PRINCO DDR3-1800 user guide and testing for ASUS M4A88TD

PRINCO DDR3-1800 user guide and testing for ASUS M4A88TD-V Motherboard

AMD 965 3.40G

Part I

：Standard test

It’s the easiest way to enjoy overclock benefit by using PRINCO DDR3-1800 DIMM board

How to use?

0. Clear BIOS to mainboard initial setting

1. Enter BIOS setup and [Ai Tweaker] menu

2. Enter [Ai Overclock Tuner] item and select [Manual]

3. Select [CPU/HT Reference Clock (MHz)] item

，and increase to higher Base clock rate (ex:225). Then select [DRAM

Frequency] item

，and set the DDR3 memory to higher clock rate (ex:1800MHz). Don’t forget setting [CPU Ratio] item to suitable ratio (ex:15.0)

( In this case we only focus on memory over clocking, not CPU )

4. Select[DRAM Voltage] item , and set the value to [1.60500]

5. Enter [DRAM Timing Configuration] item

6. set [DRAM CAS# Latency] item to [8 CLK] set [DRAM RAS# to CAS# Delay] item to [9 CLK] set [DRAM RAS# PRE Time] item to [8 CLK] set [DRAM RAS# ACT Time] item to [27 CLK] set [DRAM Command Rate] item to [1T] then return to previous to [Ai Overclock Tuner] menu

7. Save BIOS changes [F10] and exit

Test result?

In order to demonstrate the performance and stability of

PRINCO DDR3-1800 DIMM board, We use the strictest stress testing, that is, multi-core MemTest in window 7.

(Data rate

：900.0*2=1800, timing：8, 9, 8, 27, multi-core test => pass!)

Advanced Overclocking and Testing

Part II

：Heavy test

If you want to know the potential of PRINCO

DDR3-1800? Following are step-by-step howto.

How to use?

0. Clear BIOS to mainboard initial setting

1. Enter BIOS setup and [Ai Tweaker] menu

2. Enter [Ai Overclock Tuner] item and select [Manual]

3. Select [CPU/HT Reference Clock (MHz)] item

，and increase to higher Base clock rate (ex:243). Then select [DRAM

Frequency] item

，and set the DDR3 memory to higher clock rate (ex:1944MHz). Don’t forget setting [CPU Ratio] item to suitable ratio (ex:14.0)

( In this case we only focus on memory over clocking, not CPU )

4. Select[DRAM Voltage] item , and set the value to [1.65000]

5. Enter [DRAM Timing Configuration] item

6. set [DRAM CAS# Latency] item to [9 CLK] set [DRAM RAS# to CAS# Delay] item to [9 CLK] set [DRAM RAS# PRE Time] item to [9 CLK] set [DRAM RAS# ACT Time] item to [27 CLK] set [DRAM Command Rate] item to [1T] then return to previous to [Ai Overclock Tuner] menu

7. Save BIOS changes [F10] and exit

Test result?

We use the strictest stress testing

， multi-core MemTest in window 7

， to show you PRINCO DDR3-1800 potential.

(Data rate

：972.0*2=1944， timing：9, 9, 9, 27， multi-core test => pass!)