Aiphone RA-A User's Manual

woe 2 AIPHONE
RAX/RCX TYPE A DUPLEX INTERCOM
M O D E LS " “Master, Open voice with handset
Master, Open voice (Flush-mount)
Master, Speaker-phone type
Sub, Open voice (Flush-mount)
RA-A
Speaker
Privacy Switch
Call LED and secretary transfer
Talk button (and absence memory) indicator
(for paging and simplex ———d
communication} Volume control switch
1 ~ 9 Number button (7) Dill OFF button
f i li I
or station ca EE (6) >) | Master-to-Sub call button
LE; E (oh) Privacy temporary release button
Memory button
3 Ц
® (9) Ju Talk button
{for paging and simplex
| communication)
| .
Bar switch (for handset private
——— a
Station number plate |
communication and privacy
temporary release)
RA-D Handset
Speaker Page button
Microphone
® The call tone & communication volume can be adjusted
to three levels.
pad (same as
RA-A's) LOW MEDIUM HIGH
m) (mm) (mw)
LEFT MIDDLE RIGHT
* (DOWN) * (MIDDLE) * (UP)
Call LED and secretary transfer
Station No. (and absence memory) indicator
plate
Microphone Volume control switch (*)
Privacy switch
RA-B ) =
o О, || RAC
I con ceo — HAIN
secretary transfer
III 4 fama sosence |
7 memory) indicator
Privacy | I Volume control —# |
switch |! switch
T— OFF button
К
— Master-to-Sub —
L
HHI call button P= HIN
CL Station number pea |!
О | plate -
J
A Microphone —
—1—
1 CALLING
OPERATION | MODE OF THE CALLED STATION ACTION
Press digit buttons of (1) =— Single call tone | > Communicate.
desired station. (2) BEEN Busy tone > Press | * | (OFF) button
(4) [0] for station No.10 | (or hang up handset in RA-D)
[1) [0] (0) for station No.100 to cancell call.
| ОК Press button to leave a
request for call back.
(Camp-on busy)
OR Press [ 0] button for urgent break
in signal and (for RCX only)
press [1] button to call by voice.
Master/sub communication; (3) NN Network busy tone =p Press [*) (OFF) button.
* At RA-C sub, simply press (in RCX only)
[=] button to call master. (4) == === Privacy tone = Wait for station to release from
* At master, press [>] button | privacy mode.
(and, in RCX only, a digit (5) —mmws Absence tone > Press [*] (OFF) button to
button ~ {9]) to call sub. (in RCX only) cancell call.
- OR Press button to leave a
request for call back.
(Camp-on absence)
Press [*) (OFF) button or
hang up handset in RA-D to
end communication.
RECEIVING
MODE OF YOUR STATIÓN CALLING TONE | ACTION
(1) Non-privacy mode Single call tone » Communicate handsfree.
OR At RA-A, pick up the unit and depress the
bar switch for private communication.
OR At RA-D, pick up handset for private
communication.
(2) Privacy mode Privacy call tone mp — Momentarily press Pk] button and
communicate handsfree.
OR At RA-A, pick up the unit and depress the
bar switch for private communication.
OR At RA-D, pick up handset for private
communication.
(3) Communicating with Urgent message » Press button to place present
another station break-in signal communication on hold, and reply.
and call (in RCX only) y
Press [ ® | button to restore connection to
| station on hold.
J
2 PRIVACY — To block out incoming calls and prevent monitoring;
* Setting Privacy mode; Slide PRIVACY Switch to the right position. |=
* Releasing from Privacy mode; Slide PRIVACY Switch to the left position. (m |
— Note: Setting and releasing from Privacy mode must be made while your station is in standby mode.
A
3 CALL HOLDING — To place present communication on hold;
* Press button.
*Press [* ) button to restore connection to station on hold and resume conversation.
4 CALL TRANSFER — To route incoming calls to another station;
(1) Press button.
(2) Press number of station where call is to be transferred.
(3) After communication line is established, press (7 | button. | (3) After communication line is established, press (© ] button.
| Note: When you have no reply, press [ * ) button and resume the initial communication. J
5 SECRETARY TRANSFER (STATION TRANSFER) 7 To have any incoming call to you answered by
your secretary;
----------------———-—------------=-- = --——-— -— — — 222 a нее кем = = о коб ое ее Що
*Cancelling Secretary Transfer mode; Press and [ 0) buttons.
*Setting Secretary Transfer mode; Press [©] button and station number of your secretary. -
6 SIMPLEX COMMUNICATION — When communicating with a station located in a noisy area;
(Pres [2] button to talk and release to listen. )
*WHEN YOUR SYSTEM INCLUDES PAGING FUNCTIONS;
7 ALL PAGE - To page all zones in your system through paging speakers;
(1) Press , [9] buttons (and button, if call
back is required).
(1) Press , [9] buttons.
(2) Make announcement while depressing and holding (*) (1) button.
(3) Wait for call back. OR If call back is not desired, press [ e) button.
8 ZONE PAGE —To page one zone in your system through paging speakers;
(and button, if call back is required).
(1) Press and zone number button ( [1] ~ [4]). | (1) Press , zone number button ( - [4] )
(2) Make announcement while depressing and holding (1) button.
If talkback is included, release (*) [1] button to listen.
(3) Wait for call back. OR If call back is not desired, press [*] button.
9 CALL BACK TO PAGING (ALL PAGE/ ZONE PAGE)
Press [ 8) button at the nearest station. Press [8) and buttons at any station
(in a zone paged).
(*) In RA-A and RA-D, TALK button in handset works for [1] (TALK) button on the dial key pad.
—3—
10 ALL CALL — то page through all intercom stations;
(1) Press Ls) button. (1) Press and (9) button (and button, °
if call back is required).
(2) Make announcement while depressing and holding (3] button. (*) | |
(3) Wait for call back. OR If call back is not desired, press [ * ) button. В
11 CALL BACK TO ALL CALL
| (1) Press button at the nearest station. (1) Press [5] and buttons at the nearest station. |
12 GROUP CALL — To page through a group of intercom stations;
( >
| (1) Press and a group number button [ 5) ~
(and button, if call back is required).
(2) Make announcement while depressing and
holding [2] button. (*)
(3) Wait for call back. OR If call back is not desired,
press [ * ) button.
\. J
13 CALL BACK TO GROUP CALL
(1) Press [5] and buttons at any station of a
group paged.
*WHEN YOUR SYSTEM INCLUDES DEVICES, SUCH AS INTERNAL/EXTERNAL LIGHTS, DOOR RELEASE ETC.
14 REMOTE OPERATION OF EXTERNAL DEVICES
a Press [:) button and zone number button € (1), (2), (3Jor a ). )
(2) Momentarily press { 3] button. (*)
* If you hear intermittent tone, the external device is in ON mode.
* If you hear a continuous tone, the external device is in OFF mode.
(3) Depress [0] button to reverse ON/OFF mode of internal/external lights, etc. OR
Depress and hold (©) button to activate electric door release, etc.
q (4) Press («| button. )
15 CONFERENCE CALL — To initiate a conference call;
4 | |
(1) Press number button of each station to be included
and button after each (up to 5 stations).
(2) Initiator depresses and holds down (*) [2] button
and begins conversation.
(3) The called stations must depress and hold down
(3) button (*) to respond.
(4) The called stations press [ * | button to get out of
the conference.
At conclusion of the conference, initiator must
press [ *) button. D
(*) In RA-A and RA-D, TALK button in handset works for (3) (TALK) button on the dial key pad.
—4—
16 ABSENCE MEMORY — To program your station to remember who called during your absence;
| (1) Press and Phkj buttons.
(2) Upon your return, red light flickering every other
| second indicates that you have calls in your
| | station’s memory bank.
17 ABSENCE MEMORY CALL BACK — When you noticed fast flickering red light upon your return;
( —
(1) Press button.
| (2) Press [*] button at completion of your
| conversation.
| (3) Repeat process until red light flickers more
slowly and all calls have been answered.
(4) Absence Memory Clear; Press and (0)
buttons to restore your station to normal
operation. J
18 MEMORY CLEAR
— To erase all memory functions except privacy (Camp-on busy, Camp-on absence, Absence memory & Secretary transfer)
| Press and [9] buttons and your station returns to normal operation. |
OPERATIONAL FLOW
No. |
NN
RCX
(and [No.] in RCX-88, -128)
STATION CALL
OFF [e Jor Hang up handset. [e Jor Hang up handset.
(RA-D) (RA-D)
CAMP-ON BUSY SET
CAMP-ON BUSY CLEAR (0) Lo
| ORCENTMESAGEBRENGNO | [coses | (Dosis) — [Edo
URGENT MESSAGE BREAK-IN
MASTER/SUB COMMUNIC ATION >] = Master cau
PRIVACY _m | в)
2 | NON-PRIVACY Ca ГВ
TEMPORARY PRIVACY RELEASE
3 CALL HOLDING = | ® Jor [ ® ](to return) | > [e (to return)
4 | CALL TRANSFER ((No.])
SECRETARY (STATION) TRANSFER ((No))
5
SECRETARY (STATION) TRANSFER Го
6 | SIMPLEX COMMUNICATION El El
7 | ALLPAGE (WITH CALL BACK) [9)(1) [8] (=) 3]
8 | ZONE PAGE (WITH CALL BACK) (1) (DES
9 | CALL BACK TO PAGING (6) [6]
10 | ALL CALL (WITH CALL BACK) (5) (4) DEEE
11 | CALLBACK TO ALL CALL (5) (5)
12 | GROUP CALL (WITH CALL BACK) (EDES
13 | CALL BACK TO GROUP CALL (5)
14 | REMOTE OPERATION [3] [9] (3) (0)
15 | CONFERENCE CALL - m (+)
16 | ABSENCE MEMORY SET Ph
ABSENCE MEMORY CALL BACK
" ABSENCE MEMORY CLEAR [о]
18 | CLEAR MEMORY (0) [o]
RCX SYSTEM OPTIONS
1 DOOR STATIONS
— To receive a call from up to two door stations at either of up to five programmed master stations;
(1) A call from door station is announced at all programmed master stations by electronic chime.
* If the chime is 4 strokes, the call is from the first door station.
Press [5] [>] buttons.
* If the chime is 2 strokes, the call is from the second door station.
Press (6 ] [»] buttons. |
(2) Talk handsfree. In RA-A, Pick up the unit and hold the bar switch and, in RA-D, pick up handset for private hand-
set communication. When the door station is situated in a noisy area, you may press [ $) (TALK) button to talk and
release to listen, |
(3) If your system includes a door release, momentarily press [0] button during communication, which activates the
timer circuits for opening the door.
a Press [ *] (OFF) button or hang up handset in RA-D to end communication with door station.
2 ADDITIONAL PAGING/REMOTE CONTROL
/
To select any YAW adaptor, press [7] [+] buttons.
(1) When continuous mono tone is heard;
Paging with YAW-R or YAW-RA;
Press [::) button and an adaptor number button (0 ~ 9) (and a zone number button in YAW-RA 1 ~ 8). Make announcement
depressing [ 3] button (and release to listen, if talkback is included). Press [ ) button at end of announcement.
NOTE:
After selecting an adaptor number for YAW-RA, press zone number buttons (1 ~ 8) in succession for multiple zone page or
[® button for all page (to 8 zones simultaneously).
Remote operation of controlling ON/OFF of lights or door release, etc.:
Press button and an adaptor number button (0 ~ 9) for YAW-S.
* When an intermittent tone is heard, the lighting function is in ON mode.
* When a continuous tone is heard, the lighting function is in OFF mode.
Alternate operation: Momentarily press button to turn on lights. OR
Momentarily press button to turn off lights.
Momentary operation: Press and hold | © | button down to activate door release, etc.
Press | * | button.
(2) When intermittent tone is heard;
It means other station is operating paging or remote control and the channel is occupied. Press | * } button to disconnect and call
later.
NOTES:
1. It is not possible to operate two or more adaptors at the same time.
2. Paging/remote control operations can be made by master stations RA-A, RA-B and RA-D.
DIRECTORY
SYSTEM
Aiphone Co., Ltd., Nagoya, Japan
INTERCOM SYSTEMS
Aiphone Corporation, Bellevue, Washington <> Al PHON E
HOME, BUSINESS, INDUSTRY
RA-A-OM (E) 1090F
— 8 — Printed in Japan (E)