Cyberoam Network Interface User Manual

How to assign multiple IP Addresses to a single
Interface?
How to assign multiple IP Addresses to a single Interface?
Applicable Version: 10.00 onwards
Overview
Cyberoam allows Administrator to configure Aliases on an interface, i.e., multiple IP addresses onto a
single physical interface. IP aliasing is the process of adding more than one IP address to a network
interface. It is another name for the interface that will easily distinguish one interface from another.
Note:
The Alias IP Address of an Interface should be configured with the same IP family as that used to
configure physical Interface. For example, if Interface is configured with IPv4 address, then the Alias
has to be an IPv4 Address (similar with IPv6).
Scenario
Assign Alias 203.88.245.235 to WAN Interface PortB 203.88.245.234.
Configuration
You must be logged on to the Web Admin Console as an administrator with Read-Write permission
for relevant feature(s).
Assign Alias
Go to Network > Interface > Interface and click Add Alias to add an alias to an Interface.
Specify Interface, IP Family and Address of Alias, as shown below.
How to assign multiple IP Addresses to a single Interface?
Click OK to assign Alias to specified Interface.
Document Version: 1.0 – 28 April, 2014
">