Nilfisk-Advance America SDV 4500 User's Manual

English

2

English

Contents

Components

Attachments

Symbols used to mark instructions.............................................4

Included Attachments.................................................................5

Accessories Included Accessories..................................................................6

Guidance Congratulations...........................................................................7

Getting the best results...............................................................7

Installation Assembly.....................................................................................8

Warnings.....................................................................................8

Operation Switching on the machine...........................................................9

Maintenance Daily............................................................................................11

Weekly........................................................................................11

Precautions Do’s & Don’ts..............................................................................11

Service Guarantee...................................................................................12

Technical Technical

Troubleshooting Symptom, possible cause & action.............................................14

Modified January 2010

3

English

Components

1. Cold Water Tank

6. Vacuum Hose Socket

7. Steam Hose Socket

10. Serial Number

Diagram A

Diagram B

4

11. On/Off Switch

12. Mode Switch

13. Heater On LED

14. Steam Ready LED

15. Cold Water Refill LED

16. Temperature Display LED

English

Attachments

These Parts were carefully packed at Nilfisk. Please check all accessories on receipt. If any parts are missing or damaged please contact the company in which you purchased this machine, within 7 days of purchase quoting your serial number on the back of the machine.

1. 2.5 Metre Steam, Detergent & Vacuum Hose

3. Floor Nozzle 300mm

5. Carpet Insert for Floor Nozzle

7. Clear Upholstery Tool

9. Nylon Details Brush x 5

11. Short Steam Lance

13. Suction Nozzle 150mm

15. Clip On Brush 150mm

17. Crevice Tool

2. Glass Washer

4. Squeegee Insert for Floor Nozzle

6. Brush Insert for Floor Nozzle

8. Extension Tubes x 2

10. Brass Details Brush x 5

12. Long Steam Lance

14. Clip on Squeegee 150mm

16. Accessory Service Kit

1.

2.

Diagram C

7.

8.

12.

13.

14.

9.

3.

15..

10.

4.

16.

5.

11.

6.

17.

Also available is Stainless Steel detail brushes (Packs of 10)

5

English

Accessories

These Parts were carefully packed at Nilfisk. You will find these items in your box with all the attachments. Please check all accessories on receipt. If any parts are missing or damaged please contact the company in which you purchased this machine, within 7 days of purchase quoting your serial number on the back of the machine.

Diagram D

• Plastic Wing Nuts x 4

• Castor with Brake x2

6

English

Guidance

Congratulations

………………………………………………...

We would like to take this opportunity to thank you for your purchase of the Nilfisk combined steam, detergent and vacuum cleaner.

The SDV4500 is manufactured in the EU to the highest quality Standards

This instruction manual contains all of the necessary information to operate and maintain this machine. Please read this instruction manual carefully before you start using or carrying out any maintenance on the machine.

If you use this machine correctly as stated in this instruction manual this machine will fulfil all your steam cleaning needs.

• This machine is intended for use in a commercial cleaning environment. If you do not follow the instructions contained in this manual, situations may arise which may be dangerous or harmful to the machine or the person operating the machine. Read this manual carefully so that you know when such situations can arise.

• Ensure that all operators of this machine are fully trained on how it works.

• Report any problems or damage to the machine immediately to the supplier or a Nilfisk approved supplier for this product. Do not operate the machine until the problem or damage has been resolved.

Getting the Best Results

………………………………………………...

• Operate the machine in accordance with the instruction manual

• Maintain the machine in accordance with instruction manual tank which have been approved by Nilfisk

• Use only parts supplied by Nilfisk approved distributors

• Use only detergents and cleaning products in the solution

Keep this manual in a safe place for future reference and ordering of spare parts

7

English

Installation

• Lift the machine out of the box.

• Carefully place the machine on its side in order to assemble the wheels securely.

!! A flat surface is required which will not scratch or damage the surfaces of the machine.

• Diagram D – Back wheel assembly. Using a 10 mm spanner remove the bolts from the machine and place the assembly into place towards the back of the machine. Tighten the bolts securely ensuring no movement on the brackets.

• Diagram D – Casters with Brake x 2. Remove bolts from the machine and position into place towards front of the machine. Tighten securely ensuring no movement on the brackets.

• Once all the wheels are fully assembled, resume the machine to its upright position.

• Place Tubular Handle (Diagram D) in position on the back of the machine and secure using the 4 x Plastic Wing Nuts (Diagram D).

!! Do not screw them all the way in at this point.

• Place Wire Basket (Diagram D) over the Wing Nuts and tighten up to secure.

• Check all accessories are present in the box as shown in Diagram C & D.

Warnings

………………………………………………...

This machine has been designed with your safety in mind, however it is important that you observe the following points for safe operation during the operating procedure

• This is an electrical product – Do not use in wet weather or allow the machine to get wet.

• Do not discharge steam towards people, danger of scolding. Or towards equipment containing electrical components

• Never allow children to play with this appliance.

• Do not use the machine for other purposes that it was built for.

• Please remember that the steam cleaner operates at temperatures in excess of 170°C. Never use it on objects, which cannot resist the temperature (delicate materials, fabrics, plastics, wood etc).

Where any doubt exists check carefully on a part of the material where minor marks will not matter.

• Do not operate the machine or carry out any maintenance out on it

ƒ Unless you are trained and authorised to do so

ƒ Unless you have read and thoroughly understand this instruction manual.

8

English

Operating Procedure

………………………………………………...

1. Switch mode switch (Number 12 Diagram B) to position 11.

• This will switch on the boiler elements and will enable you to use the handle controls on the hose once connected.

2. Fill the cold water tank (Number 1 Diagram A) with clean cold water only.

!! Anything other than clean cold water used in the

water tank will void the manufacturers warranty.

3. Fill the detergent tank (Number 2 Diagram A) with Nilfisk approved detergent.

!! Unapproved detergent may be harmful or dangerous to the machine or the operator using the machine. This may cause irrepairable damage to seals and will void the manufacturers warranty.

4. Connect the Vacuum Hose to the front of the machine (Number 6 Diagram A) ensuring it locks into position. To release the vacuum hose from the socket slide the red button upwards at the same time as pulling the hose out.

!! If the Hose becomes damaged the complete hose must be replaced. Do not attempt this task yourself, contact a Nilfisk approved supplier for replacement.

5. Connect the Steam Hose to the front of the machine (Number 7 Diagram A) ensuring it is pushed in all the way and the pin on the flap locks into the hole on the hose.

!! Grease “O” rings on steam pin before connecting.

!! To release the steam hose, lift the flap and pull.

6. Plug the power cable into a 240 Volt supply.

!! Inspect the electric cable before every use. If the cable becomes damaged at anytime the complete cable must be replaced by a Nilfisk approved distributor.

!! Never touch the power cable or plug with wet hands

!! Always unplug the machine when i. The machine is not in use ii. Cleaning the machine iii. Any maintenance work is being carried out

(Number 13 Diagram B) will illuminate.

9. Allow approximately 5 minutes for the boiler to heat the water

10. When the Steam Ready LED (Number 14 Diagram B) illuminates the machine is ready to be used.

9

English

Operating Procedure cont….

………………………………………………...

11. The handle controls are now active.

• The red trigger on the hose handle will release steam when pressed.

• The red button on the side of the handle will lock the steam trigger in the off position.

• Pressing the left hand switch on top of the handle will activate the vacuum.

• Pressing the right hand momentary switch located on the top of the handle will activate the detergent pump. Hold the switch as long as you need to dispense the detergent. Releasing the switch will stop the detergent supply.

12. The steam output can be adjusted by the steam control knob (Number 3 Diagram A)

13. Choose and fit the required accessory (Diagram C) to the hose handle. Lock the accessory in place by turning the accessory locking clip.

!! When changing accessories during use please note these will be hot.

During Use

………………………………………………...

Cold Water Tank Empty(Number 1 Diagram A)

1. Refill the cold water tank when the refill cold water LED (Number 15 Diagram B) is illuminated.

A buzzer will sound and the steam will no longer come out of the nozzle when the steam switch on the handle is pressed.

2. Always empty the collection tank each time the cold-water tank is refilled.

3. The pumps will not work when the cold-water tank is empty.

4. Once the cold water refill LED is illuminated the boiler heater will remain on for 30 minutes. If the cold-water tank is not refilled within 30 minutes and the machine is left powered on the boiler heater will switch off.

Detergent Tank Empty (Diagram A)

1. If the detergent does not come out of the nozzle when the detergent switch on the handle is pressed, refill the detergent tank (Diagram A)

Collection Tank Full (Number 4 Diagram A)

1. Always empty the collection tank each time the cold-water tank is refilled

2. The pitch of the motor noise changes and there is no suction at the nozzle

3. Switch off the machine, empty the collection tank and rinse clean

10

English

Maintenance

Warning: Disconnect the machine from the mains before cleaning or carrying out any maintenance work.

Daily Maintenance

………………………………………………...

To be carried out every day or every 8 hours of operation.

1. Grease “O” rings on the steam pin in the steam hose.

2. Wash the hose by sucking one or two litres of water from a basin into the collection tank.

3. Empty the collection tank, rinse and wipe down.

4. Remove the foam filter, wash in water and re fit.

• Take care not to damage the filter mesh. If it becomes torn do not use the machine and replace damaged parts immediately.

5. Rinse detergent bottle with clean water.

6. Wipe down the body of the machine with a clean damp cloth

7. Always wash the accessories in hot soapy water

DO NOT IMMERSE THE MACHINE OR HOSE IN WATER

8. Wrap the power cable around the handle before storage.

Weekly Maintenance

………………………………………………...

To be carried out every week or every 50 hours of operation.

As for daily maintenance plus the following:

1. Inspect the power cable for any signs of damage. If damaged do not repair, contact the supplier of this product. Do not use until repaired.

2. Inspect the hose assembly for any signs of damage. If damaged do not repair, contact the supplier of this product. Do not use until repaired.

3. Inspect castors to ensure all securing bolts are fully tightened.

Safety Precautions

………………………………………………...

DO

This machine is to be used by trained operatives only

• Check the cable and plug are safe and intact before plugging the machine in.

• Place cleaning in progress signs where necessary

• Point the steam nozzle away from your body during use

• Empty and clean machine after each use

DON’T

• Use the machine near people, children or animals

• Point steam at electrical apparatus

• Use the machine to clean the machine down

• Do not use on Velvet, satin or leather

• Leave the machine unattended

11

English

Service & Guarantee

If you require a service or advice on using or maintaining your machine please contact your Nilfisk approved distributor.

Nilfisk guarantees that if within 12 months from the date of purchase this appliance, or any parts thereof, is proved to be defective by reason of faulty workmanship or materials, we will at our option repair or replace the same free of charge for labour and materials, provided that:

• The appliance has been installed and used in accordance with our operating and servicing instructions.

• If the appliance has been serviced, maintained, repaired, modified taken apart or tampered with by any person not authorised by us, then we will not be liable under this guarantee for any fault arising from their defective workmanship.

• We shall not be liable under this guarantee for any fault in the appliance arising from the use of spare parts not supplied and recommended by us.

• Excluded from this guarantee are parts that need replacement due to normal wear and tear such as hoses, nozzles and accessories.

12

English

Technical

Technical Information

………………………………………………...

Boiler

Wattage: 1950W

Continuous Fill

Steam Pressure

Steam at source:

Vacuum

Yes

4.5 Bar

135

°C >

Electrical

Voltage 230V ~ single phase

Low Voltage Controls 5V

Cord length 10m

Capacities

Cold Water Tank

Collection Tank

Detergent Tank

2.5 Litres (easy fill)

12 Litres

2.5 Litres (easy fill)

13

No power

No steam

English

Trouble Shooting

Not connected / Faulty socket

On / Off switch not on

Fuse blown

Steam Control turned down fully clockwise

Steamer not ready

Clean water tank is low (beeping sound& "refill" light is lit)

Action

Check connection to wall socket and socket switch. Try in another wall socket

Press On / Off switch which will illuminate when on

Replace fuse with approved 13A fuse

Turn the control to half way

Wait for the “Ready to steam” light to illuminate

Pour water into the clean water tank until the beeper stops. The steam handle will work again.

No steam, Just water

Steam Leaking from front socket

Vacuum power low

No detergent

Steamer not ready

Boiler at pressure and not heating(temperature less than 110ºC)

Wait for the "Ready to steam " light to illuminate

Hold the steam switch on for approximately one minute, ever if just water is coming out. This will result in the heater coming back on

“O” Rings split

“O” rings worn

Vacuum operation has been selected on the machine

High pitch motor noise

Change and re grease “O” Rings. To avoid this happening ensure “o” rings are grease before every use.

Change and re grease “O” Rings. To avoid this happening ensure “o” rings are grease before every use.

Operate any of the handle controls, which will reset the motor power to full.

Continue vacuuming

Switch the machine off and empty the collection tank. Refill the collection tank with clean water to the mark and recommence work.

Solution tank empty Pour cleaning solution diluted in accordance with the manufacturers instructions into the solution tank.

14