ScanTool OBDLink OBD-II User Manual

OBD
TM
1. Install drivers
Quick Start
2. Locate the diagnostic connector
Insert the software CD in your CD-ROM drive.
The scan tool selection menu will automatically
appear. Click on the icon labeled OBDLink:
If the menu does not appear, click StartgRun,
type D:\setup.exe (where ‘D’ is the drive letter of
your CD-ROM drive), and click OK.
The OBDLink menu will appear. Click on the
driver link for your operating system and install
the drivers:
5. Install OBDwiz software
From the OBDLink menu click on OBDwiz, and
follow the prompts to install the software:
The 16-pin D-shaped diagnostic link connector
(DLC) should be located in the passenger or
driver's compartment in the area bounded by the
driver's end of the instrument panel to 300 mm
(~1 ft) beyond the vehicle centerline, attached to
the instrument panel and easy to access from the
driver's seat. The preferred location is between
the steering column and the vehicle centerline.
To launch the software, click on Startg
ProgramsgOBDwizgOBDwiz. Click the Auto
Detect button, then click the Connect button.
3. Connect scan tool to the DLC
Technical support
Turn the vehicle’s ignition to the Key On, Engine
Off position. Follow connection diagram (bottom
of page) to connect OBDLink to the diagnostic
connector using the OBD-II cable (steps A & B).
Should you run into problems, technical support
is just a click away:
With step A completed, watch the LEDs as you
are performing step B. The "STATUS" LED will
glow red (or alternate between red and amber if
the Bluetooth option is installed) and the Tx/Rx
LEDs will cycle on and off in sequence from left to
right .
4. Connect scan tool to the PC
6. Launch OBDwiz software
—
—
Knowledgebase - contains answers to
the most commonly asked questions,
general information about OBD-II, and
troubleshooting information.
Forum - allows you to share information
and get support from other ElmScan 5
users.
These resources can be accessed from our
website: www.ScanTool.net
Connect OBDLink to your PC's USB port using
the USB cable (steps C & D).
vehicle
A
OBD-II cable
B
scan tool
PC
OBD
Tx Rx
POWER
STATUS
Tx Rx
C
computer
USB cable
D
Thank you for your purchase!
Please consider leaving feedback on:
">