(Apply the label from warranty here)
PRODUCT INSTRUCTIONS
GB
1.
Normal hotplate Ø 180 - 1500 W
2.
Normal hotplate Ø 145 - 1000 W
3.
Rapid hotplate Ø 180 - 2000 W
4.
Normal hotplate Ø 145 - 1000 W
5.
Normal hotplate control knob Ø 180
6.
Normal hotplate control knob Ø 145
7.
Rapid hotplate control knob Ø 180
8.
Normal hotplate control knob Ø 145
9.
Hotplate operation control lamp
Operation of electric hotplates
•
•
Set the knob to one of positions 1-6, which
correspond to different temperatures.
To switch off the hotplate, set the knob to
position “0”.
NOTE: In case of installation of a hood above the cooktop, please refer to the hood
instructions for the correct distance.
`
SUPPLY VOLTAGE
230 V ~ +
CONDUCTORS:
NUMBER AND SIZE
3 x 2.5 mm2
TYPE: PLETS 230 V ~ 50 Hz 5.5 kW
5019 619 01378
ELECTRICAL
CONNECTION
~
BEFORE USING THE COOKTOP
• To get full satisfaction of your cooking
hob, please read these instructions
carefully and keep them for future
consultation.
• Keep the packaging material (plastic bags,
polystyrene parts, etc.) out of the reach of
children, as they are potentially dangerous.
• Check whether the cooking hob has been
damaged during transport.
• Ensure that the installation and electrical
connections are performed by a qualified
technician, following the manufacturer’s
instructions and in compliance with current
local safety regulations.
• Before first use of appliance, be sure to
clean stainless steel cooktop surface with
specific commercial cleaning product. Also
remove any labels applied on hob upper side
SUGGESTIONS FOR ENVIRONMENT
PROTECTION
1. Packaging
The packaging material is entirely recyclable, and is
marked with the recycling symbol
, which
identifies it as a type of material that must be sent
to local waste-disposal centres.
2. Product
This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol
on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as household
waste. Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household waste
disposal service or the shop where you purchased
the product.
PRECAUTIONS AND GENERAL ADVICE
• Before any cleaning or maintenance
operation, disconnect the cooking hob from
mains power supply.
• In case of prolonged use, additional
ventilation may be needed (opening a
window or increasing the extraction force of
the hood).
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge unless
they have been given initial supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• Keep children away from the cooking hob
when it is in use.
• After use, ensure that the knobs are in
position zero.
• Never clean the appliance with high
pressure water or steam cleaning
equipment.
2
Declaration of conformity
• This cooking hob is suitable for contact with
foodstuffs and complies with EEC (CE)
Regulation n. 1935/2004.
• This cooking hob (Class Y) has been designed to
be used only for cooking. Any other use (such as
heating a room) is improper and dangerous.
• This cooking hob has been designed, constructed
and marketed in compliance with:
- safety objectives of the “Low Voltage”
Directive 2006/95/CE (which replaces
73/23/CEE and subsequent amendments).;
- protection requirements of Directive “EMC”
2004/108/CE.
ENERGY SAVING TIPS
• The cooking hob is equipped with hotplates having different
diameters. Use pots and pans whose bottom diameter is
equal to that of the hotplates, or slightly larger.
• Only use flat-bottomed pots and pans.
• Do not operate a hotplate without placing a container
on it.
• If possible, keep the container covered when cooking.
• Cook vegetables, potatoes, etc. with a small amount of water
in order to cut down cooking time.
• A pressure cooker allows you to save even more energy and
time.
CARE AND MAINTENANCE
Important: Never clean the appliance with high pressure water
or steam cleaning equipment.
Cleaning the hob
• Before cleaning the cooking hob, disconnect it from
mains power supply and wait until it has cooled down.
• Wipe it with a cloth moistened with hot water and soap or
diluted liquid detergent.
• Do not use abrasive or corrosive products, chlorine products
or steel wool.
• Do not leave acid or alkaline substances, such as vinegar, salt
or lemon juice, etc., on the cooking hob.
Stainless steel surface
• Clean it with a specific commercial product.
Note: if the cooking hob is used continuously, the high
temperatures may alter the colour of the hotplates.
Cleaning the electric hotplates
The electric hotplates must be cleaned when they are
lukewarm.
Wipe them with a cloth moistened with water and salt, and
polish with a cloth moistened with oil.
3
TROUBLESHOOTING GUIDE
The hob does not work:
• Check for the presence of mains electrical
power.
• Set the knob to “0” and switch on the hob again
to ensure that the fault has been remedied.
The hob does not turn off:
• disconnect the hob immediately by disconnecting
the power cable from the socket.
• In case of direct connection to the power grid,
disconnect immediately using the fuse box.
AFTER SALES SERVICE
Before you call the After Sales Service:
1. Re-start the cooktop, to check whether correct
operation has been restored.
2. If the malfunction persists, call the After Sales
Service.
Give the following information:
• type of malfunction;
• model of cooktop;
• service number (i.e., the number that
follows the word SERVICE on the rating
plate under the cooktop and on the
guarantee paper);
• your complete address;
• your telephone number and area code.
4
If any repairs are required, please contact an
authorised After-Sales Service, as indicated in
the warranty.
In the unlikely event that an operation or repair is
carried out by an unauthorised technician,
always request a certification of the job carried out
and insist on the use of original spare parts.
Failure to comply with these instructions may
compromise the safety and quality of the
product.
INSTALLATION
Technical information for the Installer
This cooking hob can be embedded in a worktop 20 to
50 mm thick.
If another appliance is not fitted under the cooking hob,
insert a separator panel, at a distance of at least 90 mm
from the cooking hob bottom.
• If a vertical piece of furniture is installed, there must be
a gap of at least 100 mm between it and the edge of the
cooking hob.
Installation of cooking hob
• Apply the supplied gasket to the cooking hob (unless it
has already been fitted), after having cleaned its surface
as shown in the figure.
A - If the worktop is made out of wood, use the springs
supplied.
1. Fit the 4 springs
into the relevant seat under the box.
2. Make an opening in the worktop, respecting the dimensions
indicated in the enclosed product description sheet.
3. Install the cooking hob in the worktop.
B - If the worktop is made out of marble or other materials
(plastics, ceramics or stone), the cooking hob must be fixed
by means of brackets
, to be ordered from the AfterSales Service (code 4819 310 18528).
1. Align the brackets with the bores and fix them with the
screws.
2. Make an opening in the worktop, respecting the dimensions
indicated in the product description sheet.
3. Install the cooking hob in the worktop.
• Before installing the cooking hob, remove the plastic
film that protects it, if present. The outer surfaces of
the furniture or appliances adjoining the cooking hob
must be heat resistant (heat protection “Y”, according
to standards EN 60335-2-6).
• Installation must comply with current local safety
regulations.
5
INSTALLATION
Electrical connection
• The electrical connections must comply with local
regulations.
• The data relevant to the voltage and power absorption
are indicated on the rating plate.
• The earthing of this appliance is compulsory by law.
The manufacturer cannot be held responsible for injury
to persons or animals or damage to property arising
from failure to comply with these requirements.
• When the cooking hob is installed, provide a single-pole
circuit breaker with a contact breaking distance of at
least 3 mm.
• After installation, the electric parts must not be
accessible.
• The cooking hob must be earthed and fitted with fuses
adequate to the hotplate rating.
• For electrical connection, use an H05RR-F cable
(see table in product description sheet).
ELECTRICAL COOKING HOBS WITH
SIDE CONTROLS
Connection to terminal board
1. Open the cover of the terminal board and loosen screw
by means of a tool, as shown in the figure.
2. Unsheathe the cable for about 70 mm.
3. Peel off the internal cables for about 10 mm loosen cable
clamp screw
, and insert the cable in the cable clamp.
• The terminal board has 4 terminals:
1-2 interconnected (line)
3 (neutral)
4 (earth): marked with symbol
.
4. Connect the cable to the terminal board, following the
indications of the connection diagram punched on the
bottom of the cooking hob. Fasten the cable clamp and close
the cover.
6
">
