Thank you for selecting Globe as your lighting choice for your home. With proper care, this product will provide years of pleasure and enjoyment.
Carefully follow the instructions in order to ensure that this product functions safely and properly for years to come.
LED PUCK LIGHT
PARTS AND SPECIFICATIONS
6 Puck Lights included
Location of Controls 3
3 Super Bright SMD LEDs
ON/OFF/DIMMER Switch 7 N
Mounting Bracket
Stand D A \
Battery Compartment*
ло К о юг
* Inside of unit г) te {
INSTALLATION
To begin, we recommended choosing the desired location for the light and testing the operation of the system
before installation. Locate the light where it is most needed without regard for physical barriers and test by turning
it on and off several times.
3M Double Sided Tape (included)
1. Check the location of where you want to place the light. Make sure it is clean and there is no debris or dust.
. Remove the protective film and apply the tape to the outside part of mounting bracket.
. Peel off the protective film and press the mounting bracket firmly to the intended surface for five (5) seconds in
correct direction.
Replace light head. Align the two pins of mounting bracket with the two grooves of puck light. Twist light head
clockwise about a quarter turn. Take care to not overtighten.
‘0
>
CAUTION: Be cautious of what surface the double sided tape is attached to, as it may remove paint or damage
surface.
OPERATING DIRECTIONS
Light Positioning
Place the light anywhere you want. It can stand on any flat surface.
ON/OFF/DIMMER Operation
Press power symbol once for full brightness
Press again for softer light
Press a third time to turn the light off
BATTERY - Each Puck Light requires 3 AAA batteries (included)
MOUNTING - 1 Double sided tape included
Product Dimensions:
Puck Light size — 76 mm(H) x 76 mm(W) x 18.45 mm(D)
INDOOR, DRY USE ONLY
INSERTING/REPLACING THE BATTERIES FOR PUCK LIGHT
If the LEDs appear to be dim this is an indication that the batteries need to be replaced.
- Open the top cover of the puck light from the gap between top & bottom cabinets.
- Remove old batteries (if replacing batteries).
- Replace with three new AAA batteries.
- Make sure to follow battery polarity guide when installing new batteries. я ;
- Replace the front cover. A | E frame € EN
SAFETY INFORMATION NS SN 7
Battery Precautions: | -
1. Use only the size and type of batteries specified.
2. Always purchase the correct size and grade of battery most suitable for the intended use.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries.
Replace all batteries of a set at the same time. Do not mix old and new batteries.
Clean the battery contacts and also those of the device prior to battery installation.
Do not dispose of batteries in fire.
Remove batteries if consumed or if product is to be left unused for an extended period of time.
© NO Ub
Since 1932, Globe has taken pride in offering products of the highest quality, and a level of service unparalleled in the industry.
Should you encounter any difficulties, have any questions or simply wish to offer us your valuable feedback, you may contact us in the following ways:
Toll Free Telephone: 1-888-543-1388 (North America Only) / Toll Free Fax: 1-800-668-4562 (North America Only)
E-Mail: [email protected] / Mail: Globe Electric Customer Service Department
150 Oneida, Montreal, Quebec, Canada H9R 1A8
Please visit our website to discover other quality Globe products: http://www.globe-electric.com
">
