advertisement
104_Layout 1 7/21/14 10:48 AM Page 104
Series
3200G
Explosion-proof Pressure Transmitter
HART
®
, Push Button Configuration, Rangeability (100:1)
4-1/4 [108]
2-3/4
[70]
1-1/2
[38]
3-1/2 [89]
6-1/4
[159]
Scan here to watch product video
The Mercoid ® Series 3200G Smart Pressure Transmitter is a microprocessor-based high performance transmitter, which has flexible pressure calibration, push button configuration, and programmable using HART ® Communication. The Series 3200G is capable of being configured with the zero and span buttons, a field calibrator is not required for configuration. The transmitter software compensates for thermal effects, improving performance. EEPROM stores configuration settings and stores sensor correction coefficients in the event of shutdowns or power loss. The Series 3200G is FM approved for use in hazardous (Classified) locations. The 100:1 rangeability allows the smart transmitter to be configured to fit any application.
FEATURES
• Completely configurable using zero/span buttons (no calibrator required)
• Rangeability (100:1)
• High accuracy (±0.075%)
• Automatic sensor temperature compensation
• Fail-mode process function
Model
3200G-1-FM-1-1
3200G-2-FM-1-1
3200G-3-FM-1-1
3200G-4-FM-1-1
3200G-1-FM-1-1-LCD
3200G-2-FM-1-1-LCD
3200G-3-FM-1-1-LCD
3200G-4-FM-1-1-LCD
Range psi (kPa)
-14.5 to 21 (-100 to 150)
-14.5 to 217 (-100 to 1500)
0 to 725 (0 to 5000)
0 to 3600 (0 to 25000)
-14.5 to 21 (-100 to 150)
-14.5 to 217 (-100 to 1500)
0 to 725 (0 to 5000)
0 to 3600 (0 to 25000)
Contact factory for custom calibration.
Calibrated Span
(Min. to Max.) psi (kPa)
0.22 to 21 (1.5 to 150)
2 to 217 (15 to 1500)
7.25 to 725 (50 to 5000)
36 to 3600 (250 to 25000)
0.22 to 21 (1.5 to 150)
2 to 217 (15 to 1500)
7.25 to 725 (50 to 5000)
36 to 3600 (250 to 25000)
Max. Pressure psi (bar)
58 (4)
580 (40)
2000 (138)
10000 (690)
58 (4)
580 (40)
2000 (138)
10000 (690)
ACCESSORIES
A-630, Stainless steel angle type bracket with SS bolts
A-631, Stainless steel flat type bracket with SS bolts
BBV-0N, 2-valve block manifold
DevCom2000, HART ® Communication Protocol Software
1/2 NPT
SPECIFICATIONS
Service: Compatible gases, steam, liquids or vapors.
Wetted Materials: 316L SS.
Accuracy: ±0.075% FS (@ 20°C).
Rangeability: 100:1 turn down.
Stability: ±0.125% FSO/yr.
Temperature Limits:
Process: -40 to 248°F (-40 to 120°C);
Ambient: Without LCD -40 to 185°F (-40 to 85°C);
With LCD -22 to 176°F (-30 to 80°C).
Thermal Effect: ±0.125% span/32°C.
Power Requirements: 11.9 to 45 VDC.
Output Signal: 4 to 20 mA / HART ® Communication.
Response Time: 0.12 seconds.
Damping Time: 0.25 to 60 seconds.
Loop Resistance:
Operation: 0 to 1500 Ω;
HART ® Communication: 250 to 500 Ω.
Electrical Connection: Two 1/2˝ female NPT conduit, screw terminal.
Process Connections: 1/2˝ female NPT.
Display: Optional 5 digit LCD.
Enclosure Rating: NEMA 4X (IP66) and explosion proof for Class I,
Div I Groups A, B, C and D.
Weight: 5.5 lb (2.5 kg).
Agency Approvals: ATEX, CE, FM.
LCD Display
No
No
No
No
Yes
Yes
Yes
Yes
104
HART ® is a registered trademark of Hart Communication Foundation.
QualityInstruments-Direct
.ca
1.800.868.7495
105_Layout 1 7/9/14 10:57 AM Page 105
Example
Series
Range
Approval
Process Connection
Electrical Connection
Diaphragm Seal Type
Mounting Flange
3200G
3200G
2
3
4
1
2
5
FM 3 1 LES
FM
ATEX
WP
1
3
1
LED
LES
LFD
LFS
Mounting Flange
Rating
Extension Length
Diaphragm Material
Fill Fluid
Capillary Length
Options
S2 A1 05 S 2 05 LCD
S2
S3
A1
A2
D1
D2
J1
J2
00
05
10
15
S
P
H
T
2
XX
LCD
SSH
NIST
CC
3200G-2-FM-3-1-LESS2A105S2-05-LCD
3200G Explosion-Proof Pressure Transmitter
-14.5 to 21 psig (factory set 0 to 21 psig)
-14.5 to 217 psig (factory set 0 to 217 psig)
0 to 725 psig
0 to 3600 psig
0 to 8500 psig
FM approved
ATEX approved
NEMA 4X (IP66) (Only available with 316 SS housing)
1/2˝ female NPT
Diaphragm seal
1/2˝ female NPT
1 extended diaphragm seal direct mount
1 extended diaphragm seal capillary type high
1 flush diaphragm seal direct mount
1 flush diaphragm seal capillary type
2˝ (50 mm) 316L SS
3˝ (80 mm) 316L SS
ANSI class 150#
ANSI class 300#
DIN PN 10/16
DIN PN 25/40
JIS 10 K
JIS 20 K
No extension (standard for flush mount)
2˝ extension
4˝ extension
6˝ extension
316L SS diaphragm
PTFE and 316L SS diaphragm
Hastelloy C-276 diaphragm
Tantallum diaphragm
Silicon oil (-40 to 400°F)
0 to 20 feet
5 digit LCD
316 SS housing (Only available with WP approval)
NIST calibration
Custom calibration
Custom Calibration Values
Primary Units
Upper Range Limit
Lower Range Limit
Damping Time
Display Mode in H
2
O, ft H
2
O, mm H
2
O, in Hg, psig, g/cm 2 , kg/cm 2 , Pa, kPa, bar, mbar, Torr, Atm, mm Hg
20 mA value
4 mA value
0 to 60 seconds
Primary unit, %, mA, rotate
QualityInstruments-Direct
.ca
Model
DevCom2000
HART
®
1.800.868.7495
Communication Protocol Software
Includes USB HART Modem
DevCom2000 Software
HART Field Device
The Model DevCom2000 HART ® Communicator Software turns your PC into a fullfeatured HART ® communicator. Now it is possible to configure transmitters and control valves at the desktop or in the field. DevCom2000 uses device descriptions (DDs) to retrieve data that is stored in the memory of smart field devices. This software is a simple, reliable and secure method to add new measurement values to control systems without the need of additional wires. This software eliminates the need to purchase and maintain a separate handheld HART ® communicator.
FEATURES
• Complete DD library
• Includes USB HART modem
• USB 1.1 and 2.0 compatible
• Self powered modem
Model DevCom2000, HART ® Communicator Software
Windows ® -Based PC
SPECIFICATIONS
HART ®
DD Library: Included.
Generic DD: Included.
Operating System: Windows NT
Windows
Windows
(32/64).
Communicator Software
®
®
2000, WindowsXP ® ,
Vista (32/64), Windows
®
®
,
7
USB HART MODEM
Material: High strength ABS plastic.
Temperature Limits: 0 to 50°C (32 to
122°F).
Storage Temperature: -40 to 85°C
(-40 to 185°F).
Humidity: 0 to 99% (non-condensing).
HART ® Cable Length: 4’ (1.2 m).
USB HART Modem
HART ® Cable Connectors: Minigrabber.
USB Cable Length: 18˝ (0.5 m).
USB Cable Connector: USB Type A.
USB: USB 1.1, USB 2.0.
Power: USB port provides power to unit.
Current Draw: 20 mA.
Output: 600 mVpp.
Leakage: < 10 uA.
Isolation Voltage: 1500 VDC.
HART
HART
®
®
: HART ®
7, HART
HCF_SPEC-54.
4, HART
®
® 5, HART ® 6,
Physical Layer Spec
Weight: 3 oz (85 g).
Agency Approval: CE.
Windows ® , Windows Vista ® , Windows NT ® , Windows XP ® , are registered trademarks of Microsoft Corporation
CONTACT US | U.S. 219/879-8000 | U.K. (+44) (0)1494-461707 | A.U. (+61) (0) 2 4272 2055 | China +852-23181007 105
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement