Legrand Clarity 5E TracJack, T568A/B, 180 degree, lt green, OR-TJ5E00-25 Instruction Sheet

 e 125 EUGENE O'NEILL DRIVE TITLE: CLARITY TRACJACK 8P8C 568A/B
Aa
4 dikes,
uz ORTRONICS 2205 | uma 71604107 REVISION: 03
FAX: 860—405—2990
DATE: 02/22/08 SIDE 1 of 2
CAUTION: TERMINATE TRACJACKS PER SPECIFIED
WIRING SYSTEM 'T568A' or ‘'T568B'. |
T568B E —E
T508A WIRING LABEL ON TOP & BOTTOM OF THE JACK
8P8C 8P8C
NOTE: When terminating cables to
TracJacks, lace wires from the center
to the outside of the module. Install
stuffer caps after terminating cable.
"a NOAA ‘This device is intended for indoor use
on communication loop circuit which
IN NI have been isolated from the Public
T568A T568A Switched Telephone Network”.
I NE N
Es
1 ES | AO ON
LL — L — WIRING CHART
TOP BOTTOM
RJ45 RJ45
COLOR CODE 8P8C | 8P8C
| LABEL T568A | T568B
© ORTRONICS WIRING | WIRING
P WHITE/BLUE 5 5
U — U BLUE/WHITE 4 4
N D) WHITÉ/ORANGE 3 1
© D ORANGE /WHITE 6 2
= Y WHE CEE 1 3
| GREEN/WHITE
S 2 WHITE/BROWN 7 7
"PUNCH BUDDY”, TracJack holder BROWN/ WHITE 8 8
REQUIRED TERMINATION TOOL RECOMMENDED supplied with full cartons of 1 8 1 8
OR-60300005 (TOOL & BLADE) STRIPPING TOOL
OR-60300006 (BLADE ONLY) OR-60300032 (TOOL) (Ses or under part # TJPBSPK Щ Щ
TracJack Module Termination
STEP 1: Feed station cables through faceplate. Mount faceplate to wall without modules installed.
STEP 2: Strip 2” of cable jacket off station cables.
STEP 3: Load TracJack as shown below, by sliding into groove as shown on Punch Buddy
until fully seated.
Do not load TracJack from the top. This may damage TracJack or Punch Buddy.
STEP 4: Lace color coded wire pairs into 110 termination.
STEP 5: Place Punch Buddy on solid flat surface. Using a single wire 110 tool,
terminate all 4 pairs. (see diagram below)
STEP 6: Repeat steps 3 thru 5 until all TracJack Modules are terminated.
STEP 7: Snap TracJack module into faceplate, or set TracJack module into base of surface
mount box.
(7 >
4 PORT 4 PAIR CABLE
FACEPLATE | = |
| Zi TracJack
E BEING
|| Г НЕ) TERMINATED
INSTALLED — — № - ==
TracJack
mm | mm
| (©) | PLACE PUNCH BUDDY SLIDE TRACJACK INTO PUNCH BUDDY
ON FLAT SURFACE WHEN LL mi — —— — — — —
TERMINATING 4 PAIR CABLE. SIDE 2 of 2
">