HomeSelects | 6219 | Instructions / Assembly | HomeSelects 6219 Instructions / Assembly
KEEP your receipt and these Instructions for Proof of Purchase.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of t w o (2) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at
the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse,
accident, modifications, alterations, neglect or mishandling. This warranty shall not apply to any product
that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not
warrant and specially disclaims any warranty, whether expressed or implied, of fitness for a
particular purpose, other than the warranty contained herein. The manufacturer specifically
disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair of said
2. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft
cloth to dust and wipe carefully.
1. To clean the outside of the lamp, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the surface of the fixture. DO NOT CLEAN THE LED CHIPS!
Page 1
Model 6219
T-8 Vapor Tight Light
Accessories included
Mount the metal clips to the surface where light is to be placed.
The mounting clips should be spaced 31” apart
Snap the fixture into the clips making sure it is secure
Never drill through fixture to mount. This will compromise the
water tight feature and could cause damage to the fixture.
4 Mounting the fixture
Assemble the light fixture using the clips.
Make sure the acrylic diffuser is seated correctly for a tight fit.
Install the T-8 fluorescent tubes carefully (tubes not included).
3 Assembly of light fixture
Connect the black supply wire to the black fixture wire.
Connect the white supply wire to the white fixture wire.
Connect the ground supply wire to the ground fixture wire.
2 Connecting the wires
Remove the metal fixture pan from the base housing
by pinching together the retainer clips.
Install the retainer clips by snapping them into the
base housing.
1 Assembly of the light fixture
CAUTION: To prevent electric shock, do not insert
any objects through openings.
WARNING: Installation must be performed by a
qualified licensed electrician.
DANGER: Before installation, turn off the main
power at the circuit breaker.
Assembly and safety instructions
WHITE Fixture Wire
BLACK Fixture Wire
BLACK Supply Wire
WHITE Supply Wire
GROUND Supply Wire
Install the T-8 fluorescent tubes
Thank you for purchasing this Vapor Tight Light. For more information
please e-mail us at
GROUND Fixture Wire
Wiring diagram
Install the diffuser retainer clips
Pinch the mounting clips to remove
and replace the light frame
(Mounting hole locations)
#6219 Fluorescent T-8 Light
T-8 Vapor Tight Light
Download PDF