manual contains important
warnings and information.
READ AND RETAIN FOR REFERENCE
See manual 308–393 for complete gun
washer warnings and instructions.
PRESSURE POT AND PAINT CONTAINER
Gun Washer Kit
Part No. 236–906
For use with Graco Gun Washer to clean pressure
pots and other paint containers. The maximum height
and width of the container the pressure washers can
clean are shown in the chart below.
Container:
Gun Washer Model
Max. Height
Max. Diameter
112–635
14 in. (356 mm)
11 in. (279 mm)
112–636
14.5 in. (368 mm) 11 in. (279 mm)
A
WARNING
Observe all warnings. Read and understand all instruction manuals before operating equipment.
To reduce the risk of serious injury, including splashing
fluid or solvent in the eyes or on the skin, shut off the air
to the pump, relieve all system pressure, and drain the
solvent from the gun washer tank before installing the kit.
Install Gun Support, Trigger Lock, and
Fluid Inlet Adapter
1.
Relieve the gun washer system pressure.
2.
Remove 1/8” plug (A) from block between manifolds.
See Fig. 1.
3.
Screw the female coupler (2), supplied with the kit, into
the 1/8” npt hole in the block. See Fig. 2.
4.
Install the quick-disconnect end of the male coupler (1)
into the female coupler (2).
5.
Place the wire loop on the snap ring (3) and snap it
around an open spray nozzle. Refer to Fig. 3 and the
parts drawing on the back page.
GRACO INC.
03675
Fig. 1
1
2
03676
Fig. 2
P.O. BOX 1441 MINNEAPOLIS, MN
COPYRIGHT 1994, GRACO INC.
55440–1441
3.
Clean the Pressure Pot or Container
1.
Place the pressure pot or other paint container over the
coupler assembly. See Fig. 3.
2.
Operate the gun washer as instructed in the gun washer
manual.
Remove the pot/container from the gun washer and blow
or wipe any solvent remaining on it.
Paint Container
Coupler
Assembly
Snap Ring
03677
Fig. 3
Parts Drawing
Parts List
Part No. 236–906
Gun Washer Kit
1
Ref.
No.
Part No.
Description
1
112–695
2
3
112–696
112–851
COUPLER, male;
Includes cable & 1 snap ring
COUPLER, female
SNAP RING
Qty.
3
Graco Phone Numbers
2
FOR TECHNICAL ASSISTANCE, service repair information
or assistance regarding the application of Graco equipment:
1–800–543–0339 Toll Free
03678
TO PLACE AN ORDER, contact your Graco distributor, or
call this number to identify the distributor closest to you:
1–800–367–4023 Toll Free
Sales Offices: Atlanta, Chicago, Dallas, Detroit, Los Angeles, Mt. Arlington (N.J.)
Foreign Offices: Canada; England; Korea; Switzerland; France; Germany; Hong Kong; Japan
GRACO INC.
P.O. BOX 1441 MINNEAPOLIS, MN
PRINTED IN U.S.A.
308−414 7/94
55440–1441
1
1
1