Grizzly H7586 Resaw Fence Attachment Instruction Sheet

MODEL H7586
RESAW FENCE
FOR G0514
INSTRUCTION SHEET
Introduction
Installing the new fence requires replacing the
original fence with the new fence support tube on
the fence base, attaching the resaw fence, then
putting on the new fence scale.
Inventory
•
•
•
•
•
•
•
Resaw Fence.............................................. 1
Fence Support Tube................................... 1
Flat Washer 8mm........................................ 1
Moving Plate................................................ 1
Adjustment Handle...................................... 1
Scale........................................................... 1
Cap Screws M6-1 x 25................................ 4
Figure 1. Four cap screws to be removed for
changing fences.
Installing Fence Support Tube
1.
Remove the four cap screws (Figure 1) and
remove the fence from your original fence
base.
2.
Install the fence support tube on the fence
base with the spacer plate between the them,
as shown in Figure 2.
Spacer Plate
Between Fence
Support Tube and
Fence Base
Attaching Resaw Fence
1.
2.
Insert the adjustment handle with washer
through the hole in the fence and attach the
moving plate on the other side (Figure 3).
Figure 2. New fence support tube installed.
Slide the resaw fence over the moving plate,
center it with your original fence, and lock it
in position with the adjustment handle.
Installing Scale
1.
Raise the blade guides, and place the resaw
fence against the blade.
2.
Note where scale indicator line is over the old
scale, and pencil a mark on the rail next to
the scale.
3.
Remove the old scale and install the new
scale so the 0 is even with your pencil mark.
Moving Plate
Figure 3. Installing resaw fence.
H7586 Parts Breakdown and List
1
2
5
10
6
8
11
7
3
4
9
REF
PART #
DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
PH7586001
PH7528002
PW01M
PH7528004
PH7589007
PN01M
PH7587010
PCAP06M
PH7588021
PH7528005
PHTEK3M
RESAW FENCE (AL) 640mm
MOVING PLATE
FLAT WASHER 8MM
ADJUSTMENT KNOB M8 X 44
FENCE SUPPORT TUBE 640MM
HEX NUT M6-1
ADJUST SCREW
CAP SCREW M6-1 X 25
SCALE
END COVER 148 X 22 X 1
TAP SCREW M3.5 X 8
QTY
1
1
1
1
1
1
1
4
1
2
4
COPYRIGHT © JUNE, 2005 BY GRIZZLY INDUSTRIAL, INC. REVISED JANUARY, 2018 (HE)
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TR7288 PRINTED IN TAIWAN
For replacement parts, call 1-800-523-4777. For help, call Technical Support at 1-570-546-9663 or email
[email protected].