Samsung PC1MWFMAN Installation guide

Air conditioner
Installation manual
PC4SUFDAN
•• Thank you for purchasing this Samsung air conditioner.
•• Before operating this unit, please read this manual carefully and retain it for future
reference.
DB68-07695A-00
4 Way Cassette Wind-Free Panel
If the Wind-Free function is not visible on the higherlevel controller after connecting the Wind-Free panel:
• Check if the software of the higher-level controller is
the latest version.
1 Open the electrical component box cover.
• After untightening the screws, slide the electrical
component box cover in the direction of the arrow as
shown in the figure and pull it down.
• If the software is not the latest version, update to the
latest version.
• If the software of the higher-level controller is the
latest version but the Wind-Free function is not visible
on it, perform tracking again on the higher-level
controller or reset its power.
※ Higher-level controller: DMS, Touch Centralized
Controller, Wi-Fit kit, or other device
Accessories
Item
Bolt (M5xL35 MACHINE)
Installation manual
Shape
NOTE
• If the supplied bolt is lost, you may purchase M5
machine bolt (with length of the thread more than
20 mm long) and a circular washer from any retail
hardware store to replace the lost bolt.
• Tightening torque for the M5 screw: 2.0 to 3.0 N∙m (20
to 30 kgf∙cm)
CAUTION
• After installing the product, be sure to explain to the
user how to use the air conditioner.
Installing the panel
CAUTION
• Handle the panel carefully.
• Do not lean the panel against a wall or place it on a
protruding object.
Failing to do so may damage the surface of the panel.
• Be careful when installing the air inlet panel by hand.
You may get hurt.
2 English
2 Pull both hooks in the direction of carved arrows and
take the grille to open.
• Hooks are located below the Samsung logo on the
grille.
3 Hang the panel on the 2 hooks on the both sides of the
indoor unit firmly so that the panel not to fall out.
Hook
5 Fix the bolt to the panel.
• Fix 4 bolts to the panel temporarily.
• Fix them tightly not to make a gap between the panel
and the ceiling.
4 Detach the 4 corners of the panel. Use two grooves on
the each corner of the panels when pulling them out.
• Handle the corner with digital display gently, since
there are electrical cables connected to that corner.
• Each corner portion of the panel is easy for you to
adjust the height, but a special tool should be used.
Don’t use directly hand.
Groove
NOTE
• Adjustment of the indoor unit height from the holes in
the corner of panel is possible.
• Pipe connecting area is not allowed to adjustment of
the indoor unit height.
English 3
4 Way Cassette Wind-Free Panel
6 Connect 4 cables between the indoor unit and the
panel.
• Make sure you check the number of pins on the three
white terminal before connecting the cables.
White (10 PIN)
8 Attach and close the front grille.
• Make sure the hooks on the rear side of grille fits
properly into the grooves on panel ( 1 ) and then push
the panel to close ( 2 ).
White (13 PIN)
White (4 PIN)
1
Blue
Hook
Grille
2
9 Check out that the panel is fixed to the indoor unit.
Panel
• Fix screws tightly between the panel and the surface
of the ceiling. If the panel is installed incorrectly, air
may leak.
• Do not block any discharge vents in the panel.
7 Close the electrical component box cover and tighten
the screws.
NOTE
• If the angle on the air flow blades has been changed by
user due to opening the front grille for installation or
maintenance, you must turn off the circuit breaker and
turn it on again before using the air conditioner.
Otherwise, angles of the each blade can be different
or some of the blade may not close when the product
is off.
4 English
Memo
English 5