PENTAX OPTIO E30 FIRMWARE UPDATE VERSION 1.01
VERSION HISTORY
Version 1.01
•
Corrected an issue whereby, on rare occasions, the single image delete function would not
complete properly when using the camera's 4-way controller.
PREPARATION
•
•
•
•
You will need a blank, formatted memory card with a capacity of 16MB or higher.
You will need your camera's USB cable, or a memory card reader.
Make sure your battery is fully charged, or that you are using an optional AC adapter to prevent
power interruptions during the update process.
Make sure your camera currently has firmware version 1.00. Before starting the update, you can
check your current firmware version by turning the camera on while holding down the MENU
button.
FIRMWARE UPDATE INSTRUCTIONS - WINDOWS
1.
2.
3.
4.
5.
6.
7.
8.
9.
Click the Windows link below to download the self-extracting firmware archive file
(e3_e101w.exe). Click SAVE to save the download file to your computer's hard drive. Saving it
to your desktop, for example, will make it easy to find after the download is complete. Please
note: this download file is not the firmware update file itself, but a compressed archive that must
be expanded in the following step.
Next, double click the download file to expand it. Once expanded, you will see a readme text file
(README.TXT) and the firmware update file itself (FWDC171P.BIN). The readme file contains
instructions similar to what you are reading on this page.
You must now copy the firmware update file (FWDC171P.BIN) to your camera's memory card.
When you connect the camera directly to your computer (or if you use a card reader), the
memory card appears as a removable disk drive in the My Computer window. Make sure you are
using a blank/formatted memory card, then drag & drop (or copy & paste) the firmware update
file (FWDC171P.BIN) from the desktop to your removable disk window, which is the camera's
memory card. Please note: You must put the firmware update file (FWDC171P.BIN) directly
onto the removable disk; it cannot be in any sub-folders. It must be on the top (or root) level of
the removable disk.
Now that you have copied the firmware update file (FWDC171P.BIN) to your camera's memory
card, you are ready to install it. Make sure your camera is turned off and disconnected from the
computer. Make sure that the memory card containing the firmware update file is inserted into
your camera. Also, make sure you that you have adequate power in your camera. We
recommend you use a Pentax AC adapter to perform the firmware update, but if you do not have
a Pentax AC adapter, make certain that your battery has a full charge.
To begin the update, turn your camera on while holding down the MENU button. If you have
followed the above instructions precisely, the camera will begin to load the new firmware. You
will see the message "NOW LOADING" then the camera will display the firmware update menu.
Select "YES" using your camera's 4-way controller (the default is "NO") then press your camera's
OK button.
The camera will now update its firmware. This may take a couple of minutes, so be careful to not
interrupt the process.
When the update is complete, you will see "COMPLETE" on your camera's LCD screen. Turn the
camera off and remove the memory card.
With the memory card removed from the camera, check your new firmware version by turning
the camera back on while holding down the MENU button. Before you begin to take pictures
again, be sure to format your memory card to erase the firmware update file.
FIRMWARE UPDATE INSTRUCTIONS - MACINTOSH
Mac users can follow this same process after clicking on the Macintosh download link below.
•
•
•
•
•
Download and save the Macintosh download file.
Decompress it with your Stuffit expander program.
Connect the camera to the computer.
Copy the firmware file (FWDC171P.BIN) to your camera's memory card, then disconnect the
camera from the computer.
Proceed with the installation of the firmware as outlined above.
">
