VHX-88C-PU

VHX-88C-PU
Dakota Digital VHX Instrument Installation
For 1988-94 Chevrolet/GMC Full-Size Pickup
Your new VHX-88C-PU kit includes:
VHX Display
Cut Template
and Cut Guard
Universal Sender Pack
Installation Manuals
Switch Harness
Control Box
CAT5 Cable
Alternator Load Harness
(Used with 3 wire alternators)
Manual # 650451A
Installation
1. The first step is to remove
the stock gauge cluster
from the dash.
1a.
1b.
1c.
Remove the plastic cover under the
steering column to access the
mounts, drop the column by
removing the two bolts shown in
picture, also slide the gear indicator
clip off the column.
The front plastic face needs to be removed, this is done by removing the (4) four Torx T20
screws and disconnecting the headlight and dimmer connectors.
By removing the vent tube on the left and the heater and stereo controls on the right, you will
have better access to remove the (4) four screws securing the cluster. Finally, remove the
gauge cluster and disconnect the harness.
Manual # 650451A
2. At your own discretion, use the supplied aluminum template\cut guard to open up the inner structure
to allow more length on the harness side for the required cut and splice wiring. Also, the harness
connector will need to be pushed back to clear the VHX cluster; opening up the inner structure will
allow space needed for it to clear otherwise, the connector will need to be removed.
Remove the connector clip
Outline cut template
Use locking pliers to hold the cut
guard into place to protect the
harness from damage while
cutting the inner structure
3. Attach the provided CAT5 Cable and the 3 Pin Switch Harness to the back of the VHX display.
Carefully route the other ends to the control box mounting location. Use the diagram below for
the wiring instructions of SW1 and SW2.
Manual # 650451A
SW1 and SW2 Connection:
This system comes with two switches located
ORANGE (switch 1)
directly in the assembly to allow a convenient and
GREEN (switch 2)
easily accessible location for the control switches.
BLUE not connected
To use these switches, the included switch
harness (pictured at right) is plugged into the back of the assembly and the wires are connected to the VHX
control box as follows:
Connect the ORANGE wire to SW1(-) on terminal on VHX control box.
Connect the GREEN wire to SW2(-) terminal on VHX control box.
Leave the BLUE wire unconnected.
4. Refer to the main manual for wiring instructions and re-install the cluster in reverse order using
all stock hardware to complete the VHX installation.
5. Stock 3-Wire alternators will need an additional wiring connection at the gauge cluster connecter.
You will need to add resistance from the Pink/Black wire in the A10 location to the Brown wire in
the A3 location. The range needed is 500-30 ohms, three 1/4W 1K resistors in parallel will be in
range at 333 ohms. The provided alternator load harness can be used to achieve this.
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
Manual # 650451A