0710175
08-06-08
Section 78
XM500 I/O Module
Features
• Adds I/O to J1939 Network
• Works with Standard J1939 Display Modules
• Wide Operating Temperature Range
• Industry Standard Deutsch Enclosure and
Connectors
• Custom Programming Available
The XM500 is a configurable Input / Output (I/O) module designed to bring analog input and digital input and output information onto the SAE J1939 Controller Area Network. Your application may require monitoring additional I/O information which may not be provided by the
OEM Engine or Transmission Electronic Control Unit (ECU), such as Fuel Level, Hydraulic Oil
Pressure, or a Low Engine Coolant Level switch. The XM500 is ideally suited to bring the additional information you need onto the J1939 CAN bus, and can be configured to broadcast fault codes and activate digital outputs per input conditions such as Fuel Level Low, Hydraulic
Oil Temperature High, etc. Because the XM500 broadcasts information using the J1939 standard protocol, the information can be displayed using standard J1939 display modules, such as the PowerView PV101.
In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time.
MURPHY and the Murphy logo are registered and/or common law trademarks of Murphy Industries, Inc. This document, including textual matter and illustrations, is copyright protected by Murphy Industries, Inc., with all rights reserved. (c) 2007 Murphy Industries, Inc.
Specifications
Power Input: 8 to 32 VDC
Operating Temperature: -40 to 85 °C (-40° to 185°F)
Digital Inputs: 4 – Ground or battery positive activation
Digital Outputs: 2 – Sinking (500 mA)
Thermocouple Input 1 : Type K
Analog Inputs 2 :
• 1 – battery supply voltage (dedicated)
• 7 – configurable as 0-5 VDC, 4-20 mA, or Murphy resistive sender 3
Communication Ports: CAN J1939
LED Indicators:
• PWR - Power On
• COP - Computer Operating Properly
• CAN - CANbus Active
Product Weight: 10 ounces
Shipping Weight: 12 ounces
Shipping Dimensions: 4” x 6” x 2”
Speed Sensing input: 2 to 120 VAC RMS from 30 to 10,000 Hz.
1
When the thermocouple input is used, only 5 resistive, 4-20 mA, or 0-5 VDC, can be used instead of 7.
2
Analog inputs can be exchanged for digital inputs (battery ground activation only), for a total of ten digital inputs.
3
Other resistive senders can be supported. Contact FW Murphy’s Industrial Panel Division for programming charges.
Dimensions
How to Order
Model: XM500
Contact FW Murphy’s Industrial Panel Division for your custom application. Minimum order quantities apply.
Phone: 918 317 4100
E-mail: [email protected]
Warranty - A limited warranty on materials and workmanship is given with this FW Murphy product. A copy of the warranty may be viewed or printed by going to www.fwmurphy.com/support/warranty.htm
