6 Route the 3.5 mm connector cable to the stereo and connect
®
Fusion MS-CBUSB3.5 Installation
Instructions
it to the AUX IN 1 or AUX IN 2 port.
Audio cables should be routed with at least 10 cm of
separation from other cables.
®
Specifications
Important Safety Information
Cable length
2 m (6.5 ft.)
Mounting hole diameter
29 mm (1 1/8 in.)
WARNING
Failure to follow these warnings and cautions could result in
personal injury, damage to the vessel, or poor product
performance.
See the Important Safety and Product Information guide in the
stereo box for product warnings and other important information.
This device must be installed according to these instructions.
Disconnect the vessel's power supply before beginning to install
this product.
Maximum mounting surface
thickness
15 mm (5/8 in.)
Operating temperature range
From 0° to 50°C (from 32° to
122°F)
Dimensions
CAUTION
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite
side of the surface.
You must read all installation instructions before beginning the
installation. If you experience difficulty during the installation,
contact Fusion Product Support.
Installing the USB and 3.5 mm Socket
Before installing the socket, make sure the cables will reach the
mounting location and the ports on the back of the device.
You must mount the socket in a location where there is at least
75 mm (2.95 in.) of clearance behind the mounting surface and
you can access the USB and 3.5 mm ports on the front after it is
mounted.
To allow for a proper seal, the mounting surface should be no
thicker than 15 mm ( 5/ 8 in.).
1 Remove the nut À from the socket and separate it from the
connected cable by pulling through one connector Á at a
time.
2
3
4
5
À
Á
Â
Ã
100 mm (3.94 in.)
48 mm (1.89 in.)
9 mm (0.35 in.)
75 mm (2.95 in.)
Do not remove the protective cover  from the socket.
Mark the mounting location of the socket and drill a 29 mm
(1 1/8 in.) hole through the mounting surface.
From the front of the mounting surface, feed the cables
through the hole by inserting one connector at a time, and
pull the cables through until the socket rests in the hole.
To ensure proper orientation, the USB socket à should be on
the top.
Place the nut over both the USB and 3.5 mm audio cables,
thread it along the cables to the USB and 3.5 mm socket, and
fasten the socket to the surface.
Route the USB cable to the stereo and connect it to the USB
port.
October 2015
Printed in China
190-01914-04_0A
© 2015 Garmin Ltd. or its subsidiaries
www.garmin.com/support
">
