Cabela's Cabelas Grinder Foot Pedal 08-0901 User's Manual

ATTENTION

If any components of this unit are broken or the unit does not operate properly, please contact Cabela’s Customer Service.

Retail Store Purchases: 1-800-905-2731 (U.S. & Canada)

Catalog and Internet Purchases: 1-800-237-8888

All International: 1-308-234-5555

DO NOT RETURN THE UNIT TO THE STORE

WHERE IT WAS PURCHASED!

SAVE THESE INSTRUCTIONS!

REFER TO THEM OFTEN AND USE THEM TO INSTRUCT OTHERS.

Model No. 08-0901

Before beginning the assembly, check the package contents for all of the parts.

If you are missing any parts, or if any parts are damaged, contact

Cabela’s Customer Service- Retail Store Purchases 1-800-905-2731 (U.S. & Canada) /

Catalog & Internet Purchases: 1-800-237-8888 / All International: 1-308-234-5555

WARNING!

Before attaching or detaching the Foot Pedal to the grinder, make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE and the power switch is in the OFF position. ALWAYS unplug the Foot Pedal and the grinder when not in use. ALWAYS FOLLOW THE MANUFACTURER’S INSTRUCTIONS AND SAFETY

GUIDELINES THE COME WITH THE GRINDER AND THE FOOT PEDAL.

IMPORTANT SAFETY RULES

READ AND FULLY UNDERSTAND ALL INSTRUCTIONS

AND WARNINGS PRIOR TO USING THIS UNIT. YOUR

SAFETY IS MOST IMPORTANT! FAILURE TO COMPLY

WITH PROCEDURES AND SAFEGUARDS MAY RESULT

WARNING!

REMEMBER: YOUR PERSONAL SAFETY IS YOUR

RESPONSIBILITY!

1. DO NOT use the grinder and the Foot Pedal the manufacturer’s guidelines.

2. Using the Foot Pedal on grinders without can cause serious injury. Follow the grinder’s manufacturer safety guidelines. DO NOT use the

Foot Pedal on grinders without proper installation.

position before attaching to the power source.

11. NEVER LEAVE THE GRINDER AND from power source before leaving the work area. Close supervision is necessary when any appliance is used near children. This appliance is

NOT to be used by children.

3. The Foot Pedal should be utilized so that dangerous areas of the grinder. KEEP FINGERS

12. TIE BACK loose hair and clothing, and roll the Foot Pedal. REMOVE ties, rings, watches, grinder and the Foot Pedal. doing so may cause serious injury. ALWAYS

USE THE PROVIDED STOMPER, NEVER FEED

FOOD BY HAND. NEVER use fingers to scrape food away from the Grinding Plate while the

Grinder is in operation. SEVERE INJURY MAY

RESULT.

13. Be sure the grinder is on a stable work

14. feet.

ONLY use the Foot Pedal with shoes on.

4. ALWAYS DISCONNECT grinder and the changing accessories, plates or knives or cleaning the unit.

15. The Foot Pedal may become HOT during operation. This is normal. DO NOT touch the

Foot Pedal parts during operation or until they cool after use.

5. Plug the grinder and the Foot Pedal into a standard 120 Volt, 60 Hz wall outlet.

6. DO NOT USE the grinder and the Foot Pedal damaged. If the Power Cord, the grinder or the

Be sure to not allow the Power Cord to drape into your work area. Check that all parts are operating properly, and perform the intended functions.

Check for alignment of moving parts or any other conditions that may affect the operation. DO NOT use extension cords.

16. ONLY use the Foot Pedal on hard, flameon carpeted surfaces.

17. Keep the area around the Foot Pedal clear place an object on the grinder running. The

Foot Pedal to keep the intermittent grinding and stuffing.

18. This product is not intended for commercial use. Commercial use will void the warranty.

7. NEVER use any accessories or parts from

WARRANTY and may cause fire, electrical shock or injury.

19. WEAR EYE PROTECTION. Wear safety glasses. Everyday eye glasses are not safety glasses. Safety glasses conform to ANSI Z87.1 requirements. Note: approved safety glasses have Z87 printed or stamped on them.

8. TO PROTECT AGAINST RISK OF

ELECTRICAL SHOCK: DO NOT SUBMERGE

THE GRINDER OR THE FOOT PEDAL INTO

WATER OR LIQUID. BE SURE THE GRINDER

AND THE FOOT PEDAL ARE DISCONNECTED

FROM THE POWER SOURCE BEFORE

CLEANING. DO NOT use near water or liquids.

20. DO NOT use outdoors.

21. The Foot Pedal is intended for use with

Grinders ONLY.

22. DO NOT use the grinder and the Foot Pedal alcohol.

9. Be sure the Foot Pedal is on the, clean, dry floor.

10. Reduce risk of unintentional starting. Make sure the power switch of the grinder is in the “OFF”

23. DO NOT let the Power Cord hang over edge

SAVE THESE INSTRUCTIONS!

Refer to them often and use them to instruct others.

INSTALLATION

WARNING!

Before attaching or detaching the Foot Pedal to the grinder, make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE and the power switch is in the OFF position. ALWAYS unplug the Foot Pedal and the grinder when not in use. ALWAYS FOLLOW THE MANUFACTURER’S INSTRUCTIONS AND SAFETY

GUIDELINES THE COME WITH THE GRINDER AND THE FOOT PEDAL.

1. Be sure the power switch on the grinder is in the ‘OFF’ position.

2. Plug the power cord on the grinder into the back of the plug on the Foot Pedal.

3. Plug the Foot Pedal into a 110 Volt electric outlet.

4. Turn the switch grinder switch to the

‘ON’ position.

5. The grinder will not operate until the

Foot Pedal is depressed with your foot.

6. To stop the grinder, release the pressure on the Foot Pedal by raising your foot.

GROUNDING INSTRUCTIONS

GROUNDING

This appliance must be grounded while in use to protect the operator from electrical shock. The appliance is equipped with a 3-conductor cord and a 3-prong grounding type plug to fit the proper grounding-type receptacle. The appliance has a plug that looks like

Figure A. An adaptor, Figure B, should be used for connecting Figure A plugs to two-prong receptacles.

The grounding tab which extends from the adaptor must be connected to a permanent ground such as a properly grounded outlet box as shown in Figure C using a metal screw.

Circuit

Grounding

Conductor

Grounding

Prong

Figure B

Metal

Grounding

Screw

Cover of

Grounded

Outlet Box

Grounding

Means

AA2220

Figure A

Figure C