INSTRUCTION BOOK
Model No. EHT632 X
Product No 949 600 538
Serial No.
4) Electrolux
AKTIEBOLAGET ELECTROLUX
Little Essington, Luxbaacken 1
105 45 STOCKHOLM, SWEDEN
Tor: 0720 0 1 ew О Electrolux
Contents Page no
Important to Know ................=..e-=eseerreerera ne Ree e ee reee e ener rene 3
Faults ———erneeeeereeecenrevesreenacrianeereooseeeer ercer renconeeroentaneeceerenteeertarerrenrerrercareccao 6
Operating EN 7
Ignition .............. anrerensoooarenotenenoenarrenconeorteraraararcaneareocacanraarcnoreroecoceo reee. 9
Maintenance And Cleaning noneoonaneonrennenonncorenTanvenaccaneooooorrrceroccorreccenooreraccorenes 10
Mounting —.............ece.ec0rcerremencen reee er Denern aerea ceca erre rec Dore erre reee. 11
Technical data ...............ee.ee=ereeeeeccen eee e ernest e ere ceca eee reee. 13
If the gas-hob does not Work ......................ecoerecriee e een, 14
Service and spare parts ...................e...0re00merer e DD IR II O II IR O DO 14
It is important to know how the hobs works, for which reason we would ask you
to read these instructions carefully before using it. Only then can we quarantee
that "your new kitchen aid" will fully meet your expectations and requirements that
you had when you chose your Electrolux system.
Sincerely
Electrolux
Important to know
Service and repair may only be
performed by the distributor, or by a
service organization approved by the
distributor. Only repair parts delivered
by the distributor may be used.
Please read the warranty.
Avoid pinching the cable.
The hob unit is intended for ordinary
household cooking purposes. Any
other use can result in damage to the
unit as well as personal injury.
Use only pots and pans with a rigid,
even contact surface - uneven contact
surface results not only in poor heat
conduction, but also increases the risk
of dangerous spills.
During deep-fat frying, sauteeing,
melting of butter, etc., one must always
remain near the unit, due to the danger
of fire. In the event of fire the unit
must be shut off immediately (and the
cooker hood as well, if in use).
Make sure that the unit is shut off
when not in use - the knob should rest
at “0”.
The unit becomes dangerously hot
during use, and remain so for a period
of time. They should therefore be
treated with due respect. Keep children
at a distance.
For safety's sake, turn pots and pans so
that handles do not protrude, thus
inviting accidents.
Never place plastic or paper, etc., on
the unit. If the unit should be switched
on by accident, the paper could burn,
plastic melt, etc.
For hygienic and safety reasons the
unit must be kept clean. Grease, oil
and food spills create unpleasant
odours when burnt, and can in some
cases result in open flames.
Read - and adhere to - the users
instructions, as well as any instructions
and wamings printed on the labels of
the cleaning agents used.
Help to avoid accidents; if the unit
should ever be discarded, render it
useless by removing the cable, or by
cutting the cable as close to the unit as
possible,
Areas if use
The hob is only intended for normal
household use. It is important that you
follow the advice given in these
instructions in order to avoid any risk
of damage to persons and objects.
Used for any other purpose invalidates
the guarantee as well as product
liability.
Product liability
Our liability is limited to that which is
stipulated by law, and covers only
damage to persons and property, which
results from defects in materials and
workmanship of the unit itself.
This liability extends fora period of 10
years from the date of purchase as a
factory-new unit.
Reservations
Our liability does not apply in the
event that the damage in question is
due to any of the following conditions:
The unit has not been installed in
accordance with the instructions set
forth in this pamphiet.
That the safety rules in the instructions
have not been complied with,
That repair has been made by others
than an authorised service technician.
The unoriginal spare parts have been
used.
That the damage is caused by transport
at a later date, for instance during
removal or resale.
That the damage 1s caused by any form
of use contrary to common sense.
Positioning
It is advisable to place the unit near an
out-of-the-way, or closed, corner, with
space on either side on which to rest
hot cooking utensils. The unit should
not be placed at a heavily-trafficked or
177$
open corner, nor in at pasageway.
Unpacking
Check to see whether the unit is
damaged.
Distribution damages
Any damages due to transportation by
us or by our representative must be
reported to the dealer not later than
one week after receipt of the unit.
Check
If you make a note of the model,
product and serial numbers on receipt
you will always have this information
to hand (See frontpage).
These numbers will be needed for any
service visits.
The model number plate is situated on
the bottom of the hob.
Size of pots and pans
Small-sized burner, recommended size
777-777 mm
Medium-sized burner, recommended
size 130-210 mm.
Large burner, recommended size 180 -
280 mm.
Saftey
To enable the consumer to locate any
leaks in the installation, a smelling
substance has been added to all gas
qualities available in the market - town
gas, natural gas or bottled gas.
When smelling gas or in case of any
other kind of malfunction of the unit
switch off the main gas supply or the
bottled gas and contact service, an
authorized heating and sanitary
engineer or your gas supplier.
It is recommended that a maintenance
check of the gas installation and the
unit should be performed at least every
three years. Consult your authorized
heating and sanitary engineer.
1737
Faults
Question:
There is no spark when lighting the
gas?
|
When the operating knob is released
the gas ring goes out again?
The gas ring burns very unevenly??
1740
Answer
Check whether the 230 V connection
has been plugged in. The ground fault
circuit relay way have switched off.
The fuse has blown
The operating knob has not been
depressed long enough, or has not
been depressed sufficiently.
Check whether the cover has been
replaced correctly, e.g. after cleaning.
Operations
Burner markings
Signs at each operating knob indicate
which burner is to be adjusted with the
knob in question. ñ a
Front Burner T
Back burner Г o() a (>
A 4
Panel markings “
Each operating knob has a ring
showing the scale of markings.
Off. = Burner 2 —_
Max. flame No Bruner]
Min. flame À
Guide knob for grid
1741
Ignition
Burner cover/burner ring * Depress the operating knob for the
Together with the burner ring the burner Burner ring Burner cover burner in question.
cover forms a space where the final * At the same time as the knob is
mixture of gas and air takes place in PP TEE TETE depressed, it is turned towards the
>
order to make the gas burn correctly. left to max. flame § which will
make the gas escape.
Please note: It is consequently very Correct | * The ignition electrode will emit
important that the individual burner | sparks, and when the mixture of gas
cover/ring is placed correctly on the and air is correct, the burner will be
ignited. If there is no possibility of
connecting the unit to mains, a
match may be used.
* After starting the burner, press the
burner, The burner ring has been
provided with holes for the ignition
electrode, and the thermo sensor.
If the burner cover/ring are wrongly control button for approx. 10 84557
placed the burner will operate seconds to activate the automatic
incorrectly, and the burners may be thermo-fuse (thermo sensor ready).
damaged within at short space of time.
Ignition electrode (A)
Each burner has been provided with an
ignition electrode. As long as the
operating knob is depressed, the Burner Main nozzle
automatic ignition will ensure that a
spark is emitted between the ignition TO
electrode and the burner cover. A
Thermo Sensor (B) TT
The hob unit features fully-secured gas Uh Th
taps (thermo-fuse)
In case the flame goes out, the thermo A B
sensor automatically prevents gas
admission after a few seconds (max. 90
seconds). R
Note: Gas admission is always allowed
while the operation button is pressed -
See start-up procedure
174 1747
Maintenance and cleaning
The operating panel with knobs/grid
and the enameled top plate and burner
covers/rings are to be cleaned with
ordinary cleaning agents.
However, do not use any kind of
scouring powder.
The hob with the stainless steel top
plate 1s to be washed with ordinary
soap and water. Dry thoroughly to
avoid lime stains. Any such stains may
be removed with vinegar or whiting
dissolved in spirit.
Avoid saucepans boiling over. If you
have been so unfortunate as to get
water in the burner this water should
be removed before re-igniting the
burner, e.g. with a no-fluff cloth.
If the hob is very dirty it is
recommended that special cleaning
agents are used, These are available
from your distributor.
10
Mounting
Caution: In order to avoid a hazard this
appliance must be installed according to
these installations for installation
The hob unit can be mounted in any
type of kitchen with a table surface
whose thickness is between 28 mm and
40 mm.
Headroom
The distance to any shelves or tops of a
cabinet under the hob is to be at least 55
min.
Fixing
Screw the fixing brackets out to such an
extent that they can be turned in under
the table top. Tighten the brackets on to Minimum distance Minimum distance
the table top with an ordinary to wall: to wall (non-
screwdriver. 150 mm flammable material);
150 mm
Cut-out measurements
One rectangular hole is sawn out for the
hob combination chosen.
The depth of the cut-out for any unit is:
490 mm
Length of hole = sum of all units”
externally measured lenght, less 20 mm.
beams
Mounting of Reinforcement
Beams
A reinforcement Beam, with supporting
flanges at each end, is included with
each two-burner unit. For unit
combinations, a reinforcement beam
must be used between each unit. It is not
1744
11
necessary to attach the reinforcement
beam to the table surface, as it is held
in place by a specially designed
moulding, which is incorporated in the
hob units flanges.
The unit's externally
measured length
145 mm:
Cooker hood
290 mm:
Two-burner standard electric hob
Two-burner ceramic-top electric hob
Two-burner gas hob
Grill
580 mm:
Four-burner ceramic-top electric hob
Four-burner gas hob
Installation of a single unit
When mounting a single unit, be it a
half-or full size unit, in a table surface
which is thicker than 30 mm, it is
necessary to make a special notch in
both sides of the cut-out hole, as
shown in the adjacent drawing.
The purpose of these notches is to
create space for the electrical cables.
Glass cover
For units with a glass cover, ensure
that the cover always remains open
while the unit is operating (operation
indicator lamp on).
1761
12
45 degrees
Technical data
Type of gas
Adjusted to natural gas: G20-20 mbar
Category and pressures
[I1a2H3+ 20 mbar
Convertible to
Town gas - 8 mbar
Bottled gas - 28/37 mbar
Max. nominal load Q na E:
Small sized burner= 10kWx!
Medium sized burner= 20kW x2
Large sized burner = 3,0 kW x 1
Total= 8,0 kW
FSD
The unit features fully-secured gas taps
(thermo-fuse).
H, = Topcalorific value
О = Nominal load
Voltage= 220-240 V
Ignition transformer=
Radio-noise reduction
This unit observes the current EEC-directive
on radio noise reduction.
This gas appliance is C€ -approved and C€ mar-
ked in accordance with the gas appliance
Directive (90/396/CEE), the low voltage
directive (73/23/CEE) and the EMC directive
(89/336/CEE incl. the agreed directive
changes.
13
50HZ-2x 0,6 VA
Burner 2 Burner 3
Burner 4
roo 00 | D
2 3 4
If the gas-hob does not work
Check to see whether a fuse has
blown.
Check to see whether the relay is
switched off.
If the problem is not with the fuse or
relay, do not attempt to correct it
yourself.
Instead, contact our service network -
all repairs must be performed by our
service personnel.
Warranty
This unit 1s warranted against defects
in materials and workmanship, when
used as intended, for a period of one
year from the date of purchase. The
warranty covers both parts and service,
as well as necessary transportation
costs. Keep your proof of purchase.
Reservations
The warranty does not cover damages
which are not due to defects in
materials or workmanship. Repair, or
attempted repair, by any party other
than our authorized service network
will invalidate the warranty. The
warranty does not cover an unjustified
house-call by our service network.
Service and spare parts
Service and repair of this unit must be
carried out by our service personnel, or
1199
14
by an alternative service organisation,
approved by the distributor. Only spare
parts delivered by the distributor may
be used. Spare parts and service are the
domain of our service network.
">
