advertisement
◉
Touch to zoom
AK6E OUTSIDE AIR KIT For Wood Burning Fireplaces Installation Instructions The outside air vent is installed through a ventilated crawl space. Install outside air vent termination in a location that would not eventually be obstructed by bushes, snow or other obstructions. Vent must be located near fireplace to make flex duct installation easier. Flex duct supplied measures approximately 10" compressed and up to approximately 3 feet extended. 1. Locate air inlet cover plate on fireplace outer surround and remove. Cut out any visible insulation that may obstruct airflow. 2. Extend flex duct to attach air inlet tube. Insert inner tab of inlet tube into mating slot next to opening. Place outer tab of inlet tube over mating hole next to opening and secure with screws previously removed from cover plate in step 1. Insert Inner Tab on Inlet Tube into Slot on Outer Surround Fireplace Remove Knockout Left Side Mounting Shown Secure to Collar with Metal Tape, Screws or Tie Straps (Not Supplied) Tab in Notch Sheet Metal Screw Air Inlet Tube Flex Duct Extends Up to 3 Feet Floor Manufactured By: FMI PRODUCTS, LLC 2701 S. Harbor Blvd. Santa Ana, CA 92704 www.fmiproducts.com 54030 Rev. G 06/09
advertisement
Related manuals
advertisement