- Industrial & lab equipment
- Electrical equipment & supplies
- Circuit protection
- Surge protectors
- Panamax
- POWER-PRO INS00809
- Installation instructions
advertisement
PANAMAX MIW-POWER-PRO INSTALLATION INSTRUCTIONS
CAUTION:
Only for use with 15 Amp circuits utilizing a minimum of 14 AWG.
Make sure the circuit is not live before installation. If you are unsure how to perform this task, please contact an electrician.
STEP 1:
Select a location close to the equipment. In the case of a flat panel display, the recommended location is one that is behind the device and hidden from view once the Plasma TV is mounted. Cut a 4” wide by 3 3/4” high hole in the wall for the outlet box.
STEP 2:
Run the building wire (e.g. Romex) through a rear opening in the outlet box (not included). No more than 1” of wire sheath should extend into the outlet box. 3” of wire should be able to extend beyond the opening of the outlet box. Install the outlet box in the hole.
(Outlet boxes not included)
STEP 3:
Strip building wire. Using the included wire nuts, first connect the ground wires - green insulated on the MlW-Power and bare copper on the building wire. Then connect the neutral wires
(white), then the hot wires (black).
STEP 4:
Neatly fold the AC wires as you install the Max In-Wall in the outlet box and secure with the included screws.
STEP 5:
Turn the power on to the circuit. The blue Power indicator should light up, indicating the outlet is ready for use.
NOTES:
In the event of a hazardous voltage situation, the red Unsafe
Voltage indicator will blink until the voltage returns to a safe level.
Signal Protection Module Usage:
Panamax In-Wall signal protection modules (sold separately), while not necessary for surge protection in the Max In-Wall
Power-Pro, may be used to provide a clean looking interface for the signal lines. When used in the proper manner the modules also provide total protection to the connected equipment.
INS00809 REV B 06/07 1
MIW-POWER-PRO SPECIFICATIONS
AC Circuit Power Outlet Faceplate
AC Outlets, Total: ..................................................2
Line Voltage: .....................................120V, 50/60Hz
Total Current Capacity: .....................................15A
UL 1449 Suppression Rating: ........................330 V
AC Connectors: ............................2 NEMA 5-15
Noise Filtration: ......................................Level 1
Signal Line Protection: Not Included / Modules
Sold
Separately
Protection Modes: .............................L-N, L-G, N-G
Energy Dissipation: ................................546 Joules
Peak Impulse Current: ...............................32,500A
Catastrophic Surge Circuit: ...............................Yes
Thermal Fusing: ................................................Yes
Over-voltage shutoff: ....................142VAC ± 5VAC
Specifications are subject to changes due to product upgrades and improvements.
CONTENTS CONTACTING PANAMAX
One MAX In-Wall power outlet enclosure
LINE FAULT
POWER ON
Panamax
1690 Corporate Circle
Petaluma, CA 94954
Phone - 707-283-5900 or 800-472-5555
Fax - 707-283-5901
Web - www.panamax.com
Customer Relations
7:30 AM – 4:30 PM, M-F Pacific Time
Email - [email protected]
Included Installation Accessories:
(3) Wire Nuts
(4) Mounting Screws
2
advertisement
Related manuals
advertisement