Actiontec HPE400AVP Quick Start Manual

Step 1

Get the MegaPlug AV

200 Mbps Powerline Ethernet

Network Adapter from the box.

Step

2

Get one Ethernet Cable.

Step

3

Plug one end of the

Ethernet Cable into the Ethernet

Port on the bottom of the

MegaPlug Adapter.

Note: An Ethernet port looks similar to a phone port but is slightly larger.

Questions? Call 1-888-436-0657 (USA)

Step 4

Plug the MegaPlug

Adapter into a Power Outlet.

Do NOT plug the Adapter into a power strip or wall outlet that uses surge protection as the Adapter may not work.

Step

5

Plug the other end of the

Ethernet Cable into an OPEN

Ethernet Port on your Broadband

Modem or Router.

Broadband

Router

Step

6

Get the MegaPlug AV

200 Mbps 4-Port Switch from the box. You will connect the 4 Port

Switch to the device(s) that you want to have Internet access.

Step 7

Get the Black Power

Cord.

Questions? Call 1-888-436-0657 (USA)

Step 8

Plug one end of the

Power Cord into the back of the

MegaPlug 4-Port Switch.

Step

9

Plug the other end into a

Power Outlet.

Do NOT plug the Switch into a power strip or wall outlet that uses surge protection as the Switch may not work.

Step 10

Get the other

Ethernet Cable.

Flip this Quick Start Guide over to continue

NEXT

Part No: 0530-0602-000

Questions? Call 1-888-436-0657 (USA)

QS1024/0309

Step 11

Plug one end of the

Ethernet Cable into an Ethernet

Port on the back of the

MegaPlug 4-Port Switch.

Step

12

Plug the other end of the Ethernet Cable into the device that you want to connect to the Internet.

Note: You can repeat Steps 10 thru 12 for each device that needs to be connected to the Internet.

Step 13

Check the LEDs and make sure both Link Lights turn

SOLID GREEN .

Note: This Quick Start Guide shows you how to install the 4-Port Switch in a location apart from your router/gateway (another room for example). If you need additional Ethernet ports near the router/gateway, you can reverse the installation order of the Powerline units (i.e., install the 4-Port Switch first, then install the

MegaPlug Adapter in another room).

Congratulations!

You have successfully installed the MegaPlug AV Powerline Ethernet

Network Adapter and 4-Port Switch.

These adapters ship with a generic encryption key. If you would like to change the key, go to www.actiontec.com/howto for further instructions. If you require additional adapters for additonal computers/devices, they may be added by following the same steps in this guide.

Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA)

Model# HPE200AVP,

HPE400AVP

Quick Start Guide

This Quick Start Guide will walk you through the easy steps to install your MegaPlug™ AV Powerline Ethernet Kit.

You will need the following items:

• One MegaPlug™ AV 200 Mbps

Powerline Ethernet Network Adapter

• One MegaPlug™ AV 200 Mbps

4-Port Switch

• Two Ethernet Cables

• One Black Power Cord

NEXT