Simplicity 030215-1 Wiring Diagram

Wiring Diagram &
Schematic
SAFETY WARNINGS
HAZARD SYMBOLS AND MEANINGS
Physical contact with energized
electrical components will result
in dangerous and possibly fatal
electrical shock.
Explosion
Fire
Shock
Safety Alert Symbols
The safety alert symbol ( ) is used to
identify hazards that can result in personal
injury. A signal word (DANGER,
WARNING or CAUTION) is used with
the alert symbol to indicate the potential
severity of injury. In addition, a hazard
symbol may be used to represent the
type of hazard.
DANGER: Indicates a hazard
which, if not avoided will
result in death or serious
injury.
WARNING: Indicated a hazard
which, if not avoided could
result in death or serious
injury.
CAUTION: Indicates a hazard
which, if not avoided might
result in death or serious
injury.
CAUTION: When used without
the alert symbol, indicates a
situation that could result in
damage to equipment or
components.
DANGER
Do not touch bare wires or
receptacles.
WD-SCH-04
CAUTION
Entanglement
Disconnect
Spark Plug
WD-SCH-01
DANGER
Generators produce powerful
voltages. Failure to isolate
generator from power utility
can result in death or injury to
electric utility workers due to
backfeed of electrical energy.
When testing generators used for
backup power, notify utility company.
These wiring diagrams and
schematics are intended for
use by trained and qualified
electrical service technicians
who are working in a properly
equipped service environment.
Familiarity with the proper
method of using tools,
measuring equipment and
service procedures is
essential to performing
successful troubleshooting and
repair of this equipment.
Only qualified electrical technicians
should attempt to service this
equipment.
WD-SCH-02
WD-SCH-05
WARNING
CAUTION: The measuring
equipment used in troubleshooting
this equipment should be of industrial
quality and should have the sensitivity
to measure electronic values to the
third decimal. Its accuracy should
conform with acceptable industry
tolerances. Ensure that all specified
tools and/or equipment are available
before attempting to troubleshoot.
WD-SCH-03
Accidental starting of the unit
may cause entanglement or
electrocution.
Where applicable, disconnect the
negative (-) battery terminal.
Disconnect the spark plug wire.
Remove the control panel fuse
WD-SCH-07
when available.
Rev: 040705
5600 Watt Portable Generator
SCHEMATIC
1
5600 Watt Portable Generator
WIRING DIAGRAM
2