Whirlpool W7 MS450 Health and safety

Health & Safety and Installation guide
EN ENGLISH
Health and Safety guide
Installation guide
2
3
5
SAFETY INSTRUCTIONS
IMPORTANT TO BE READ
AND OBSERVED
Before using the appliance
carefully read these safety
instructions.
Keep them close at hand for
future reference.
These instructions and the
appliance itself provide
important safety warnings, to be
observed at all times.
The manufacturer declines any
liability for failure to observe
these safety instructions, for
inapropriate use of the appliance
or incorrect setting of controls.
and accessories, taking care not
to touch the heating elements.
At the end of cooking, exercise
caution when opening the door,
by letting the hot air or steam
exit gradually before accessing
the appliance.
Do not obstruct hot air vents at
the front of the oven.
If the appliance is suitable for
probe usage, only use a
temperature probe
recommended for this oven.
PERMITTED USE
This appliance is solely for
domestic, not professional use.
SAFETY WARNINGS
Do not use the appliance
Very young (0-3 years) and
outdoors.
young children (3-8 years) shall
Do not store explosive or flambe kept away from the appliance
unless continuously supervised. mable substances such as
aerosol cans and do not place
Children from 8 years old and
above and persons with reduced or use gasoline or other flammable materials in or near the
physical, sensory or mental
capabilities or lack of experience appliance: a fire may break out
if the appliance is inadvertently
and knowledge can use this
switched on.
appliance only if they are
CAUTION: The appliance is not
supervised or have been given
instructions on safe use and
intended to be operated by
understand the hazards
means of an external timer or
involved. Children must not play separate remote controlled
with the appliance. Cleaning and system.
user maintenance must not be
No other use is permitted (e.g.
carried out by children without
heating rooms).
supervision.
WARNING: The appliance and
INSTALLATION
its accessible parts become hot
Installation and repairs must be
during use, children less than 8
carried out by a qualified
years of age shall be kept away
technician, in compliance with
unless continuously supervised. the manufacturer’s instructions
WARNING: Avoid touching
and local safety regulations. Do
heating elements or interior
not repair or replace any part of
surface - risk of burns.
the appliance unless specifically
Keep clothes or other flammable stated in the user manual.
materials away from the
Children should not perform
appliance, until all the
installation operations. Keep
components have cooled down children away during
completely.
installation. Keep the packaging
Never leave the appliance
materials (plastic bags,
unattended during food drying. polystyrene parts, etc.) out of
Overheated oils and fats catch
reach of children, during and
fire easily. Always be vigilant
after the installation.
when cooking foods rich in fat,
The appliance must be handled
oil or when adding alcohol (e.g.
and installed by two or more
rum, cognac, wine) - risk of fire.
persons. Use protective gloves
Use oven gloves to remove pans
EN
to unpack and install the
appliance.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest Aftersales Service.
The appliance must be
disconnected from the power
supply before any installation
operation.
During installation, make sure
the appliance does not damage
the power cable.
Only activate the appliance
when the installation has been
completed.
Carry out all cabinet cutting
works before fitting the
appliance in the furniture and
carefully remove all wood chips
and sawdust.
After installation, the bottom of
the appliance must no longer be
accessible.
Do not obstruct the minimum
gap between the worktop and
the upper edge of the oven.
Only remove the oven from its
polystyrene foam base at the
time of installation.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3mm is required
and the appliance must be
earthed.
If the fitted plug is not suitable
for your socket outlet, contact a
qualified technician.
The power cable must be long
enough to connect the
appliance, once fitted in its
housing, to the main power
supply. Do not pull the power
supply cable.
If the power cable is damaged,
replace with an identical one.
The power cable must only be
replaced by a qualified
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
3
center.
For appliances with fitted plug, if
the plug is not suitable for you
socket outlet, contact a qualified
technician.
Do not use extension leads,
multiple sockets or adapters.
Do not operate this appliance if
it has a damaged mains cord or
plug, if it is not working properly,
or if it has been damaged or
dropped. Keep the cord away
from hot surfaces.
The electrical components must
not be accessible to the user
after installation.
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot.
The rating plate is on the front
edge of the oven (visible when
the door is open).
In case of replacement of power
cable, use only following type(s):
H05 RR-F 3 x 1.5 mm2.
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by an
accessible multi-pole switch
installed upstream of the socket
in conformity with national
electrical safety standards.
CLEANING AND
MAINTENANCE
Wear protective gloves for
cleaning and maintenance.
The appliance must be disconnected from the power supply
before any maintenance operation.
Never use steam cleaning
equipment.
WARNING: Ensure that the
appliance is switched off before
replacing the lamp to avoid
electric shock.
Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the door glass since
they can scratch the surface,
which may result in shattering
of the glass.
Ensure the appliance is cooled
down before carrying out any
cleaning or maintenance.
SAFEGUARDING THE ENVIRONMENT
DISPOSAL OF PACKAGING
MATERIALS
The packaging material is 100%
recyclable and is marked with the
recycle symbol.
The various parts of the packaging
must therefore be disposed of
responsibility and in full compliance
with local authority regulations
governing waste disposal.
SCRAPPING OF HOUSEHOLD
APPLIANCES
When scrapping the appliance, make
it unusable by cutting off the power
cable and removing the doors and
shelves (if present) so that children
cannot easily climb inside and become
trapped.
This appliance is manufactured with
recyclable or reusable materials.
Dispose of it in accordance with local
waste disposal regulations.
For further information on the
treatment, recovery and recycling of
household electrical appliances,
contact your competent local
authority, the collection service for
household waste or the store where
you purchase the appliance.
This appliance is marked in
compliance with European Directive
2012/19/EU, Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed
of correctly, you will help prevent
potential negative consequences for
the environment and human health,
which could otherwise be caused by
inappropriate waste handling of this
product.
The symbol
on the product or on the
accompanying documentation
indicates that it should not be treated
as domestic waste but must be taken
to an appropriate collection center for
the recycling of electrical and
electronic equipment.
ENERGY SAVING TIPS
Make sure the oven door is closed
completely when the appliance is
turned on and keep it closed as much
as possible while baking.
Cut the food into small, equally-sized
pieces to reduce cooking time and
save energy.
When the cooking time is long, over
30 minutes, reduce the oven
temperature to the lowest setting
during the last phase (3-10 minutes),
based on the overall cooking time.
The residual heat inside the oven will
continue cooking the food.
DECLARATION OF CONFORMITY
This appliance has been designed,
constructed and distributed in
compliance with the safety
requirements of EC Directives:
2006/95/EC, 2004/108/EC, 93/68/EEC
and 2011/65/EU (RoHS Directive).
4
This appliance, which is intended to
come into contact with foodstuffs,
complies with European Regulation n.
1935/2004/EC.
This appliance meets the Eco Design
requirements of European Regulations
n. 65/2014, and n. 66/2014 in
conformity to the European standard
EN 60350-1.
EN
A
B
C
x2
x2
90°C
5
497 mm
551 mm
20 mm
447 mm
455 mm
595 mm
min 450 mm
8 mm
B
X2
A
6
600 mm
min 550 mm
EN
C
X2
400010849600
001
Printed in Italy
7