49444-97193 ModB ClassRite InF 3/18/05 8:34 AM Page 1

QUALITY FEATURES FOR BETTER PICTURES,

EASIER OPERATION, LONGER LIFE

• Exclusive Camlok Roller System

• Attractively styled

• Easily installed

• Economically priced

• Completely self-storing

OPERATING INSTRUCTIONS

FOR

MANUAL

WALL/CEILING

SCREENS

SC-MAN WHT-84

SC-MAN WHT-100

SC-MAN WHT-120

SC-MAN GRY-92H

SC-MAN GRY-106H

InFocus Corporation

27700 SW Parkway Ave

Wilsonville OR 97070

800-294-6400 www.InFocus.com

97193 3/05

49444-97193 ModB ClassRite InF 3/18/05 8:34 AM Page 2

YOU HAVE MADE A WISE

SELECTION… in choosing an InFocus projection screen designed and engineered to produce the sharpest, most pleasing pictures with maximum convenience.

PROTECT YOUR SCREEN by keeping it rolled in its protective case when not in use. Always examine both front and back of surface before re-rolling into case to make certain screen is free of dust, dirt or other foreign matter. Use a very soft duster brush gently to remove foreign particles.

INSTALLATION

Care in mounting and care in correct operation will mean a long and satisfactory life for your

InFocus wall/ceiling screen. Locate the screen where the audience can best see it and where other furnishings in the room permit. Mount the screen so that bottom of picture surface, when fully extended, will be above heads of viewers.

BUILT-IN HANGERS

InFocus wall/ceiling screens may be mounted on wall, map rails, suspended from ceiling or extension brackets. Wall screens must be mounted level and with the case-back parallel to the wall.

FOR WALL MOUNTING –

Use the keyhole slot at the back of the hanging bracket for flush wall suspension. Position screws or other fasteners into wall and hang screen by using slots.

FOR

WALL

FOR

CEILING

FOR MAP RAIL MOUNTING –

Use keyhole slots in flat brackets. Do not use

“D” rings.

FOR CEILING SUSPENSION

If the screen is to be ceiling mounted, two screw hooks placed in a beam or other solid surface will do the job.

NOTE: Whichever method is used, the screen should be free to swing forward and back and not be anchored rigidly. Mount the screen so that bottom of picture surface, when fully extended, will be above heads of viewers.

OPERATING INSTRUCTIONS

TO LOWER PICTURE SURFACE

Pull screen down all the way. HESITATE – then allow screen to retract VERY SLOWLY until it locks in place.

TO RAISE PICTURE SURFACE

Pull down on the pull bail, then raise quickly, as a window shade. Keep control of the picture surface. Do not allow it to roll uncontrolled into the case or damage is sure to result.