alder tapware
PRODUCT: NUOVA FILTRO MIXER Code 85320
WARRANTY
(Nuova Filtro Mixer Only – Does not apply to Water Filter System)
1. Vito Bertoni products - taps, mixers, showers and accessories
1 year parts and labour warranty
10 year replacement warranty on ceramic disc cartridges
2. Warranty claims must be accompanied by the invoice showing dates of purchase or installation. Where a product has not been installed, the product can be returned with proof of purchase, to the place of purchase .
3. This warranty may become void due to the following:-
Inability to provide proof of purchase
Products not installed by a licensed plumber
Products not installed in accordance with installation instructions
Products exposed to pressures that exceed 500 KPA and or temperatures that exceed 75 o
C within a building
–
Refer AS/NZS 3500.1:2003 (Clause 3.34)
Damage to ceramic disc cartridges from foreign matter e.g. sand, dirt, stones, thread tape, pieces of copper or plastic tubing etc.
Inadequate flushing of system prior to usage, causing damage and/or obstructions to the product
Damage to product surface due to installation (including adhesives and sealants) or post-installation
Failure to install flow regulators and check valves from outlets including showers, sink and vegie mixers
Products not used for its intended purpose
Failure to observe care and cleaning instructions, including failure to regularly clean aerator inserts in taps and or shower heads
For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: 08 6217 0600 FAX: 08 6217 0699 EMAIL: [email protected] www.aldertapware.com.au www.vitobertoni.com.au
V01 140210
INSTALLATION: NUOVA FILTRO MIXER
This set up will allow:
1. Right hand operation (grub screw at back of spout)
2. Filter handle lever is off at vertical position.
Your Mixer comes fully assembled.
For installation follow steps below:
1. Flush out all pipe work before installation of the mixer
2. Remove adaptor nut and washer
3. Remove brass nut, brass and rubber horse shoe washer.
4. Fit mixer into the sink ensuring the dress ring is in the correct position.
5. The long handle of the mixer should be on the right side – water supply.
6. For installation on a Stainless Steel sink - fit plastic sink stiffener provided.
When installing on bench top, sink stiffener not required.
7. From underneath, install horse shoe rubber washer, horse shoe brass fixing plate and the fixing nut.
Use the enclosed tube spanner to tighten fixing nut.
8. Connect the flexible hose with the blue marking to the cold water supply.
The flexible hose with red marking connect to hot water supply.
9. When fitting a water filter system, fit adaptor nut and washer to fixing stem stud attach 300mm flexi hose to adaptor nut, and then attach to water filter system. Note:-
Water Filter System is not supplied with this mixer and is purchased separately
35mm Cartridge LHS Filter System cartridge
WATER FILTER SYSTEM
The Nuova Filtro Mixer does not include the Water Filter System..
Vito Bertoni recommends the installation of the following Water Filter systems to the Nuova Filtro Mixer:-
Aqua-Pure Water Filter System Code AP9100 or AP9300
The AquaPure Filter Water System can be purchased from any plumbing merchant.
Please refer to the AquaPure website u nder “Where to Buy” for plumbing merchants carrying stock of this Water Filter
System and cartridges in your area.
For warranty details for the Aquapure Water Filter System refer Aquapure website and/or contact details
Aquapure Contact Details:- www.aquapure.com.au
For general enquiries or technical support: - 1300 345 837.
For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: 08 6217 0600 FAX: 08 6217 0699 EMAIL: [email protected] www.aldertapware.com.au www.vitobertoni.com.au
V01 140210
