Behringer | TM300 | User's Manual | Behringer TM300 User's Manual

Behringer TM300 User's Manual
Thank you for showing your confidence in us by purchasing the BEHRINGER TUBE AMP
MODELER TM300. This high-quality effects pedal provides 3 classic guitar amps, 3 gain
modes and 3 mic placements for a total of 27 configurations that let you easily achieve
the most sought-after tube amp sounds from clean, crunch to super-fat distortion.
Thanks to its high-performance features you can achieve the typical hard rock or heavy
metal distortion sounds.
Top view
The LEVEL control adjusts the output level.
The LOW control allows you to boost/cut the low-frequency range.
The HIGH control allows you to boost/cut the high-frequency range.
The DRIVE control adjusts the amount of overdrive effect.
The MIC switch simulates the microphone placement (orientation and distance) in
relation to the cabinet. Select CLSIC (Classic: distant mic placement without ambience)
to achieve high mid-range content and a greater definition of notes like with classic
early tube amps. In CNTR (Center: close miking at the center of a cone) you get
greater high mid-range content and increased low-end for mega crunchy results.
OFF X (Off Axis: close miking at the edge of a cone) is very similar to CNTR, but
produces a smoother, softer sound with less upper mid-range content; perfect in
combination with MODE position HOT.
Use the MODE switch to dial up one of 3 gain settings (HOT, HI G, CLN) that you
want to combine with the amp setting.
Use the AMP switch to select one of 3 great classic tube amps. You will recognize
these classic amp tones as soon as you hear them. For crystal-clear, transparent
sounds with dynamic bass select TWEED. For aggressive mids and incredible
sustain select BRIT(ISH). Rounder and more evened-out (yet still sophisticated)
sounds can be dialed up if you select CALIF(ORNIAN); it’s perfect for leads.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The TM300 has no on/off switch. As soon as you insert the plug into the IN
connector, the TM300 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the underside.
For our current warranty terms, please refer to our website at
1/4" TS
500 kΩ
Power supply
Power connector
Power consumption
Dimensions (H x W x D)
1/4" TS
1 kΩ
, 100 mA regulated
120 V~, 60 Hz
Europe/U.K./Australia 230 V~, 50 Hz
220 V~, 50 Hz
220 V~, 60 Hz
100 V~, 50/60 Hz
2 mm DC jack, negative center
9 V type 6LR61
30 mA
approx. 54 mm (2 1/8") x 70 mm (2 3/4") x 123 mm (4 4/5")
approx. 0.33 kg (0.73 lbs)
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made
from time to time to existing products without prior notice. Specifications and appearance may therefore differ from those listed or shown.
Do not use near water, or install near heat sources. Use only authorized attachments/accessories. Do not service product yourself.
Contact our qualified servicing personnel for servicing or repairs, especially when power supply cord or plug is damaged.
No utilizar cerca de agua o instalar cerca de fuentes de calor. Utilice sólo accesorios y aditamentos autorizados. No intenté reparar
el producto usted mismo. Contacte a nuestro personal técnico cualificado para servicio y reparaciones, especialmente cuando la
fuente o el cable de alimentación estén dañados.
Не эксплуатируйте прибор вблизи от источников воды и тепла. Применяйте только авторизованные дополнительные
устройства. Никогда не ремонтируйте прибор самостоятельно. Ремонт может производить только квалифицированный
специализированный персонал, особенно при повреждениях сетевого провода или сетевой вилки.
Die deutsche Anleitung ist erhältlich @
Manuel francophone en téléchargement sur
Manual en español disponible en
Manuali italiani disponibili @
Русскоязычное руководство @
Polska instrukcja dostępna jest pod adresem @
Nederlandse handleiding beschikbaar @
Suomenkielinen käyttöohje saatavilla osoitteesta
Svensk manual finns tillgänglig på
Dansk vejledning findes på @
Manual português disponível @
Åëëçíéêü åã÷åéñßäéï õðÜñ÷åé äéáèÝóéìï óôç äéåýèõíóç
Technical specifications and appearance subject to change without notice. The information contained herein is correct at the time
of printing. BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part
upon any description, photograph or statement contained herein. Colours and specification may vary slightly from product.
Products are sold through our authorised dealers only. Distributors and dealers are not agents of BEHRINGER and have
absolutely no authority to bind BEHRINGER by any express or implied undertaking or representation. No part of this manual may
be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any
kind, for any purpose, without the express written permission of BEHRINGER International GmbH. BEHRINGER, the BEHRINGER
logo and JUST LISTEN are trademarks of BEHRINGER. ALL RIGHTS RESERVED. © 2006 BEHRINGER International GmbH,
Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Münchheide II, Germany. Tel. +49 2154 9206 0, Fax +49 2154 9206 4903
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF