Xantech Computer Keyboard 598-00 Installation instructions

INSTALLATION INSTRUCTIONS

598-00

EIGHT BUTTON DRY CONTACT KEYPAD

• The 598 is an eight button, momentary, dry contact keypad. It is normally used in conjunction with the

Xantech 590 Programmable Controller as shown in the illustration below.

• Requires 9-conductor cable, as shown. Use 24 gauge, stranded or solid wire, up to lengths of 5000'.

• Two 598's may be used to provide momentary switch closures for all 16 of the 590 input terminals.

• Two or more 598's may also be wired in parallel to the same terminals on the 590 where control from more than one room or area is required.

• The 598 fits into a standard single-gang J-box. 598's may also be used side-by-side in two (or more) gang

J-boxes.

• A legend cutout sheet (included) contains typical component function command icons for button identification.

5-14-99

5

6

3

4

C

1

2

7

8

Model 598

Key Pad

(rear view)

+12V DC

Wire size typically AWG 20-24

Model 590

(rear panel)

+

RES DEL SEQ PGM

ON

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 O G

12VDC

– +

1 2 3 4

BANK

12VDC

–

Ground or " – return wires.

"

White Striped

Side (output)

Emitter, Connecting Block, etc.



786-00

Power

Supply

To 120 V AC

Unswitched

1