iP29 IB in English version

Print color : Black text on white paper

Size of manual: 178mmW x 178mmH

June 26,09

P1

Model iP29

Portable Stereo Speakers for your iPod / iPhone

®

off on

Questions? Visit www.ihomeaudio.com

P3 iP29 Quick Start

Controls and Indicators

Using the iP29

A Consumer Guide to Product Safety

Trouble Shooting

Warranty Information

3-4

5

6

7

1

2

A Consumer Guide to Product Safety

IMPORTANT SAFETY INFORMATION: IT IS THE USER'S RESPONSIBILITY TO USE THIS PRODUCT PRUDENTLY,

RESPONSIBLY AND IN A SAFE, NON-DISTRACTED MANNER AT ALL TIMES. FAILURE BY THE USER TO PAY

FULL ATTENTION TO THE PROPER OPERATION OF ANY EQUIPMENT BEING USED ALONG WITH THIS

PRODUCT COULD RESULT IN AN ACCIDENT AND/OR PERSONAL INJURY.

P4

FCC Information

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area.

However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate interference you can try one or more of the following corrective measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and the radio or TV.

• Use outlets on different electrical circuits for the equipment and the radio or TV.

• Consult your dealer or an experienced radio/television technician if the problem still exists.

Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s warranty and void your FCC authorization to operate it.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Battery Information

For Model Included Battery More Than One Piece

• Do not mix with used or other battery types/brands

• Replace all cells at the same time

• Do not open batteries

• Do not dispose of in fire

• Do not heat above 75ºC (167ºF)

• Do not expose contents to water

• Do not charge or recharge

• Do not install backwards

Maintenance

• Place the unit on a level surface away from sources of direct sunlight or excessive heat.

• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture.

• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzene, thinner or similar materials can damage the surface of the unit.

P5

iP29 Quick Start

1:batteries 2:AC adaptor

off on line-in

Open battery compartments located to left and right inside unit. Insert 4 “AA” batteries (not included) as indicated on diagram. Unit can now play iPod/iPhone.

Batteries will not charge iPod/iPhone.

Connect AC adaptor to the DC jack (rear of iP29) and plug the other end into a working wall socket to charge and play iPod/iPhone. Does not charge batteries.

Use this insert iPhone 3G insert 15 iPod touch 2G insert 16 iPod nano 4G insert 17

For this iPhone/iPod iPhone 3G iPod touch 2G iPod nano 4G

NOTE: If you do not have an insert for your iPod, please visit www.ihomeaudio.com or call iHome toll free at 800-288-2792 to purchase one

3:inserts 4:iPod/iPhone

Select the dock insert for your iPod/iPhone model from the table above and place insert in dock.

Never dock an iPod/iPhone without an insert in place.

1 off on

Gently place iPod/iPhone on the connector plug in dock.

Slide Power Switch to ON. Unit and iPod/iPhone will turn on. Adjust volume by pressing the

+

or

–

Button.

P6

Controls and Indicators

Front Panel

Speaker

Left Battery Compartment

Dock

Volume “_”

(lowers volume) off on

Off/On Switch

Volume “+”

(raises volume)

Right Battery Compartment

Rear Panel

line-in

AC Adaptor Jack Line-in Jack

2

P7

Using the iP29

Installing/Replacing Speaker Batteries

FOR PORTABLE LISTENING

1. Open the battery compartment covers located on the left and right inside the unit.

2. Insert 4 “AA” batteries (2 in each compartment), checking the + and – ends of the batteries match the drawings inside the battery compartments. We recommend the use of alkaline batteries for longer life. Different types of batteries or new and used batteries are not to be mixed.

3. Close the compartment cover.

NOTE: Unit will not charge iPod/iPhone while operating on battery power

Batteries Information

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.

• Make sure you dispose of batteries properly (see your local regulations).

off on

Battery Compartment

Connecting the AC Adaptor

Connect the AC adaptor cable plug into the DC jack located under the black tab on the back of the unit, then plug the AC adaptor into the wall outlet. When connected to the AC adaptor, the iP29 charges and lets you play your iPod/iPhone.

NOTE: This AC adaptor is for use with the iP29 only. To avoid damage, do not use other adaptors with iP29.

line-in

Playing and Charging your iPod/iPhone

1. Place proper insert for your iPod/iPhone (see insert table on Quick Start Section) in Dock, then gently dock iPod/iPhone.

When docked and connected to AC power, the iPod/iPhone will charge until fully charged. The iPod/iPhone will not overcharge.

2. Switch the Power On/Off Switch to “ON” to play iPod/iPhone and the power on indicator will light up to show iP29 is on.

3. Press the + or – Button to adjust the volume.

4. To switch off the unit, slide the Power On/Off Switch to “OFF”. It will switch off both iP29 and your iPod/iPhone.

NOTE: If the Power On/Off Switch is in the ON position when you dock an iPod/iPhone that is paused or off the iPod/iPhone will autoplay (turn on and begin playing).

3

P8

Using iP29

Using the Line-in Jack

1. Plug one end of a standard audio patch cord (not included) into the headphone or line-out jack on your audio device and the other end of the patch cord into the iP29 Line-in Jack.

2. Switch the Power On/Off Switch to “ON” and the power on indicator will light up to show iP29 is on. You need to set your device to play too.

3. Press the + or – Button to adjust the volume. You may need to adjust your device’s volume, too.

4. To switch off the unit, slide the Power On/Off Switch to ‘OFF’. Do remember to switch off your device, too.

4

P9

A Consumer Guide to Product Safety

When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.

1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.

2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings.

3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances

(including amplifiers) that produce heat.

4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket.

6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions.

7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product.

8. Attachments – Do not use attachments not recommended by the product manufacturer.

9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges.

10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.

11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:

A. the power supply cable or plug has been damaged.

B. objects have fallen into or liquid has been spilled into the enclosure.

C. the unit has been exposed to rain.

D. the unit has been dropped or the enclosure damaged.

E. the unit exhibits a marked change in performance or does not operate normally.

12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a month or longer, the power cable should be unplugged from the unit to prevent damage or corrosion.

13. Servicing – The user should not attempt to service the unit beyond those methods described in the user’s operating instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel.

Questions? Visit www.ihomeaudio.com

or call 1-800-288-2792 Toll Free

5

Trouble Shooting

Symptom

Unit doesn’t respond

(no power)

Possible Problem Solution

AC adaptor isn’t plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the dock

Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit iPod/iPhone does not dock properly

Batteries are weak or dead

Using no or wrong iPod/iPhone insert iPod/iPhone not installed properly iPod/iPhone does not respond to the unit iPod/iPhone is not installed properly

Your iPod/iPhone software is too old iPod/iPhone is locked up iPod/iPhone does not come on immediately

Using 1 st or 2 nd generation iPod, iPod shuffle or other devices.

If your iPod/iPhone is not used for some time, it may enter deep sleep mode iPod/iPhone battery is run down or is too weak

Replace with new batteries

Make sure the dock insert is the proper fit for your iPod/iPhone

Remove your iPod/iPhone from the dock and check for obstruction on the connectors in the dock and on your iPod/iPhone. Make sure there is no “skin” or case on the iPod/iPhone. Then reseat it in the dock.

Remove your iPod/iPhone from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock.

Upgrade software on your iPod/iPhone via iTunes

Please make sure your iPod/iPhone is working properly before docking into the unit. Please refer to your iPod/iPhone manual for details.

Unit cannot control those iPod models or other devices.

Use the Line-in jack to play these devices.

Press the Menu button on your iPod/iPhone

Charge your iPod/iPhone for about 5 minutes

P10

6

P11

Limited 90-Day Warranty Information

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.

Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except for a $10.00 charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below. The product must include proof of purchase, including date of purchase. The fee for service without proof of purchase is $35.00.

Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or defective batteries are the most common cause of problems encountered.

If service is still required:

1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.

2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period.

3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($35.00 without proof of purchase).

4. Send the unit prepaid and insured, to the Factory Service Center listed below.

Consumer Repair Department

SDI Technologies Inc.

1330 Goodyear Drive

El Paso, TX 79936-6420

Disclaimer of Warranty

NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner.

This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser.

In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI Technologies product.

© 2009 SDI Technologies, Inc. All rights reserved

Questions? Visit www.ihomeaudio.com or call 1-800-288-2792 Toll Free

7

P12 iP29-062609-A Printed in China