A POLYCOM DATA SHEET
Polycom
®
KIRK
®
Wireless Server 300
SIP Telephony Solution for Small to Medium-sized Businesses
Polycom offers a simple all-in-one IP DECT solution that enables your employees to stay in contact with colleagues or customers wherever they are within the business premises.
Cost-Effective Business Wireless
The Polycom
®
KIRK
®
Wireless Server 300 system is a single-cell solution supporting up to 12 wireless users and four simultaneous calls, making it an excellent choice for small to medium-sized businesses.
Companies with a number of small offices can easily offer mobility to their employees by installing the KIRK Wireless Server 300 solution at each location. Call-handling can be managed by a local or centralized IP SIP PBX.
Up to six KIRK Repeaters can be subscribed to the KIRK Wireless Server 300 solution, providing a number of advantages, such as the:
Ability to cover a larger area, compared to other single-cell solutions
Flexibility to handle complex coverage requirements
Scalability to extend coverage after initial deployment
Small and Medium-sized Business Benefits
In its basic version, the infrastructure of the KIRK Wireless Server 300 solution consists of the server itself and KIRK Handsets, wherefore it is very easily installed. The solution can be expanded with up to six KIRK Repeaters for greater geographical coverage.
The KIRK Wireless Server 300 solution is ideal as a hosted solution since it comes with the capability for provisioning configuration, firmware, and wireless users.
The simple installation and the ability to run as a hosted solution specifically addresses the needs of small and medium-sized businesses (SMBs) because it allows these to benefit from a high-quality wireless voice system without complex management and administration requirements.
In addition, the KIRK Wireless Server 300 solution integrates with all handsets from the
KIRK Handset portfolio. Thus, allowing all users to be equipped with a handset that meets their exact business needs and requirements. The KIRK Wireless Server 300 solution is therefore suited for SMBs in a wide range of vertical markets.
KIRK Wireless Solutions
The KIRK Wireless Server 300 is part of the KIRK Wireless portfolio, which includes a number of wireless server solutions suitable for SMBs as well as large businesses and enterprises.
All KIRK wireless solutions are built on the international DECT (Digital Enhanced Cordless
Telecommunications) standard and are compatible with most enterprise communication systems through either an analog or IP interface.
Benefits
Designed for simple installation and coverage scalability via repeaters
A cost-effective system that allows usage of the exsisting LAN infrastructure
Delivers high-quality and secure voice communication
Maximizes employee availability using simple, reliable, and durable devices
Increases business efficiency by integrating with application systems and business processes
IP interface based on SIP protocol
Power over Ethernet
Browser configuration option
Compatible with all KIRK Handsets
Polycom
®
KIRK
®
Wireless Server 300 Specifications
Protocol Support
• Session Initiated Protocol SIP
For overview of all supported RFC protocols, see support page on www.
polycom.com
Operation and Maintenance
• Single web portal for administration and maintenance of the entire DECT infrastructure
• HTTP with digest authentication
• HTTPS
• Provisioning, maintenance, and supervision of all KIRK Handsets controlled by the solution
System Architecture
• The KIRK Wireless Server 300 is a control unit acting as a SIP integration unit to the SIP IP-PBX. Also, it controls and handles all other infrastructure elements
• Max. no. of simultaneous calls: 4
• Max. no. of KIRK Repeaters: 6
A KIRK Repeater extends the coverage area in a KIRK solution
• Max. no. of registered KIRK Handsets:
12
Supported Codecs
• G.711 A-law and μ-law
Network and Provisioning
• 10/100 Mbps Ethernet port
• Manual or dynamic host configuration protocol (DHCP) network setup
• Time and date synchronization using
NTP
• Event logging
• LED status indication
Radio Interface
• Full slot DECT RF part (12 channels)
• RF output 20 to 24 dBm at antenna connection
• Sensitivity: typical -90 dBm measured at antenna connection at BER = 0.001
• Typical range:
• Indoor: 20 – 50 m.
• Outdoor: 300 m.
Environmental Conditions
• Operating temperature: 10 - 40 °C
• Storage temperature: - 50 - 70 °C
• Relative humidity: between 20% and
80% (non-condensing)
• The equipment is in compliance with the requirements of EU directive 2002/95/
EC (ROHS) and 2002/96/EC (WEEE)
Electro Magnetic Compatibility (EMC)
Approvals (Regulatory Standards)
• EN 301 489-1
• EN 301 489-6
• FCC RULES, FCC PART15, subpartD;
RSS-213
• IC Rules RSS213 Issue 2
Electrical Requirements
• Power over Ethernet (IEEE 802.3af)
• PoE Class 1 device
• Typical power consumption: 1W per unit
Safety (Regulatory Standards)
• UL60950-1 CAN/CSA-C22.2 No.
60950-1-03
• EN 60950-1
DECT Approval
• EN 301 406
Physical Characteristics
• Size: 100 x 100 x 38 mm.
• Weight: 120 g.
• Grey-white (NCS 0502-Y)
• Wall-mountable, indoor
Interoperability
For information about supported PBX platforms, visit the Support Portal on www.
polycom.com
.
Polycom Worldwide Headquarters
4750 Willow Road, Pleasanton, CA 94588
1.800.POLYCOM or +1.925.924.6000 www.polycom.com
Polycom EMEA
270 Bath Road, Slough, Berkshire SL1 4DX, UK
+44 (0) 1753 723000 www.polycom.eu
Polycom Asia Pacific
8 Shenton Way, #11-01 Temasek Tower,
Singapore 068811
+65.6389.9200 - www.polycom.asia
© 2011 Polycom, Inc. All rights reserved. POLYCOM ® , the Polycom “Triangles” logo and the names and marks associated with Polycom’s products are trademarks and/or service marks of Polycom, Inc. and are registered and/or common law marks in the United States and various other countries. All other trademarks are property of their respective owners. No portion hereof may be reproduced or transmitted in any form or by any means, for any purpose other than the recipient’s personal use, without the express written permission of Polycom.
01/13/2011
