Model #: SMX5000XLRT3U

Tripp Lite
1111 West 35th Street
Chicago, IL 60609 USA
Telephone: +(773) 869 1234
E-mail: [email protected]
Model #: SMX5000XLRT3U
SmartPro 5kVA Line Interactive Sine Wave UPS, Extended-run & SNMPWEBCARD options, 3U Rack/Tower,
USB, Serial, EPO, 230V
Highlights
5kVA / 5000VA line interactive 3U rack/tower UPS; Sine wave output
230V nominal output during brownouts to 170V and overvoltages to 282V
USB, Serial, EPO & optional SNMP/Web card monitoring options
3U all-in-one chassis; 98% efficiency
Hardwire input; 8 C13 & 3 C19 outlets
Description
5000VA line interactive UPS system for server, network and telecommunications equipment. 5kVA UPS with internal batteries installs in only 3 rack
spaces with a depth of only 635mm / 25 inches. High 98% line-power efficiency rating reduces energy consumption and BTU heat output.
Expandable battery runtime with optional BP48V24-2U and BP48V60RT-3U external battery packs. Uninterruptible Power Supply (UPS) switches to
battery-derived AC output during power failures and extreme voltage variations. Line interactive Automatic Voltage Regulation (AVR) offers voltage
boost during brownouts and voltage reduction during overvoltage conditions to maintain regulated 230v output over an input range of 170-282V.
Supports hardwire input. Includes C19 and C13 output receptacles. Network-grade AC surge and noise suppression. Network management
interfaces support communications via USB, DB9 serial and SNMPWEBCARD slot. Supports simultaneous detailed monitoring of equipment load
levels, self-test data and utility power conditions via all 3 network interfaces at once. Includes PowerAlert monitoring software and complete cabling.
Emergency Power Off (EPO) interface. 3-stage metered current monitoring and battery charge status LEDs. Utility power and voltage regulation
LEDs. Audible alarm. Self-test. 4-post rackmount installation accessories included; 2-9USTAND tower kit and 2POSTRMKITWM two post rack
mounting accessories available. Field-replaceable, hot-swappable internal batteries and external battery packs.
Package Includes
SMX5000XLRT3U UPS system
PowerAlert Software and Cabling
Mounting hardware for 4 post rackmount installation
Warranty information
Instruction manual
Features
5000VA/3750 watt max. output power capacity compatible with International 230V input voltage
3U rack/tower UPS installs in standard 19 inch rack enclosures with an installed depth of only 635mm / 25in
Protects sensitive networking equipment from blackouts, voltage fluctuations and transient surges
Line Interactive Automatic Voltage Regulation (AVR) corrects 230V nominal input from 170 to 282VAC to usable 230V levels without
consuming battery power
AVR circuits boost undervoltages from 170 to 199V by 12% and reduce overvoltages from 245 to 282V by 12%
Network interfaces support simultaneous communications via USB, DB9 serial or contact closure and SNMPWEBCARD slot
Included PowerAlert UPS monitoring software supports safe unattended shutdown, monitoring and control via local connected servers, plus
any number of additional servers over IP
Communications ports support on-battery, low-battery, power-restored, AC-voltage, DC-voltage, output current monitoring, battery charge
current, battery capacity, internal UPS temperature, AC line frequency, timed inverter shutoff and activate self-test
Built-in Emergency Power Off (EPO) interface with cable
Sine wave output in AC and battery mode
Expandable runtime with optional BP48V60RT3U external battery packs
Expandable runtime with optional BP48V60RT3U external battery packs
Half/full load runtime of 27/10 minutes with internal batteries
Includes 11 output receptacles (3 C19/8 C13)
Hardwire input AC connection
3 stage metered LEDs offer current monitoring and battery charge level
Mains power and voltage regulation LEDs offer at-a-glance power status information
Front panel switches support self-test and alarm cancel functions
Included adjustable mounting rails support installation in 4 post 19 inch racks
Supports 2 post rackmount installation with optional 2POSTRMKIT accessory
Supports upright tower placement with optional 2-9USTAND accessory
CE, GOST, SASO listed
Specifications
OUTPUT
Output Volt Amp Capacity
(VA)
5000
Output kVA capacity (kVA)
5
Output Watt Capacity
(watts)
3750
Output kW capacity
3.75
Output power factor
0.75
Nominal Output Voltage(s)
Supported
220V; 230V; 240V
Nominal Voltage details
230v nominal inverter output voltage
Frequency compatibility
50 / 60 Hz
Output voltage regulation
(line mode)
-17%, +8%
Output voltage regulation
(Battery mode)
+/- 5%
Built-in UPS output
receptacles
8 C13 outlet(s); 3 C19 outlet(s)
Included output power
cables
Includes 3 C13 to C14 output power cables
Output circuit breaker
15A (x3) breaker supports 1 C19 outlet each, 10A (x2) breaker supports 4 C13 outlets each
Output AC waveform (AC
mode)
Sine wave
Output AC waveform
(battery mode)
Pure Sine wave
INPUT
Rated input current (at
maximum load)
27A
Nominal Input Voltage(s)
Supported
230V AC
UPS input connection type
Hardwire
BATTERY
Full load runtime (minutes)
8.5 min. (3750w)
Half load runtime (minutes)
20 min. (1875w)
Expandable battery runtime
Extended runtime supported via optional external battery packs
External battery pack
compatibility
BP48V60RT-3U (multi-pack compatible)
DC system voltage (VDC)
48
Battery recharge rate
(included batteries)
Less than 4 hours from 10% to 90%
Replacement battery
cartridge (internal UPS
battery replacement)
RBC94-3U (quantity 3)
Battery Access
Front panel battery access door
Battery replacement
description
Hot-swappable, user replaceable batteries
VOLTAGE REGULATION
Voltage regulation
description
Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 170 to 282
Overvoltage correction
Input voltages between 245 and 282 are reduced by 12%
Undervoltage correction
Input voltages between 170 and 199 are boosted by 12%
LEDS ALARMS & SWITCHES
LED Indicators
5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status
Alarms
Audible alarm indicates power-failure, overload and low-battery conditions
Alarm cancel operation
Power-fail alarm can be silenced using alarm-cancel switch; once silenced, alarm will re-sound to indicate
low-battery status
Switches
2 Switches control off/on power status and alarm-cancel/self-test operation
SURGE / NOISE SUPPRESSION
UPS AC suppression joule
rating
480
UPS AC suppression
response time
Instantaneous
EMI / RFI AC noise
suppression
Yes
PHYSICAL
Installation form factors
supported with optional
accessories
2 post rackmount (2POSTRMKITWM); Tower (2-9USTAND)
Primary form factor
Rackmount
UPS / Power Module
dimensions in primary form
factor (height x width x
depth / inches)
5.2 x 17.5 x 25
UPS / Power Module
dimensions in primary form
factor (height x width x
depth / cm)
13.3 x 44.4 x 63.5
Rack Height
3U
Secondary form factor
Tower (requires 2-9USTAND)
UPS / Power Module weight
(lbs)
143
UPS / Power Module weight
(kg)
64.9
UPS Shipping dimensions
(height x width x depth /
inches)
11.3 x 23 x 31.5
UPS Shipping dimensions
(height x width x depth / cm)
28.6 x 58.4 x 80
Shipping weight (lbs)
182
Shipping weight (kg)
82.6
Cooling method
Fans
UPS housing material
Steel
ENVIRONMENTAL
Operating Temperature
Range
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range
+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity
0 to 95%, non-condensing
AC mode BTU / hr. (full
load)
271
COMMUNICATIONS
Communications interface
USB; DB9 Serial; EPO (emergency power off); Slot for SNMP/Web interface
Network monitoring port
description
Supports detailed monitoring of UPS and site power conditions
PowerAlert software
Included
Communications cable
USB and DB9 cabling included
WatchDog compatibility
Supports Watchdog application, OS and hard-reboot restart options for remote applications
LINE / BATTERY TRANSFER
Transfer time
2-4 milliseconds
Low voltage transfer to
battery power (setpoint)
170
High voltage transfer to
battery power (setpoint)
282
SPECIAL FEATURES
Grounding lug
Back panel grounding lug
Cold Start (startup in
battery mode during a
power failure)
Cold-start operation supported
High availability UPS
features
Hot swappable batteries
Green & high efficiency
features
Greater than 95% efficiency - GREEN UPS
CERTIFICATIONS
UPS Certifications
CE
UPS Certification details
Class A (EMI)
WARRANTY
Product Warranty Period
(International)
2-year limited warranty
Product Warranty Period
(Mexico)
2-year limited warranty
Product Warranty Period
(Puerto Rico)
2-year limited warranty
Related Items
Optional Products
Related Model
Description
Qty.
PDU12IEC
Basic PDU / Power Distribution Unit - Safe, reliable power distribution for critical
networking equipment
1
SNMPWEBCARD
For remote monitoring and control via SNMP, Web, or Telnet.
1
ENVIROSENSE
Monitors temperature, humidity and contact-closure inputs. (Requires SNMPWEBCARD
or switched PDU.)
1
U022-010
10-ft. USB2.0 A/B Gold Device Cable
(A Male to B Male)
1
DNET1
Network Surge Suppressor - Essential protection for data and communication lines
1
DTEL2
Network Surge Suppressor - Essential protection for data and communication lines
1
DCATV
Network Surge Suppressor - Essential protection for TV/VCR coaxial lines
1
BP48V60RT-3U
External Battery Pack and Cable. 3U, Expandable, Blue 2-Point Connector
1
2-9USTAND
Enables Tower Placement of Rackmount UPS Systems
1
MODBUSCARD
For remote monitoring and control via MODBUS protocol
1
2POSTRMKITHD
Enables 2-Post Rackmount Installation of 3U and Larger UPS, Transformer and Battery
Pack Components
1
More information, including related products, owner's manuals, and additional technical specifications, can be found online at
www.tripplite.com/en/products/model.cfm?txtModelID=3036.
Copyright © 2013 Tripp Lite. All rights reserved. All trademarks are the sole property of their respective owners. Tripp Lite has a policy of continuous
improvement. Specifications are subject to change without notice. Photos may differ slightly from final products.