INSTALLATION
&
OPERATING
INSTRUCTIONS
RA/RM-1D
RGE 300
0402
822 70 73-03
MO-M 0709
OPERATING AND INSTALLATION INSTRUCTIONS
FOR REFRIGERATOR RGE 300
INTRODUCTION
CONTENTS
We are pleased that you have chosen this refrigerator and hope
you will derive much satisfaction from using it, but first a few
well-meant words of advice:
• It is important to read through these instructions carefully
before using the refrigerator.
• To ensure good refrigeration and economical operation, the
refrigerator must be installed and used as described in these
instructions.
• The refrigerator is ideal for installation in homes, farms, cottages, holiday homes, and chalets or similar.
OPERATING INSTRUCTIONS _ __________________ 4
CONTROLS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
STARTING THE REFRIGERATOR . . . . . . . . . . . . . . . . . . 4
REGULATING THE TEMPERATURE. . . . . . . . . . . . . . . . 4
FOOD STORAGE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
TRANSIT DAMAGE
ICE-MAKING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Inspect the refrigerator for damage. Transit damage must be
reported to whoever is responsible for delivery not later than
seven days after the refrigerator was delivered.
DEFROSTING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
CLEANING THE REFRIGERATOR. . . . . . . . . . . . . . . . . . 5
DATA PLATE
TURNING OFF THE REFRIGERATOR. . . . . . . . . . . . . . . 5
iF THE ‘FRIDGE FAILS TO WORK . . . . . . . . . . . . . . . . . 5
The data plate is located inside the refrigerator. Since these
details will be needed if you have to contact service personnel,
it is a good idea to make a note of them here:
MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
SOME USEFUL HINTS. . . . . . . . . . . . . . . . . . . . . . . . . . . 5
TECHNICAL DATA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Model designation. . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION INSTRUCTIONS__________________ 6
Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PLACEMENT OF THE REFRIGERATOR. . . . . . . . . . . . . 6
Gas pressure. . . . . . . . . . . . . . . . . . . . . . . . . . . .
LP GAS CONNECTION. . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Product number . . . . . . . . . . . . . . . . . . . . . . . .
ELECTRICAL CONNECTION . . . . . . . . . . . . . . . . . . . . . . 6
Serial number. . . . . . . . . . . . . . . . . . . . . . . . . . .
OPERATING INSTRUCTIONS
STARTING THE REFRIGERATOR
CONTROLS
LP Gas operation
The position numbers refer to fig. 1.
After initial installation, servicing, or changing gas cylinders
etc., the gas pipes may contain some air, which should be allowed to escape by briefly turning on the refrigerator or other
appliances. This will ensure that the flame lights immediately.
1. Make sure that all valves between the gas container and
the refrigerator are open.
2. Turn the energy selector (A) to position .
3. Push the button (C) in until it reaches the bottom - and
hold, push the button (D) for the piezo igniter several
times to light the burner.
4. Check the flame indicator (E) to see if the flame is lit.
5. Keep the button (C) pressed for a further 10-15 seconds.
6. Release the button (C) and check that the flame is alight.
To terminate gas operation, turn knob (A) to 0.
Electric operation
Set the energy selector (A) to position I. To shut off the refrigerator, turn the knob (A) to 0.
Fig. 1
REGULATING THE TEMPERATURE
The refrigerator can be run on either mains electric or LP gas.
Changing between these modes of operation is carried out by
means of control buttons positioned as shown in fig. 1.
The position number refers to fig. 1.
It will take several hours for the refrigerator to reach normal
operating temperature. A thermostat controls the temperature
of the main compartment of the refrigerator. The thermostat
knob (B) should be set at 3-5. If a lower (colder) temperature is
desired set the thermostat to a higher figure.
The energy selector (A) can be set at either I (= 230 V),
(= LP gas) or 0 (= off).
FOOD STORAGE
The refrigerator temperature is controlled by a thermostat (B).
Please note that the thermostat has no “off” position.
Always keep food in closed containers. Never put hot food in
the refrigerator; allow it to cool first.
Never keep items in the refrigerator that might give off
flammable gases.
The frozen food compartment is intended for the storage of
frozen food and for making ice. It is not suitable for freezing
items of food.
Never put bottles or cans of fizzy drinks in the frozen food storage compartment as they may burst when freezing.
Most kinds of frozen food can be stored in the frozen food
compartment for about a month. This period of time may vary,
however, and it is important to follow the instructions on the
individual packets.
The refrigerator is fitted with a safety device that automatically
shuts off the supply of gas if the flame goes out. The safety
device can be opened manually by pressing the button (C).
The piezoelectric igniter discharges sparks over the burner
when the button (D) is pressed.
In the flame viewer (E) you can see a blue light when the gas
flame is lit.
ICE-MAKING
Fill the ice tray just below the brim with drinking water and
place it on the freezer shelf.
It is possible to make ice faster by turning the control knob
temporarily to its highest value but do not forget to turn it back
to its regular setting afterwards as the refrigerator might otherwise become too cold.
DEFROSTING
If the refrigerator is not cold enough it may be because:
• The ventilation of the cooling unit is inadequate; see the
paragraph PLACEMENT OF THE REFRIGERATOR.
• The evaporator is frosted up.
• The temperature control setting is incorrect.
• The gas pressure is incorrect - check the pressure regulator
at the gas container.
• Too much food is loaded at one time.
• The door is not properly closed or the magnetic sealing
strip is defective.
Frost will gradually accumulate on the refrigerating surfaces.
It must not be allowed to grow too thick as it acts as an insulator and adversely affects refrigerator performance.
Check the formation of frost regularly every week and when
it gets about 3 mm thick, defrost the refrigerator. To defrost
the refrigerator, turn it off and remove the ice tray and all
food items. Warning: normally the temperature of items of
frozen foods would rise unduly during defrosting and so they
should be consumed within 24 h or discarded.
Do not try to accelerate defrosting by using any kind of heating appliance, as this might damage the plastic surfaces of
the refrigerator. Neither should any sharp objects be used to
scrape off the ice.
The defrost water runs from a collector channel to a receptacle at the rear of the refrigerator where it evaporates. Defrost
water in the freezer compartment should be mopped up with
a cloth. When all ice has melted, wipe the refrigerator dry and
restart it.
Place the food items back inside but wait until the refrigerator
is cold before making ice cubes.
If the refrigerator still does not work properly, call a service
technician.
The sealed cooling system must not be opened,
since it contains corroding chemicals under
high pressure.
MAINTENANCE
Inspect the gas hose periodically for cracks or deep chafing marks. Connections can be tested for leaks using a soap
solution. DO NOT USE AN OPEN FLAME! If there is any
suspicion of damage, call for a service technician. We recommend that a service technician check the refrigerator once a
year.
CLEANING THE REFRIGERATOR
Clean the inside of the refrigerator regularly to keep it fresh
and hygienic. Soak a cloth in a solution consisting of a
teaspoon of bicarbonate of soda to half a litre of warm water.
Wring out the cloth and use it to clean the interior of the
refrigerator and its fittings.
Never use detergents, scouring powder, strongly scented
products or wax polish to clean the interior of the refrigerator
as they may damage the surfaces and leave a strong odour.
The exterior of the refrigerator should be wiped clean now
and again, using a damp cloth and a small quantity of detergent. The door gasket should only be cleaned with soap and
water and then thoroughly dried.
The cooling unit behind the refrigerator should be cleaned
with a brush from time to time, but make sure that the refrigerator is switched off when doing this.
SOME USEFUL HINTS
Make sure that:
• Defrosting is carried out periodically.
• The refrigerator is clean and dry with the door left open
when it is not to be used for some time.
• Liquids or items with a strong odour are well packaged.
• There is a free air circulation over the cooling unit at the
rear of the refrigerator.
TECHNICAL DATA
RGE 300
Overall dimensions
TURNING OFF THE REFRIGERATOR
If the refrigerator is not to be used for some time:
1. Shut off any valve in the gas line to the refrigerator.
2. Set the energy selector (A) to 0.
Height
1175 mm
Width
592 mm
Depth
623 mm
Capacity
3. Empty the refrigerator. Defrost and clean it as described
earlier. Leave the doors of the refrigerator and the frozen
food compartment ajar.
iF THE ‘FRIDGE FAILS TO WORK
Gross
146 litres
Net
137 litres
Frozen food compartment
15 litres
Weight (without packaging)
Check the following points before calling a service technician:
1. That the STARTING THE REFRIGERATOR instructions have been followed.
58 kg
Electrical data
2. The refrigerator is level.
Input 230 V
175 watt
Energy consumption/24h
2.2 kWh
LP gas data
3. If it is possible to start the refrigerator on any of the connected sources of energy.
4. If the refrigerator fails to work on gas, check:
• That the gas bottle is not empty.
• That all LP-gas valves are open.
5. If the refrigerator fails to work on mains electric, check:
• That the mains electric supply is connected to the
refrigerator.
• That the fuse is intact.
Input max
0.33 kW
Energy consumption/24h
400 g
Cooling medium
Ammonia
INSTALLATION INSTRUCTIONS
This appliance must be installed by an authorised person
and conform to all relevant local authorities.
From the side
PLACEMENT OF THE REFRIGERATOR
The room should have a capacity (length x width x height)
of at least 20 m3 and must be adequately ventilated as well as
follow all relevant national and local regulations. Further the
room should have a window (which can be opened) or a door
to the outside.
It is important that the refrigerator is not subject to radiation
of heat from a stove etc.
For best performance also at high ambient temperatures there
must be a free air circulation over the cooling unit at the rear
of the refrigerator.
The refrigerator is designed for a free-standing installation
and the clearance to the rear wall and to possible side walls,
should be at least 25 mm. The clearance above the refrigerator should be at least 100 mm.
The refrigerator must be adjusted to a vertical position in
both directions. Use the feet on the refrigerator to adjust its
position.
At least
25 mm
From above
LP GAS CONNECTION
The gas installation and servicing should only be carried out
by an authorized, qualified person and must conform to all
relevant national and local regulations.
The gas supply system must incorporate a pressure regulator
to maintain a supply pressure of not more than 2.75 kPa.
The supply pipe should preferable be of copper. If any other
material is used, it must be of a type approved for use with
continuously operating bottled-gas appliances, and have
threaded connections throughout.
All connectors etc. should be of a type specifically designed
for the type and diameter of the connection pipe used, and
screwed joints should be sealed with a joining compound approved for use with bottled gas.
The gas supply pipe should be connected to the gas valve at
the rear of the refrigerator, by means of a suitable threaded
coupling. The gas valve is furnished with a ISO 7/1 - Rp 1/8
internal pipe thread connection. In making the connection to
the refrigerator, a union gas cock of an approved bottled-gas
type must be incorporated in the supply line in a position that
is readily accessible to the user.
For servicing purposes, the union should be on the outlet side
of the cock and the pipework should be positioned so as not
to prevent the refrigerator from being readily withdrawn.
All completed connections should be checked for leaks with
soapy water. DO NOT use a flame to check for gas leaks.
25
25
25
Check that the gas supplied to the refrigerator
is at the correct pressure. See the reducing valve
on the lp gas container.
Rear
The refrigerator is designed for operation on LP gas, the
pressure of which must be 30 mbar for Propane. Check that
this is stated on the data plate.
The refrigerator is not designed for operation on town gas or
natural gas.
Wall
Wall
ELECTRICAL CONNECTION
The electrical installation must be carried out in a proper and
durable manners, taking into account all relevant regulations
and codes of practice.
For mains voltage operation, it is important that the circuit is effectively earthed.
230 volts connection
Check that the voltage stated on the data plate is the same as
the main voltage in use. Plug the refrigerator power cord into
an easily accessible earthed wall socket.
Electrical leads must be routed and secured so that they
cannot come into contact with hot or sharp parts of the
refrigerator.
">
