Memory Module Specification

KVR1333D3S9/2G

2GB 256M x 64-Bit PC3-10600

CL9 204-Pin SODIMM

DESCRIPTION:

This document describes ValueRAM's 256M x 64-bit (2GB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM) memory module, based on sixteen 128M x 8-bit DDR3-1333MHz FBGA components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 204-pin SODIMM uses gold contact fingers and requires

+1.5V. The electrical and mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply

VDDQ = 1.5V ± 0.075V

667MHz fCK for 1333Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 5,6,7,8,9,10

Posted CAS

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

Programmable CAS Write Latency(CWL) = 7(DDR3-1333)

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

Asynchronous Reset

PCB : Height 1.180” (30.00mm), double sided component

PERFORMANCE:

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh Command Time (tRFCmin)

Row Active Time (tRASmin)

Power

UL Rating

Operating Temperature

Storage Temperature

9 cycles

49.5ns (min.)

110ns

36ns (min.)

1.200 W (operating)

94 V - 0

0 o C to 85 o C

-55 o C to +100 o C

Document No. VALUERAM0802-001.A00

06/11/09 Page 1

MODULE DIMENSIONS:

ValueRAM

(units = millimeters)

Document No. VALUERAM0802-001.A00

Page 2