Kingston Technology ValueRAM KVR16LS11/8 memory module Datasheet

Memory Module Specifi cations

KVR16LS11/8

8GB 2Rx8 1G x 64-Bit PC3L-12800

CL11 240-Pin SODIMM

DESCRIPTION

This document describes ValueRAM's 1G x 64-bit (8GB)

DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, low voltage, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This

204-pin SODIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:

SPECIFICATIONS

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh

Command Time (tRFCmin)

Row Active Time (tRASmin)

Maximum Operating Power

UL Rating

Operating Temperature

Storage Temperature

FEATURES

•

JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~

1.575V) Power Supply

• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)

•

800MHz fCK for 1600Mb/sec/pin

•

8 independent internal bank

•

Programmable CAS Latency: 11, 10, 9, 8, 7, 6

•

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•

8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or

MRS]

•

Bi-directional Differential Data Strobe

•

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

•

On Die Termination using ODT pin

•

Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

•

PCB: Height 1.18” (30mm), double sided component

*Power will vary depending on the SDRAM.

11 cycles

48.125ns (min.)

260ns (min.)

35ns (min.)

(1.35V) = 2.721W*

94 V - 0

0 o C to 85 o C

-55 o C to +100 o C

Continued >>

Document No. VALUERAM1348-001.A00 05/07/13 Page 1

MODULE DIMENSIONS:

(units = millimeters)

Document No. VALUERAM1348-001.A00 Page 2