PENTAX /2С35 им |
PENTAX LENS
PENTAX
|
The PC35 Winder, an optional auto film winder exclusively designed
for the Pentax PC3SAF, is able to automate film winding functions.
e The PC35 winder operates on two 1.5V alkaline mini batteries;
approximately ten 36-exp. film cassettes may be used when
the winder is provided with a new set of batteries.
e Film transport—will advance the film one frame after a photograph
has been taken.
o Winder capability—approximately one frame per second
e Size & weight—54(w) X 72.5(h) X 46(d}mm; 85g w/o batteries
Description of components
© Coupler
© Coupling gear
© Shutter release button
O Guide pin
O Winder screw
@ Grip/Battery chamber
Battery reminders
e Incorrectly placed batteries in
the winder unit will cause a
malfunction—please recheck
proper insertion.
e When battery supply weakens
through power drain, the
winding becomes much slower;
they should then be replaced
with a new set.
¢ Battery replacements should
always consist of the same type/
Insertion of batteries
1. Remove battery chamber cover
at winder base by gently
pushing it in the direction of the
arrow.
2. Carefully place two 1.5V mini
batteries in the chamber
provided according to the + and
— cap markings; close cover.
Caution
eo Winder may operate even if
the batteries are improperly
inserted, but film winding
doesn’t function.
© Contact pins
© Winder screw
© Film advance wheel cover
® Power switch
O Battery chamber cover
brands to insure quality and
uniform performance from your
unit.
e In the event that the camera/
winder is not used for some time,
the batteries should be removed,
old or low powered batteries may
leak, causing damage to the
camera/winder mechanism.
e Keep the batteries warm when
using the winder under lower
temperature condition.
Winder installation
1. Set winder on Pentax PC35AF
side, to enable proper coupling
of component (covering for
shutter button & film advance
wheel) of the winder so that it
completely covers the camera's
shutter button.
2. Firmly affix winder screw,
turning the same clockwise—a
coin or similar object may be
used for this purpose.
Film loading
In loading a film cassette, open
film advance wheel cover by
sliding it to the right as illustrated.
Ascertain by winding on slightly
that film perforations are properly
e When the film comes to
an end, the motor will
idle with clatter; turn off
the winder switch. Also,
when the batteries are
worn out, the film is not
wound up; replace
the batteries right away.
Operation
1. Winder power switch must be
turned on; close film advance
wheel cover, and the film will be
automatically wound on until
film counter indicates “1"—at
the positioning of ‘0-2".
2. The winder is now ready for
operation. Pressing the shutter
release button, an audible click
will be heard; by releasing the
pressure, the film will be
automatically advanced.
In the event of possible power
failure, film may also be wound
manually by using the normal
film advance wheel.
For film unloading, see the
operating manual of Pentax
PC35AF camera.
engaged by the sprocket; then,
take up any remaining slack,
using the rewind crank, and
replace back cover.
8008800000000
‘Fos
GOD0D0O0O900
Notes:
e The winder stops its forward
movement after cocking the
shutter, so even if the winder
power switch is turned off,
depressing of the winder's
shutter button will release the
shutter unexpectedly, which
may cause waste of a frame.
To avoid such a releasing the
shutter in error, close the lens
protector.
“UY — | Asahi Optical Europe N.V, Weiveldiaan 3-5,
Pentax Svenska AB Box.6
e Whenever the camera's back
cover or the film advance wheel
covering of the winder is open,
the winder will not operate as
the built-in safety mechanism
acts as a safety device.
Asahi Optical Co., Ltd. C.P.O. 595, Tokyo 10091, JAPAN
‚ 1930 Zaventem Zuid-7, BELGIUM
Pentax Handelsgesellschaft mbH Postfach 54 0169, 2000 Hamburg 54, WEST GERMANY
Pentax UK, Limited Pentax House, Sauth Hill Avenue, South Harrow, Middlesex HA2 OLT, U.K.
Pentax France S.A, Z 1, Argenteuil, 12, Rue Ambroise-Croizat, 95100 Argenteuil, FRANCE
Pentax (Schweiz) AG Industriestrasse 2, 8305 Dietlikon ZH, SWITZERLAND
5-781 27 Uppsala, SWEDEN
Pentax Nederland Spinveld 25, 4815 HR Breda, THE NETHERLANDS
Pentax Corporation 35 Inverness Drive East, Englewood, Cotorado 80117, USA.
Pentax Canada Inc, 1760 West 3rd Avenue, Vancouver, B.C. VÓJ1K5, CANADA
Asahi Optical Brasileira Ind. e Com. Ltde. Rus Capitóo Antonio Rosa 376, Sala 121 Ed. PBK, S50 Paulo, BRASIL
06341 ENG
Specifications are subject to change without notice.
8/84 Printed in Japan
">
