Demeter Amplification Real Reverbulator analog spring reverb User guide

Below you will find brief information for analog spring reverb Real Reverbulator. The Real Reverbulator is a true analog spring reverb unit from Demeter Amplification, featuring two spring tanks (one short and one long) for a wide range of reverberation effects. The unit has footswitch control and is fully bypassable, allowing you to switch between the effected and un-effected signal output. The Real Reverbulator also includes a Blend control for mixing the wet and dry signal, a Phase control for manipulating the tonal color of the long spring, and a Gain control to adjust the input sensitivity.

PDF

Document

User Guide Real Reverbulator
Real
Reverbulator
Real analog spring reverb by Demeter Amplification
24 volts DC
Output
Important!!
Spring
long short both Phase
Volume
Blend
Gain
Overload
Input
Unscrew Back, Remove shipping foam before use!!!
Controls
Input Gain : Controls the input sensitivity of the unit. The gain should be adjusted up to a level that will
cause the overload light to blink occasionally, the overload light should never be on continually, Normal
use will be gain up most of the way for guitar use and down most of the way for loop or line use.
Blend: Mixes the amount of wet and dry signal should be set to user preferences. For line studio use it
will usually be set 100% wet.
Volume: Sets the output level. Use with the footswitch to match your effected and non effected signals.
Phase: Changes the phase of the Long spring, effects the tonal colors especially when both springs are on.
Spring Selector: Selects the reverb unit in use, either the short decay or long decay or both mixed.
Foot switch: Selects between the effected and un-effected signal going to the output. True bypass.
Connections
Input: Hook the output of your guitar or loop to this jack.
Output: Hook is to the input of your Amp or next effect, or loop or mixer.
Power Connector: Hook up the supplied 24Volt Dc power supply to this jack.
Tips
Keep unit away from strong magnet fields (power transformers) they could induce noise (Hum).
Mount on a stable surface so the unit does not shake (spring noise will result). Keep a reasonable distance
from the amp to avoid feed back. In a pedal board, the unit should be used after distortion and compressor
pedals for best sound. If you use amp distortion, the unit should be used in the effects loop for best sound.
Questions: [email protected] or Phone 805-461-4100
">

Hello! I am an AI chatbot specifically trained to assist you with the Demeter Amplification Real Reverbulator User Guide. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant is out of keyboard. Please, try again later.

Key features

Analog spring reverb
Two spring tanks
Footswitch control
True bypass
Blend control
Phase control
Gain control

Frequently asked questions

The gain should be adjusted up to a level that will cause the overload light to blink occasionally. Normal use will be gain up most of the way for guitar use and down most of the way for loop or line use.

The Blend control mixes the amount of wet and dry signal. For line studio use it will usually be set 100% wet.

The Phase control changes the phase of the Long spring, which effects the tonal colors especially when both springs are on.