DPH 101 • User Guide
The Extron DPH 101 DisplayPort to HDMI active adapter equalizes incoming DisplayPort sources up to 15 feet (4.5 meters) at the input to compensate for signal loss. The DPH 101 then reconditions the signal, ensuring signal integrity up to an additional 15 feet (4.5 meters) from the output to the connected HDMI device.
FCC Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. The Class A limits provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference; the user must correct the interference at his own expense.
NOTE: This unit was tested with shielded I/O c ables on the peripheral devices. Shielded cables must be used to ensure compliance with FCC emissions limits.
For more information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the “ Extron Safety and Regulatory Compliance Guide ” on the Extron website.
Specifications Availability
Product specifications are available on the Extron website, www.extron.com
.
Features
• Provides connectivity between Type 2 enabled, 4K-capable Dual-Mode DisplayPort equipped sources and HDMI sink devices
• Equalizes incoming DisplayPort signals up to 15 feet (4.5 meters) to compensate for signal loss
• Reconditions HDMI signals at the output to ensure signal integrity up to 15 feet (4.5 meters) to the connected HDMI device
• Supports computer video to 2560x1600, HDTV 1080p/60 Deep Color, and 4K resolutions
• Passes EDID information from HDMI display to the source
• HDCP compliant
• Supports data rates of 3.4 Gbps per color (10.2 Gbps total)
• LED indicator for signal presence and power — Provides visual indication of system status for real-time feedback and monitoring of key performance parameters
• Shares power supply with another Extron product or optional external power supply
1
DPH 101 • User Guide (Continued)
Mounting
Use the included hook and loop tape to attach the DPH 101 to the application surface.
Cabling
A B C
POWER
12V
0.2 A MAX
SIG
DPH
101
SIG
DP IN HDMI OUT
DPH 101
Rear
Figure 1. DPH 101 Panels
Front
A DC power input — Wire the external 12 VDC power supply as shown in figure 2 and connect it to the two-pole captive screw
Power connector.
A
Smooth Ridges
SECTION A–A
A
Power Supply Output Cord
Figure 2. Power Connection
3/16"
(5 mm) Max.
NOTE: See the
Attention on the next page for important information.
The DPH 101 can also share power with an Extron switcher or similar device (as shown in figure 3).
POWER
12V
0.2 A MAX
SIG
DP IN
DPH
101
SW4 HDMI
POWER
12V
0.5A MAX
1 2
INPUTS
3 4
OUTPUT REMOTE
TALLY OUT
1 2 3 4 +V
CONTACT
1 2 3 4 G
RS-232 AUTO
Tx Rx
PS 1210 C DPH 101 SW4 HDMI
DC Power
Shared
DC Power
Output
Figure 3. Sharing Power with an Extron Switcher
B DP input — Connect a Dual-Mode DisplayPort input device to the DP input. The DPH 101 equalizes DisplayPort signals up to 15 feet.
NOTE: The DPH 101 can be used with Extron DisplayPort Architectural products, such as the DisplayPort F-F
Architectural Adapter Plate (see
figure 5
on page 4). However, it is not recommended to use more than one DP-DP pigtail in an application.
C HDMI output — Connect an HDMI output device to the HDMI output. The DPH 101 reconditions HDMI signals up to 15 feet.
NOTE: Extron recommends using HDMI Pro Series cables for 300 Mhz pixel clock (4K/UHD) signals.
2
DPH 101 • User Guide (Continued)
ATTENTION:
• The length of the exposed wires in the stripping process is critical. The ideal length is 3/16 inches (5 mm).
Any longer and the exposed wires may touch, causing a short circuit between them. Any shorter and the wires can be easily pulled out even if tightly fastened by the captive screws.
• Always use a power supply supplied by or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the end product.
• If not provided with a power supply, this product is intended to be supplied by a UL Listed power source marked “Class 2” or “LPS” and rated output 12 VDC, minimum 0.5 A.
• Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling spaces or in wall cavities. The power supply is to be located within the same vicinity as the Extron AV processing equipment in an ordinary location, Pollution Degree 2, secured to the equipment rack within the dedicated closet, podium, or desk.
• The installation must always be in accordance with the applicable provisions of National Electrical Code
ANSI/NFPA 70, article 725 and the Canadian Electrical Code part 1, section 16. The power supply shall not be permanently fixed to building structure or similar structure.
• La longueur des câbles exposés est primordiale lorsque l’on entreprend de les dénuder. La longueur idéale est de 5 mm (3/16 inches). S’ils sont un peu plus longs, les câbles exposés pourraient se toucher et provoquer un court circuit. S’ils sont un peu plus courts, ils pourraient sortir, même s’ils sont attachés par les vis captives.
• Utilisez toujours une source d’alimentation fournie par Extron. L’utilisation d’une source d’alimentation non autorisée annule toute conformité réglementaire et peut endommager la source d’alimentation ainsi que l’unité.
• Si ce produit ne dispose pas de sa propre source d’alimentation électrique, il doit être alimenté par une source d’alimentation certifiée UL de classe 2 ou LPS et paramétré à 12 V et 0,5 A minimum.
• Sauf mention contraire, les adaptateurs AC/DC ne sont pas appropriés pour une utilisation dans les espaces d’aération ou dans les cavités murales. La source d’alimentation doit être située à proximité de l’équipement de traitement audiovisuel dans un endroit ordinaire, avec un degré 2 de pollution, fixé à un équipement de rack à l’intérieur d’un placard, d’une estrade, ou d’un bureau.
• Cette installation doit toujours être en accord avec les mesures qui s’applique au National Electrical Code
ANSI/NFPA 70, article 725, et au Canadian Electrical Code, partie 1, section 16. La source d’alimentation ne devra pas être fixée de façon permanente à une structure de bâtiment ou à une structure similaire.
LED Indicators
A A B C B C
POWER
12V
0.2 A MAX
SIG
POWER
12V
0.2 A MAX
DP IN
SIG
DPH
101
DP IN
Rear
DPH
101
SIG
HDMI OUT
SIG
HDMI OUT
DPH 101 DPH 101
Rear Front
Figure 4. DPH 101 LED Indicators
Front
A SIG LED (rear) − Lights up to indicate signal presence on the DisplayPort input.
B Power LED − Lights up to indicate power.
C SIG LED (front) − Lights up to indicate signal presence on the HDMI output.
3
DPH 101 • User Guide (Continued)
Application Diagrams
NOTE: In order for the DPH 101 to operate in the system, the DisplayPort source (laptop or desktop PC) must be a
Dual-Mode DisplayPort device. Dual-Mode DisplayPort devices are marked with the logo.
Laptop not
Supplied
SIG
HDMI OUT
DPH 101
E
DPH 101
DPH
101
PO
WE
12V
0.2
R
MA
X
SIG
DP
IN
DPH 101
DisplayPort
Cable
DisplayPort
Cable
DisplayPort
AAP
HDMI Cable
HDMI Display
Figure 5. DPH 101 Application with DisplayPort AAP
4
DPH 101 • User Guide (Continued)
Laptop not
Supplied
DisplayPort
Cable
Cable Cubby
SIG
HDMI OUT
DPH 101
Extron
DPH 101
PO
WE
R
12V
0.3
AX
A M
1
SW4 HDMI
Switcher
2
INPUT
S
3
4
OUTPUT
1
1
RE
MO
LLY
OU
T
TE
RS-
232
A
UTO
2
CO
NT
3
4 +v
ACT
Tx
Rx
G
4
2
3
12V
0.2
WE
R
MAX
SIG DP
IN
DPH
101
DPH 101
HDMI Cables
Blu-ray
Figure 6. DPH 101 Application with SW4 HDMI Switcher
DisplayPort
Cable
Cable Retractable
System
HDMI Display
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX +1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Australia
+61.8.8351.2188
+61.8.8351.2511 FAX
68-2656-01 Rev B
04 17
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
© 2017 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
