HPE Knowledge Article
HPE OfficeConnect 1810 v2 Series Switch - How to Configure Daylight Saving
Time
Article Number mmr_sf-EN_US000005206
Environment
HP 1810 V2 Series Switch
Issue
On HP 1810 Series Switch Daylight Saving Time will not adjust automatically.
To Configure HP 1810 Series Switch to Automatically adjust time when Daylight Saving Time (DST) occurs. To Configure
HP 1810 Series Switch to Automatically adjust time when Daylight Saving Time (DST) occurs.
Cause
Need to configure Daylight Saving Time on HPE 1810 series switches.
Resolution
Daylight Saving Time
The Daylight Saving Time page is used to configure if and when Daylight Saving Time (DST) occurs for your time zone.
When configured, the system time will adjust automatically during Daylight Saving Time.
To display the Daylight Saving Time page, click Network Setup > Daylight Saving Time in the navigation pane.
The page displays differently depending on the mode selected in the Daylight Saving Time field.
In the following figure, the mode is set to Recurring.
Figure 1. Daylight Saving Time Page
Table 1. Daylight Saving Time Fields
Field
Description
Daylight Saving Time
Select how DST will operate:
• Disabled—No clock adjustment will be made for DST.
• Recurring—The settings will be in effect for the upcoming period and subsequent years.
• Non-Recurring—The settings
Set the following to indicate when the change to DST occurs and when it ends. When Recurring is
selected as the DST mode, the following fields display:
• Week—Set the week of the month, from 1 to 5, when the change to/from DST occurs.
• Day—Set the day of the week when the change to/from DST occurs.
• Month—Set the month when the change to/from DST occurs.
Start Time settings / End
• Hours—Set the hour of the day when the change to/from DST occurs.
Time settings
• Minutes—Set the minutes in the hour when the change to/from DST occurs. When Non-Recurring is
selected as the DST mode, the following fields display:
• Month—Set the month when the change to/from DST occurs.
• Date—Set the day of the month when the change to/from DST occurs.
• Year—Set the year in which these settings will take effect.
• Hours—Set the hour of the day when the change to/from DST occurs.
• Minutes—Set the minutes in the hour when the change to/from DST occurs.
Offset
Specify the time amount of time in minutes to advance the clock during DST.
Click Apply to save any the changes for the current boot session; the changes take effect immediately.
Click the Refresh link above the page to re-display the page with current settings from the switch.
To view a summary of clock and DST information, click Status > Clock in the navigation pane.
Information for this document can be found at the following URL:
Click here to access HP 1810 Switches Management and Configuration Guide.
© Copyright 2016 Hewlett Packard Enterprise Development LP. The information contained herein is subject to change without
notice.The only warranties for Hewlett Packard Enterprise products and services are set forth in the express warranty statements
accompanying such products and services.Nothing herein should be construed as constituting an additional warranty. Hewlett
Packard Enterprise shall not be liable for technical or editorial errors or omissions contained herein.
">
