advertisement
◉
Touch to zoom
SR3100 Antenna Replacement Instructions 1. Open the case. Gently push a small flathead screwdriver into each of the two openings on the right side of the case as shown in the picture. Avoid inserting the screwdriver into the holes on the left side of the case as the receiver could be damaged. 2. Remove the antenna. Lift up on the antenna close to where it connects to the circuit board. 3. Connect the new antenna. Align the antenna with the connector on the circuit board. Apply a light pressure to the top of the antenna connector and it will pop into place. DO NOT FORCE THE ANTENNA. 4. Swivel the antenna back and forth. If connected correctly, the antenna will swivel freely. If it doesn't, the antenna is not connected correctly. 5. Find the small round cutouts in the case. Make sure that when you replace the case that the antenna fits into the round slots. IF YOU DO NOT ALIGN THE SLOTS, THE ANTENNA WILL BE DAMAGED. 6. Snap the case back together. It should easily snap back together. If it doesn’t, check to make sure that you have everything aligned correctly. © 2008 Horizon Hobby, Inc. Spektrum radios and accessories are distributed exclusively by Horizon Hobby, Inc. 4105 Fieldstone Road, Champaign, IL 61822 Call toll-free, 877-504-0233 with any questions or concerns regarding this product. To find your country's distributor, log on to www.horizonhobby.com. DSM and DSM2 are trademarks or registered trademarks of Horizon Hobby, Inc. spektrumrc.com Spektrum is used with permission of Bachmann Industries, Inc. 13653
advertisement
Key Features
- DSM2 technology for reliable and long-range control
- Compatible with all Spektrum DSM2 transmitters
- Compact size and lightweight design
- Built-in failsafe system
- 3-channels for controlling steering, throttle, and one auxiliary function
- Bind button for easy pairing with transmitter
- Antenna can be swiveled back and forth for optimal signal reception
- Round slots in the case for proper antenna placement
- Easy to install and remove
Related manuals
Frequently Answers and Questions
How do I connect the SR3100 to my transmitter?
To connect the SR3100 to your transmitter, first make sure that both the transmitter and receiver are powered off. Then, press and hold the bind button on the receiver while turning on the transmitter. The LED on the receiver will begin to flash, indicating that it is in bind mode. Release the bind button and the LED will turn solid, indicating that the receiver is bound to the transmitter.
What is the range of the SR3100?
The range of the SR3100 will vary depending on the environment in which it is being used. In open areas, the range can be up to 1000 feet. However, in areas with obstacles such as buildings or trees, the range may be reduced.
What is the failsafe system on the SR3100?
The failsafe system on the SR3100 is designed to automatically return the vehicle to a preset position in the event of signal loss. To set the failsafe position, first turn on the transmitter and receiver. Then, move the controls on the transmitter to the desired failsafe position. Finally, press and hold the failsafe button on the receiver for 5 seconds. The LED on the receiver will flash to indicate that the failsafe position has been set.
advertisement