Candy | LBCTS44 UNI | Candy LBCTS44 UNI User manual

Candy LBCTS44 UNI User manual
EN
INTRODUCTION
INDEX
page
Read this manual carefully as it offers practical advice to help you get the most from your
washing machine.
GUARANTEE .............................................................................. 47
TECHNICAL DATA ....................................................................... 48
This Instruction Manual
contains everything you need to
know about the everyday
running of your machine. Keep
it for future reference.
OPENING THE LID – LOADING ................................................ 49
DETERGENT DISPENSER ........................................................ 50
PROGRAMME SELECTION ....................................................... 51
An
Installation
and
Maintenance Manual is also
provided which you should
consult during the installation
and routine maintenance of
your washing machine. The manual also contains information
about possible working
problems, advice about the
wash load, an explanation of
label symbols and hints about
how to remove stubborn stains.
CONTROL DESCRIPTION
MOD. CTS 44 ............................................................................... 52
MOD. CTS 45T ............................................................................ 54
TABLE OF PROGRAMMES ....................................................... 57
1.- CONTROL PANEL
2.- LID
3.- DRUM
4.- DETERGENT COMPARTMENT
5.- FILTER DOOR
6.- FILTER
When contacting a CANDY or one of its Technical Assistance Centre
always refer to the model (see control panel) and the registration and
series numbers which are indicated at the bottom of the machine under
the lower panel or on the warranty certificate. That is to say, everything
that appears in the box.
Providing this information will ensure a faster and more efficient service.
45
Place the adhesive label, in the
corresponding language, in the
support that slots into the back of the
panel display.
46
GUARANTEE
1.
The appliance comes with a guarantee certificate.
B
A
2.
Complete part B and keep it in a safe place. It should
be presented to the Technical Assistance Centre in
the event of a repair being necessary along with the
legal receipt issued by the dealer on purchase.
TECHNICAL DATA
CTS 44
Load capacity ....................................................................... kg.
4,5
4,5
Voltage ................................................................................... V.
230
230
Wash motor power rating ...................................................... W.
280
280
Spin motor power rating ........................................................ W.
500
500
Electropump power rating ..................................................... W.
30
30
Heating element power rating ............................................... W.
1.950
1.950
Max. power input ................................................................... W.
2.300
2.300
Fuse ....................................................................................... A.
10
10
Water pressure .................................................................. MPa
0,05 min.
0,05 min.
0,8 max.
0,8 max.
Spin speed ............................................................. r.p.m./min
400
400
Water consumption (60º C programme) ................................ lit.
65
65
Energy consumption (60º C programme)/4,5 kg ............... kWh
1,21
1,21
Energy efficiency rating ..............................................................
C
C
3.
Do not forget to send part A of the Guarantee
Certificate to be validated within 15 days of purchase.
47
48
CTS 45 T
OPENING THE DRUM
A
FR
W ON
A
MA SH T OF
CH ING TH
IN
E
E
1.
Lift the lid (A) and open completely. Next open the drum
door following these instructions:
2.
Press catch (B) and kept it pressed down.
Press the first shutter (C) to unlock the two shutters (C)
and (D).
3.
Open the second shutter (D). Open the first shutter (C).
Place the washing in the drum.
C
D
NG LI
HI NE
AS I
W ACH
M
DETERGENT DISPENSER
B
The detergent dispenser is divided into 4 compartments:
• Compartment I, is for prewash powder detergent. The recommended quantity is 60
gm of detergent (for 4,5 kg of laundry).
• Compartment II, is for wash powder detergent. The recommended quantity is 120
gm of detergent (for 4,5 kg of laundry).
• The
compartment is for bleach. The recommended quantity is 7 cl.
• The
compartment is for fabric conditioners, scenting agents and special
additives. The recommended quantity is 5 cl.
D
The detergent compartment has two guidance lines:
FR
W ON
M AS T
AC HI OF
HI NG T
HE
NE
4.
Close the first shutter (C).
Close the second shutter (D) so that the catch on the first
shutter fits correctly into the slot. Release.
• RECOMMENDED (lower line). This indicates the recommended level for the prewash
and wash compartments.
• MAX. This indicates the maximum level which should never be exceeded.
C
5.
Ensure that both shutters are perfectly aligned and properly
closed.
D
FR
W ON
M AS T
AC HI OF
HI NG T
HE
NE
IMPORTANT: IT IS IMPORTANT TO MAKE SURE THAT
THE DRUM IS CAREFULLY CLOSED BEFORE
OPERATING THE MACHINE, OTHERWISE THE MACHINE
OR LAUNDRY COULD GET DAMAGED.
C
MAXIMUM
(wash)
2 min.
D
E
TH
F
O
NT G
O HIN E
FR AS HIN
W AC
M
C
IMPORTANT: A SPECIAL
SAFETY DEVICE PREVENTS
THE LID FROM BEING
OPENED
IMMEDIATELY
AFTER THE WASH HAS
FINISHED. ONCE THE SPIN
CYCLE HAS FINISHED, WAIT
FOR 2 MINUTES BEFORE
TRYING TO OPEN THE LID.
MAXIMUM
(prewash)
MAXIMUM
(bleach and scenting agent)
RECOMMENDED
D
49
50
PROGRAMME SELECTION
CONTROL DESCRIPTION
CTS 44
WHEN SELECTING A PROGRAMME, ENSURE THAT THE START/STOP BUTTON IS NOT
ACTIVATED.
To select a programme:
• Programmes are selected by means of the corresponding control knob (A). See the
table of programmes.
• Select the wash temperature by means of the corresponding control knob. (MOD.
CTS 45T)
• Select the different options available by pressing the corresponding buttons.
51
Programme selector knob ...........................................................
A
1/2 load button ............................................................................
D
Cold wash button ........................................................................
E
ON/OFF pilot light .......................................................................
G
ON/OFF button ...........................................................................
H
52
USE OF THE SELECTION CONTROLS
CTS 44
CONTROL DESCRIPTION
CTS 45 T
A. PROGRAMME SELECTOR KNOB
This control allows you to select the washing programmes.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button (H)
before selecting the programme.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
D. 1/2 LOAD BUTTON
Programme selector knob ...........................................................
A
The water load for a small wash may be reduced by pressing the ( ) load
button. This saves water, detergent and electricity. The amount of detergent
used should be reduced in proportion to the load.
Temperature selector knob .........................................................
B
Spin exclusion button ..................................................................
D
IMPORTANT: NEVER PRESS THE HALF LOAD BUTTON
WHEN
WASHING PURE NEW WOOL AND VERY DELICATE FABRICS.
1/2 load button ............................................................................
E
ON/OFF pilot light .......................................................................
G
ON/OFF button ...........................................................................
H
E. COLD WASH BUTTON
When pressed, your washing machine washes with cold water.
G.
H.
ON/OFF PILOT LIGHT
ON/OFF BUTTON
53
54
USE OF THE SELECTION CONTROLS
CTS 45 T
A. PROGRAMME SELECTOR KNOB
USE OF THE SELECTION CONTROLS
D. SPIN EXCLUSION BUTTON
This control allows you to select the washing programmes.
This button excludes the spin cycle from the wash programme. This option is
recommended for special fabrics.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button (H)
before selecting the programme.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
E. 1/2 LOAD BUTTON
The water load for a small wash may be reduced by pressing the ( ) load
button. This saves water, detergent and electricity. The amount of detergent
used should be reduced in proportion to the load.
IMPORTANT: NEVER PRESS THE HALF LOAD BUTTON
WHEN
WASHING PURE NEW WOOL AND VERY DELICATE FABRICS.
B. TEMPERATURE SELECTOR KNOB
This control allows you to select the temperature of your wash.
G.
H.
ON/OFF PILOT LIGHT
ON/OFF BUTTON
If you wish to carry out a cold wash, turn the knob until the
cold symbol
coincides with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
55
56
TABLE OF PROGRAMMES
PROGRAMME
TYPE OF
FABRIC
FAST WASH PROGRAMME
32-minute cycle
INTENSIVE HEAVILY SOILED
MAX.
LOAD
IN KG
PROG.
SEL.
2
32´
4,5
1
TEMP.
SEL.
ºC
Cold to
…50º
Cold to
PRODUCTS
I
II
•
•
•
•
•
•
•
…90º
4,5
NORMAL
2
Cold to
REMARKS
1. For highly soiled clothes, use a maximum load of 3 kg.
2. In programmes 5, 6, 7 and 8 the washing machine stops with water in the drum at the end
of the rinse cycle to prevent creasing.
To finish the cycle, select programme Z to drain the drum. Another option is to select
programme:
gentle spin.
Always turn the machine off with the ON/OFF button before selecting programme.
3. In programmes 1 and 2, add bleach in the appropriate compartment
for automatic
whitening.
4. This machine is designed to use fabric softener in the last rinse automatically in all washing
cycles.
…90º
4,5
FAST COLOUREDS
3
*
…60º
4
…40º
Cold to
Cold to
DELICATE COLOUREDS
3,5
BLEACH/WHITENER
Organic stains
—
—
VIGOROUS RINSE
—
—
VIGOROUS LAST RINSE
—
—
VIGOROUS SPIN
—
—
HEAVILY SOILED
2
5
Cold to
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
32-MINUTE FAST PROGRAMME
This programme runs through a complete washing cycle for up to 2 kg of
clothes at 50 ºC in just 32 minutes.
Pour washing powder/liquid into the pre-wash compartment (compartment
I).
The maximum amount of bleach which can be used is shown on the specific
indicator provided.
The 32-minute fast programme can also be used as a pre-wash cycle with
particularly heavily soiled clothes. Just select the desired main programme
afterwards.
…60º
2
COLOUREDS
6
Cold to
…50º
2
ACRYLICS
7
Cold to
…40º
Cold to
Programme
8
WOOL
1
GENTLE RINSE
—
—
GENTLE LAST RINSE
—
—
GENTLE SPIN
—
—
EMPTY
Drain off water
—
*, as per standard
Z
…40º
•
•
—
EN 60456.
The first programmes in each group are longer and therefore ensure a more efficient wash at the same
temperature. Select the later programmes for lightly soiled or particularly delicate clothes.
57
58
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertising