SDC4/SDC8 Network Settings

SDC4/SDC8 Network Settings

An overview of the SDC series network settings

Item Description

Connect type Select the setup mode for network connection: (choose

HTTP Setup

from ADSL, DHCP, LAN or 3G connection).

Enter to setup HTTP.

DDNS Setup Enter to setup DDNS.

Mail Setup

Networking Setup

3G Setup

Enter to setup Email settings.

Enter to setup 3G network settings.

There are three ways to connect to the network:

1: DHCP

When DHCP is selected, the DHCP server will automatically assign an IP address. If you are setting up your DVR for remote viewing over the internet then you should use the LAN option instead of DHCP.

2: LAN

If you select LAN for network connection, the following information is required:

Item Description

IP Address Enter the IP address.

Subnet Mask Enter the IP address of the Subnet Mask.

Gateway Enter the IP address of the Gateway.

DNS Enter the DNS address.

(Note: The correct DNS address must be entered for DDNS function).

3: ADSL

If you select ADSL for network connection, the following information is required:

Item

User Name

Password

Description

Enter the user name provided by your ISP

Enter the password provided by your ISP

3G

If you are using a USB 3G dongle for network connection, the following information is required:

Item Description

Dial-up Number Dial-up Number (Determined by your ISP).

PIN Enter the password.

APN Enter “internet”.

Advance Setting Select to enter the advanced settings menu.

Advanced Setting Menu

Item

Enable

User Name

Password

IP Address

Description

Check to enable advance setting.

Enter your ISP username.

Enter your ISP password.

Enter the fixed IP address provided by your ISP.

HTTP Setup

If you are setting up your DVR for remote viewing over the internet you will need to make a note of the

HTTP port that is listed in this menu, by default it is set to 80.

FPS

Enable

Item

HTTP Server

Port

Auto

No.

Quality

Description

Check to enable HTTP server. Users can remotely access into the DVR over the network if the HTTP function is activated.

Enter a valid port value from 1 up to 65000. The default

Channel number.

Set up record quality. The options are: below basic, basic, normal, high, highest.

Set up record FPS.

DDNS Setup

If you do not have a static external IP address from your ISP you may need to set up a DDNS address to view your DVR over the internet.

Item

Enable DDNS

DDNS Server

Host Name

User Name

Password

Description

Enable/disable DDNS function.

Enter the registered SMTP Server: Select either ez-dns,

I-DVR.NET, DYNDNS.ORG, NO-IP.ORG, 3322.ORG.

Enter the completed registered SMTP Server.

(Including user and Server name).

Enter the details in the correct format, i.e. If the user name is h.264 and you choose i-dvr as your server, you should enter: h.264.i-dvr.net

Enter the user name.

Enter the password.

Mail Setup

When an event occurs such as VLOSS (video loss) or MOTION (motion detection), an email will be sent to the receiver account automatically.

Item

Enable E-mail Notification

SMTP Server

User Name

Password

Sender Email

Trigger Event

Description

Check the box to enable/disable the Email Notification function.

Enter to setup SMTP Server name. (Varies according to the user).

Enter to setup User Name.

Enter to setup Password.

Enter to setup the Email address of the sender account.

Enter to select the events to send as Email notifications when the following circumstances happen: Motion

(Motion Detection), Sensor (Alarm triggered) and VLOSS

Receiver Email