Sanyo RP-6165F Instruction manual

 "AM/FM Portable Radio '
INSTRUCTION MANUAL > | SANYO
RP-6165F
SPECIFICATIONS
RADIO SECTION power qui |
Tuning range: " ower ouiput:
FM: 87.5 ~108MHz 400 mW (DC max)
AM: .526.5—1606.5kHz Speaker:
Aerials: т pommes, A ohms
Built-in ferrite bar and telescopic erminal. |
rod aerial | р EAR: 8 ohms (not supplied)
Power source:
AC: 230V~240V 50Hz
DC: 4.5V (3 “R20/D” size batteries)
Dimensions: |
228X143X75mm{WXHXD)
Weight:
Approx. 800g (without batteries)
Specifications subject to change without
notice.
1ADGP1.P1916-- | О
(AU) SANYO Electric'Co., Ltd. made in CHINA
Fig. 1
Fig. 3
Fig. 2
dedireereges
ig HA
Meir
‘роде mm amy
[Add
12525,
HE
я mr
Fig. 4
FOR SAFE AND EFFICIENT OPERATION
Do not damage the mains lead.
Do not take the unit apart.
Do not insert pins, etc., Inside the unit.
When not in use, disconnect the mains lead from the outlet. Grasp the plug, not
the lead when disconnecting the unit.
Do not drop the unit or subject it to strong shocks.
Doing so could result in damage.
If water should enter the unit, electrical shock or a malfunction may result. Use in
an area where there is low humidity and little dust.
Do not use the unit areas where extremes in temperature occur (below 5" C or
exceeding 35° C), or where it may be exposed to direct sunlight.
Keep the unit away from heating appliances and electric sources that could
cause static on the radio such as fluorescent lamps and motors.
The apparatus shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as vases, shall be placed on the apparatus.
Do not install this equipment in a confined space, such as a book case or builtin
cabinet.
CONTROLS (Fig.1)
O 09 1 E Сл Js HN =>
. Telescopic aerial
. TUNING control (TUNING)
. Volume control (VOLUME)
. Earphone socket (EAR)
. Band switch (BAND SELECTOR)
. Tuning indicator (TUNING)
. Speaker
. AC input socket (AC INPUT)
. Battery compartment lid.
POWER SUPPLY
AC POWER OPERATION
Connect one end of the mains lead to the AC INPUT socket and the other end to
An AC outlet (Fig.2)
THE UNIT IS NOT DISCONNECTED FROM THE MAINS UNLESS IT IS UNPLUGGED
FROM THE AC OUTLET.
BATTERY POWER OPERATION (Fig.3)
5
3.
Open the battery compartment lid.
. Install 3 “R20/D” size batteries (not supplied). Refer to the polarity diagram on
the back of the unit. Match the (+) and {(-) marks on the diagram to the (+) and (-)
marks on the batteries.
Replace the lid.
CAUTION
WHEN INSTALLING BATTERIES
To prevent battery electrolyte leakage, which may result in injury and damage to
the unit or other objects, observe the following precautions: |
1. Ali batteries must be installed with the proper polarity ( see diagram on the
back of the unit).
2. Do not mix new with old or used batteries.
3. Only use batteries of the same type and brand.
4. Remove the batteries when they are not be used for a long period of time.
RADIO OPERATION
1. Setthe BAND switch to the desired band.
2. Turn on the radio by turning the VOLUME control upward until a ‘click’ sound is
.. heard. ;
3. Turnina desired station by turning the TUNING control. The TUNING indicator
will light when a station is accurately tuned in.
4. Adjust the VOLUME control to your desired sound level.
5. For private listening, connect the earphone to the earphone socket (EAR)
6. To turn off the radio, tune the VOLUME control downward until a ‘click’ sound is
heard.
Aerials(Fig. 4)
For FM recention, pull out the telescopic aerial and detemine the direction, length
and angle for optimum reception.
For AM reception, the aerial inside the unit is somewhat directional, and so
reception from distant station may sometimes be improved by rotating the unit.
MAINTENANCE
CLEANING THE CABINET
Use a clean soft cloth moistened with plain lukewarm water and wrung dry. Never
use benzol or other strong chemical cleaners since these could damage the finish
of your unit.
It is.importanct that no liquid reaches the inside ofthe unit.