Installation Instructions
Optional Tools Needed: Ladder, Safety Goggles, Gloves, Tin Snips & Metal Bending Tool
• Ensure gutter system is clean and free of debris
• Inspect gutter hangers, ensuring:
- tightly fastened to fascia and attached to gutter
- minimum one hanger every 24 inches
• Install first Diamond Gutter Shield® at beginning of gutter run
• Measure 2 inches from end of Shield
• Cut and remove a notch from front and back edges
• Cut a line 2" long down the center of rib
• Bend remaining 2 inch flap 90 degrees to create an end cap
• See illustrations #6 and 8 for details
• Insert Drip Foot (back edge) of Shield onto gutter hangers
• Ensure Drip Foot engages fully, sitting snug to back of gutter
• Lower the face of Shield onto the top of the gutter
• Shield should be approximately 1/4" longer than inside face of gutter
• See circled portion of illustration #4
• Flex the Shield slightly inward and engage front edge of Shield inside
gutter lip
• The flex will create a snug Pressure Fit with gutter lip
• *Option for high wind areas - add 1/4" galvanized screw through
punched holes
• When installing each additional section, be sure to overlap the notched areas
completely with previous section
• Overlapping each Shield section keeps debris out and adds support to the
completed Shield system
• Gutter system corners require a butted mitre joint
• Measure from back corner of gutter system to ensure correct length
• Cut a 45 degree angle from the Drip Foot (back of Shield) to the Drip Lip
(front of Shield), careful not to distort the profile of the Shield
• At the termination end of the Shield system, you will need to cut and
remove a 2 inch section of the Shield's face (as in #2)
• Cut a line 2" long down the center of rib as shown. Bend these 2 inch sections
downward at a 90 degree angle as shown to overlap and create a cap to the
end of the system
Cutting Instructions
STEP #1: When cutting Shield
sections, start from Drip Foot (back)
and cut towards the hook area. Stop
cutting before the hook.
STEP #2: Begin second cut on Drip Lip
(front edge). Stop cutting when you
reach hook area.
STEP #3: Hook area is now the only
attached portion. Gently bend this
portion back and forth until section
separates. This method ensures the hook
area maintains its profile and proper
function.
*Areas which fall within 50 miles of the coastline are required to use fasteners attached
into the Shield's Drip Lip to engage the top of the gutter (as shown in #5 above). Pressure
Fit Technology testing has passed independent testing over 75 MPH, or a Low Velocity
Hurricane Rating only.
">
