Pure Acoustics NRX-600 User's Manual

Installation instructions
Take the cardboard template that comes with the speakers and
place it where you want the speaker to be mounted.
Draw around the template and cutout the speaker mounting hole.
Run quality speaker wire (12-16 gauge) to that location.
Carefully pry off the grill from the speaker.
Connect the speaker wire to the speaker terminals and insert the
speaker into the hole.
There are screws around the perimeter of the face of the speaker
These screws connect to “ wings” in the rear of the speaker
which will swing out and clamp the speaker to the wall as they
are tightened.
Secure the speaker to the wall by tightening these screws until
the speaker is securely mounted.
That’s It ! Enjoy !