Electrolux WAGL8E300 Quick start guide

48,&.86(5ൄ6*8,'(
1
2
3
4
5
6
Soft Plus
Before you activate the appliance
read the Safety Information chapter
in the User Manual.
7
6
Before you activate the appliance
remove all the transit bolts.
1 Detergent dispenser
5 Options/Skip phase button
2 On/Off button
6 Start/Pause button
For more information please always
refer to the User Manual.
3 Programme knob
7 Options/Skip phase button
THE ON/OFF BUTTON
4 Display
7+('(7(5*(17',63(16(5
The On/Off function automatically
deactivates the appliance to stop energy
consumption:
Compartment for prewash and soak phase.
• Beforet touching Start/Pause button, if
not using the appliance for about five
minutes. All settings are cancelled.
Press On/Off button to activate it again.
Compartment for liquid additives.
• After five minutes from the end of
the programme. Once activated the
appliance again, the display shows the
cycle end.
Compartment for wash phase.
Compartment for stain remover.
Flap for powder
(position up) or liquid
detergent
(position down).
(1
,17(5$&7,9(',63/$<
THE PROSENSE LOAD DETECTION
After the programme start and before the water filling, the
appliance estimates the laundry amount in 30 seconds. The
and indicators flash. After load estimation, the programme
duration is updated accordingly on the display.
MIX
Maximum load indicator
Maximum laundry indicator, it flashes in case of overloading.
Door lock indicator and
If the laundry amount is not reduced, the appliance starts the washing
programme immediately despite the overload (for more information
see the User manual).
child lock indicator
Delay start indicator
7KLVDUHDFDQVKRZVWKHSURJUDPPHGXUDWLRQ (e.g.
),
the delay time (e.g.
), the cycle end ( ), the warning code
(e.g.
)
3KDVHLQGLFDWRUV
MIX
Washing
Rinse
Soft Plus
Spin
Anticrease
Steam
Energy saving indicators.
appears if selecting a cotton
programme at 40°C or 60°C
Time save indicator
Spin speed indicator
Temperature indicator and
connection indicators.
Extra Silent indicator
Cold wash indicator
$/$50&2'(6
The display can show alarm codes (refer to the “Troubleshooting”
table in the user manual):
OKO-MIX (if available)
Rinse Hold indicator and
If the drum is overloaded, the display shows the maximum load
and
flashes. In this case, for further 30 seconds it is
possible to pause the appliance and remove a few garments.
Hot water
:
:
:
:
The appliance does not fill water properly.
The appliance does not drain the water.
The appliance door is open or not closedcorrectly.
The anti-flood device is on. Disconnect the appliance and
close the water tap. Contact the Authorised service centre.
67$577+($33/,$1&(
'$,/<86(
Open the water tap and connect the mains plug to the mains
socket.
Press On/Off button to activate the appliance.
Put the laundry in the drum, one item at a time. Make sure that
no laundry stays between the seal and the door.
Close the door and put the detergent and additives in the
correct compartment of the dispenser.
Turn the programme knob to set a programme. The
corresponding indicator comes on.
E.g. Synthetic programme at 40°C, 1200 rpm, 4 kg
The display shows the maximum
declared load, the default
temperature, the maximum
spin speed, the washing phase
indicators (when available) and
the programme duration. To
change the temperature and/or the spin speed or to add the
available options touch the related buttons.
If necessary, set the delay start function. Keep touching the
Delay Start button until the display shows the desired delay
time.
Touch Start/Pause button to start the programme. The
Prosense function starts the load estimation. If you have set the
Delay Start, the appliance starts the countdown.
During the programme, the appliance can adjust the
duration, depending on the water absorption of the
fabrics.
At the end of the programme the appliance stops automatically.
In the display all washing phase indicators become steady and
the time area shows a steady . The indicator of the Start/Pause
button and the door lock indicator
goes off. The door unlocks.
If you have set the Rinse Hold or Extra Silent option, refer to
‘Draining water out after end of cycle’ paragraph in the User
Manual.
Remove the laundry from the appliance. Make sure that the drum
is empty. Keep the door and the detergent dispenser slightly ajar
to prevent mildew and odours.
Unplug the appliance and close the water tap.
AFTER PROGRAMME START
If it is necessary to interrupt a programmme, touch Start/Pause
button and wait for the door unlock. Touch it again to restart the
programme.
If it is necessary to cancel a running programme, press the On/Off
button to deactivate the appliance. The selection is cancelled.
CARE AND CLEANING
&OHDQWKHDSSOLDQFHᅧOWHU
UHJXODUO\5HIHUWRൃ&DUHDQG
&OHDQLQJൄFKDSWHULQWKH
XVHUPDQXDO
352*5$00(6
3URJUDPPH
7HPSHUDWXUHUDQJH
7\SHRIORDG
:DVKLQJSURJUDPPHV
60 °C - 30 °C
Duvet
40 °C - Cold
Wool/Silk
40 °C - Cold
Delicates
60 °C
Anti-allergy
60 °C - Cold
Jeans
60 °C - Cold
Synthetics
95 °C - Cold
Cottons
White cotton and coloured cotton with normal soil.
Synthetic items or mixed fabric items with normal soil.
Denim clothing and jersey items with normal soil.
White cotton items. This programme helps to remove germs and bacteria
Delicate fabrics such as acrylics, viscose, polyester items with normal soil.
Machine washable wool, hand washable wool and delicate.
Single synthetic blanket, padded clothes, duvets, down jackets.
6WHDPSURJUDPPH
Steam
-
Steam programme for cotton and synthetic items
:DVKLQJSURJUDPPHV
40 °C - Cold
Outdoor
40 °C - 30 °C
20 Min. - 3 kg
Cotton and synthetic items lightly soiled or once worn.
Modern sports clothes such as gym, cycling, jogging and similar items.
157006730-A-372016