advertisement
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
Instruction No Version
© Volvo Car Corporation Carrier bag holder- 30664341 - V1.0
Side 1 / 7
Equipment
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
A0000162
M8902050
© Volvo Car Corporation Carrier bag holder- 30664341 - V1.0
Side 2 / 7
1
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
INTRODUCTION
Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.
The new floor hatch has two decals with instructions on how to use the jack for two wheel or four wheel drive cars.
Applies to two wheel drive cars:
Remove the decal with P/N 9454320 (see the lower right corner of the decal) from the floor hatch.
Applies to four wheel drive cars:
Remove the decal with P/N 9454319 (see the lower right corner of the decal) from the floor hatch.
2
M8902050
© Volvo Car Corporation
Lift the rear edge of the rear floor hatch 10-15 cm (4-5”) to remove it. Then detach the floor hatch by pulling it backwards out of its mountings. The hatch is securely installed. Detach one side at a time
Place the floor hatch to one side. The floor hatch will not be reused.
Carrier bag holder- 30664341 - V1.0
Side 3 / 7
3
M8503119
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
Check the floor supports to see if there is a lug protruding from them which is used to hook the support belt for the carrier bag holder
If there is a lug. Proceed directly to point 13.
4
M8902052
Pull the rear edge of the front floor hatch up. Pull the front floor hatch backwards. Remove the front floor hatch from the mountings.
5
M8504643
© Volvo Car Corporation
Remove the foldable side panels on the left and right-hand sides of the cargo compartment.
Carrier bag holder- 30664341 - V1.0
Side 4 / 7
6
M8502710
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
Remove the storage box from under the rear floor hatch by turning the clips on the left and right-hand sides 90°.
Lift out the box.
7
M8503121
Fold the rear backrest forward on both the right and left-hand sides.
8
M8503601
© Volvo Car Corporation
Remove the cover and then the screw from the front edges of the side panels on the left and right-hand sides of the cargo compartment. Remove the side panels from the left and righthand sides
Pull the top of the panel out until the clips release
If the car is equipped with a 12V electrical socket by the righthand side panel, disconnect its connector
Carrier bag holder- 30664341 - V1.0
Side 5 / 7
9
M8503130
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
Fold the panel inwards. Lift the panel out.
Remove the insulation panel in the cargo compartment.
10
M8503245
11
M8503223
© Volvo Car Corporation
Remove the screw on the left-hand side of the tailgate sill
Remove the three screws from the left-hand floor support
Repeat the operation on the other side
If the car has a CD or RTI system, disconnect their screws and note how the washers are installed
Lift up the front edge of the floor supports. Pull the floor supports forward.
Place the floor supports upside down
Take out the brackets with lugs from the kit. Align the brackets with the lug in the hole and the hole in the bracket on the locating pin for the floor support
Press the brackets into place so that the hooks hold them in position.
Carrier bag holder- 30664341 - V1.0
Side 6 / 7
12
M8803068
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
13
Reinstall the left and right-hand floor supports on both sides
Carefully press the insulation back into place
Tighten the floor supports in the floor. Tighten using the three screws and using the screw through the tailgate sill trim panel
Reinstall the CD/RTI units if applicable. Tighten the CD/RTI units using the previously disconnected screws and washers
Reinstall the insulation panel cargo compartment. Install the storage box
Reinstall the side panels. Reconnect the 12V socket connector if this was disconnected
Reinstall the front floor hatch
Fold the rear backrests up on both sides.
Press the new floor hatch (from the kit) into the mountings
Fold up the floor hatch until it is standing in the vertical position
Fold out the side support (1) on the right and left-hand sides.
Securely hook the end mounting of the strap (2) in the lug (3).
M8902052
© Volvo Car Corporation Carrier bag holder- 30664341 - V1.0
Side 7 / 7
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement