ENTERTAINMENT/Music
PREMIUM MUSIC
SOLUTION
Now the family doesn't have to share the same music over the whole house system.
Homeowners can listen to any one of four audio sources in up to eight different locations at
the same time.
PREMIUM MUSIC / BILL OF MATERIALS
PRODUCT
PART #
QUANTITY
lyriQ Keypad in Studio Design
AU5009-WH
4
LyriQ Flush Mount Single Source Input
AU1004-WH
1
lyriQ Flush Mount Triple Source Input
AU1011-WH
1
lyriQ Four-Source, Eight Zone Distribution Module
AU1002
1
lyriQ Local Source Input in Studio Design
AU5008-WH
1
Home Systems Remote
AU1060
1
Dual IR mouse emitter
F7425
2
24VDC 60W Power Supply
PW1060
1
3000 Series 6.5" Ceiling Speakers (Pair)
MS3650
4
6.5" In-Ceiling Pre-Construction Speaker Bracket (pair)
364672-02
4
Universal IR Target
F7426
1
2-Gang Studio Wall Plate
WP5002-WH
1
1-Gang Studio Wall Plate
WP5001-WH
1
PREMIUM MUSIC / WIRING DIAGRAM
PREMIUM MUSIC
INSTALL / SETUP
The lyriQ™ Multi-Source Distribution Module, Single Source Input, Triple Source Input, Studio Keypad, Studio Local Source, Remote
Control, IR Emitter, IR Target and the evoQ™ In-Ceiling Speaker components of the On-Q Premium Music Solution each come with their
own installation/instruction sheets (IS-0327, IS-0392, IS-0406, IS-0420, IS-0421, IS-0419, IS-0405 and IS-0242 respectively) which detail
exactly how those components of the Premium Music Solution are to be installed.
As a complete solution, the Premium Music Solution is best installed during new construction in two steps; at “rough-in” after the
Electricians are done, but prior to drywall being installed, and at “trim-out” after the drywall is installed and painted. These steps are
detailed below:
“Rough-in” steps:
a.
One Category 5 cable should be run in the wall from one single gang electrical box or low voltage racket and two Category 5
cables should be run in the wall from one two gang electrical box or low voltage bracket at the location/s in the home where the
home entertainment center, containing the main source of music, will be located, to the location where the structured wiring
enclosure is located (leave extra cable at both ends).
b.
A single Category 5 cable should also be run from the enclosure location to a single gang electrical box or low voltage bracket at
each remote location where distributed music is desired (eventual volume control and/or local source input location).
Note: To enable future upgrades for higher current applications, also run a 16/2 or 16/4 speaker wire from the enclosure to each
eventual volume control location. There are bundled cables available with this configuration (see the CEA-2030 specification for
more detail on audio requirements).
c.
A Category 5 cable should also be run from the two Local Source Input locations to a single gang electrical box or low voltage
bracket at its associated eventual Volume Control location.
d.
From the single gang electrical box or low voltage bracket at each eventual Volume Control location, high quality 16/2 speaker
wire should be run to the eventual location of the speakers associated with that volume control.
e.
Speaker Brackets may be used to identify the exact location of the speakers, and adjusted to line up with previously installed
ceiling lights if desired. There are clips on the speaker bracket to secure a coil of speaker wire, which will be connected to the
speaker at trim-out.
Note: To achieve the maximum speaker efficiency, you can build a speaker back box by putting a cross stud at two locations,
(on either side of the speaker) in the stud space where the speaker will be mounted. Exact blocking distances between these
cross studs are provided on the Instruction/Installation sheet that comes with each speaker. Before installing the speaker (after
the drywall is installed), you can then fill this cavity with a good quality insulation to complete the back box.
PREMIUM MUSIC
INSTALL / SETUP
“Trim-out” steps:
f. At the home entertainment center location/s, the Category 5 cables that were run to the enclosure may be terminated with RJ45
plugs and attached to the rear of the Flush-Mount Single and Triple Source Inputs, which are then mounted in the single gang
and two gang electrical boxes or low voltage brackets.
g.
In the structured wiring enclosure the other end of those same Category 5 cables should be terminated with RJ45 plugs and
plugged into the input jacks of the Four Source, Eight Zone Distribution Module.
Note: It is very important to connect the Category 5 cable from the Triple Source Input’s “A” output to the Four Source, Eight
Zone’s “A” input and the Triple Source Input’s “B” output to the Four Source, Eight Zone’s “B” input. Damage to the module
may occur if these are reversed. The Category 5 cable from the Single Source Input’s only output is connected to the Four
Source, Eight Zone’s “Single” input.
h.
The Category 5 cables from each volume control location should be terminated with RJ45 plugs and plugged into the output
jacks (labeled “1”, “2”, “3” and “4”) of the Four Source, 8 Zone Distribution Module.
i.
At each of the two remote volume control locations without local source inputs, the Category 5 cable should be pulled through the
single gang electrical box or low voltage bracket and terminated with an RJ-45 plug which is then attached to the rear of the
Volume Control, which is then mounted in the single gang electrical box or low voltage bracket.
j.
At the other two remote volume control locations containing local source inputs, each Category 5 cable should be pulled through
the single gang electrical box or low voltage bracket and terminated with an RJ-45 plug which is then attached to the rear of the
Local Source Input.
k.
The Category 5 cable that was run from each Local Source Input location to its associated Volume Control location should be
pulled through the single gang electrical box or low voltage bracket and terminated with RJ-45 plugs on each end and plugged
into the “Output” RJ-45 jack on the rear of the Local Source Input and the other end should be plugged into the RJ-45 jack on the
rear of its associated Volume Control. The Local Source Input is then mounted in its associated single gang electrical box or low
voltage bracket.
Note: Follow standard TIA 568A rules for punching down Category 5 according to the indicated color codes.
l.
The Volume Controls contain screw terminals for left and right +/- speaker connections. Connect the 16/2 speaker wires to the
Volume Control screw terminals and mount it in its associated single gang electrical box or low voltage bracket.
m. The evōQ™ 3000 6.5” In-Ceiling Speakers have black and red push to insert style terminals. Connect the 16/2 speaker wires to
the speakers and mount the speakers in the pre-construction brackets.
Note: To insure the speakers are installed “in-phase” follow a standard wiring pattern such as “+” on the volume control goes to
the red terminal on the speaker over the wire with the label and “-“ on the volume control goes to the black terminal on the
speaker over the wire without the label. Wiring the speakers out of phase will decrease their sound output dramatically.
n.
The mouse portion of the IR emitter is attached to the IR window of the homeowner equipment with the supplied peel and stick
tape and it is then plugged into one of the three IR outputs on the appropriate Source Input. The IR Target is placed near the
homeowner equipment and plugged into the input jack on one of the Source Inputs. This allows the On-Q Universal Remote to
control the homeowner equipment.
o.
When all devices have been connected, plug the 24VDC cable into the Distribution Module and plug the 24VDC PW1060 power
supply into an available AC outlet.
PREMIUM MUSIC
SALES MAP
Key Presentation Phrases
“Improvements in technology mean that
you no longer need to fill your home
with black boxes to enjoy seriously
great sound.”
“Unlike speakers you could get from
Best Buy, evoQ speakers were
specifically designed to provide
maximum sound quality and reliability in
ceiling and wall mount applications”
MUSIC SOLUTIONS
Music solutions solve real world problems
Music solutions increase your enjoyment of any room in the
house without detracting from the beauty or function of your new
home.
Music solutions are so simple to control that you will use them
all the time for background ambience; and the sound quality is
good enough to please serious music listeners.
Music solutions are compatible with equipment you own, & play
loud enough to impress a teenager.
Music choices add value to your home & are flexible enough to
meet current and future needs.
LIFESTYLE MUSIC QUESTIONS
“evoQ speakers are loud enough to
impress a teenager & are designed to
work with almost any amplifier”
BASIC MUSIC provides 2 rooms of crystal-clear sound
delivered through evoQ 3000 speakers. One source of audio is
controlled in each location using the stylish lyriQ Keypad.
PREMIUM MUSIC provides an expanded music experience
from evoQ 3000 speakers and updated lyriQ Keypads in the
Studio Design in 4 rooms. Four Sources of audio will keep
everyone in the house happy. Includes 1 Local Source Input
used to override the main source and play a portable media
device. A whole house wireless remote is included.
ULTIMATE MUSIC provides an expanded music experience
from evoQ 3000 speakers and updated lyriQ Keypads in the
Studio Design in 4 rooms. Four Sources of audio will keep
everyone in the house happy. Includes 1 Local Source Input
used to override the main source and play a portable media
device. A whole house wireless remote is included.
Determine the need for music solutions
ANSWER HOMEBUYER CONCERNS
Tell me about your family. Kids ages? Do you enjoy the same
music?
The top homebuyer concerns for music solutions include sound
quality, compatibility with their current equipment, and system
cost versus DIY or pre-wire only options.
Tell me about your new home. Number of bedrooms? Pool or
patio?
Tell me about your lifestyle. Where in your home will you
entertain? Dining room, patio, or kitchen?
Do you own a music system? Have you considered how your
current system will fit your new home?
What sources do you use? Cd, iPod, internet music, or satellite
radio? How many Cds do you own?
PRESCRIBE APPROPRIATE SOLUTIONS
Music solution details
Demonstrate the sound quality to every client and attribute it to
the technology in evoQ speakers. Tell the On-Q/Legrand
speaker story and contrast it to generic or consumer products.
Point out the monthly cost of owning a multi-room music system
and the value it adds to their home’s resale price.
Point out the benefits of a matched system that is ready to enjoy
when they move in versus the hassles, dirt, and headaches of
cutting, wiring and trouble shooting in their beautiful new home.
ASSURE SATISFACTION
Map the speaker locations; go over functions of the lyriQ keypad
& remote controls.
Be available to answer homebuyer questions.
">
